Tork SS721Z Manuel d'installation

FOR TECHNICAL SUPPORT: SOUTIEN TECHNIQUE : PARA COMUNICARSE CON EL SERVICIO TÉCNICO: [email protected] 877.230.7874 LI-835

A DIVISION OF NSi INDUSTRIES, LLC

PROGRAMMING INSTRUCTIONS

SS721Z

SS721ZA

CAUTION

Before wiring and servicing, power

to this time switch and the equipment

it controls must be turned off at the

main panel.

WARNING

Unit must be properly grounded to

operate correctly.

RATINGS

• 120/277VAC 16A 1920/4432W Resistive

• 120/277VAC 13A 1560/3600VA Ballast

• 120VAC 8A 960W Tungsten

• 120VAC 1 HP

SS721Z SMART TIMER

INSTALLATION

1. Connect black and blue wires as shown in the diagram.

Cap the red wire.

2. Connect the mounting strap green wire and timer green

wire to the ground wire.

3. Mount the timer inside electrical box using 2 mounting

screws provided.

4. Install cover plate.

5. Turn power on at the electrical panel.

RETROFITTING A SS721Z

TO EXISTING 3-WAY SWITCH

1. Disconnect the second 3-way switch.

2. Connect the timer blue wire to the load. Connect the timer

black wire to “Traveler A” and the timer red wire to

“Traveler B”.

3. Connect the mounting strap green wire and timer green

wire to the ground wire.

4. Mount the timer inside electrical box using 2 mounting

screws provided.

5. At switch #1 connect a wire between the hot leg of the

3-way and “Traveler A” inside of that switch’s gang-box.

6. Install cover plates.

7. Turn power on at the electrical panel.

1.0 Press MODE to go to the CLK mode.

2.0 TO SET CLOCK

3.0 TO SET DATE

4.0 TO SET AUTOMATIC DAYLIGHT

SAVING TIME ADJUSTMENT

5.0 DAYLIGHT SAVINGS MODE CONFIRMATION

6.0 SCHEDULE SET MODE

a) For automatic sunset ON/sunrise OFF press MODE and go to step 7

b) For sunset ON & time OFF, press ENTER and go to step 6.2 to set OFF time

then go to step 7.

c) To set an ON/OFF time go to step 6.1

6.1 SETTING AN ON TIME

6.2 SETTING AN OFF TIME

6.3 NEXT SCHEDULE

Repeat steps 6.1 & 6.2 for additional ON/OFF pairs OR

MODE

HOUR MIN ENTER

ENTER OR

To skip

ENTER

DAY

MAINE

MASS

NEW YORK

PENNSYLVANIA

OHIO

IND

ILLINOIS

KENTUCKY VIRGINIA

NORTH CAROLINATENNESSEE

WEST

VIRGINIA

SOUTH

CAROLINA

GEORGIAALABAMA

MISS

FLORIDA

LOUISIANA

ARKANSAS

OKLAHOMA

MISSOURI

TEXAS

KANSAS

NEW MEXICO

MEXICO

ARIZONA

CALIFORNIA

NEVADA UTAH COLORADO

NEBRASKA

WYOMING

IDAHO

OREGON

SOUTH DAKOTA

IOWA

WISCONSIN

MICHIGAN

MINN

NORTH DAKOTA

MONTANA

WASHINGTON

RHODE ISLAND

CONNECTICUT

NEW JERSEY

MARYLAND

DELAWARE

45°

50°

60° ALASKA

40°

35°

30°

25°

ASTRONOMIC LATITUDE ZONES

ZONES DE LATITUDE

ZONAS ASTRONOMICAS (LATITUDES)

21° HA W AII 18° PUERTO

RICO

MODE

ENTER

To skip LAT

HOUR MIN ENTER

DAY

HOUR MIN ENTER

DAY

INSTALLATION INSTRUCTIONS

SS721Z

SS721ZA

PLEASE READ ALL INSTRUCTIONS FIRST

When rst powered-up or after pressing reset button the unit will display the word “HOLd” and a 30 second

countdown will begin. The display will then ash “SS700” and show “12:00am.” The unit is ready for programming.

FOR TECHNICAL SUPPORT: SOUTIEN TECHNIQUE : PARA COMUNICARSE CON EL SERVICIO TÉCNICO: [email protected] 877.230.7874 LI-835

A DIVISION OF NSi INDUSTRIES, LLC

HOUR MIN ENTER

ENTER

YEAR

DATE

MONTH

MODE

7.0 TO SET AUTOMATIC DAILY

SUNSET/SUNRISE (ASTRO) SCHEDULE

See map below. Find desired degree of latitude from 10° to 60° north.

Use LAT key to advance. If the screen reads LAtS it is for south hemisphere.

Advance to N.

7.1 SET SUNSET ON

Press DAY to show today’s sunset time.

7.2 OPTIONAL OFFSET

Turn load ON before or after calculated sunset

7.3 SET SUNRISE OFF

Press DAY to show today’s sunrise time.

ENTER

DAY

7.4 OPTIONAL OFFSET

Turn load OFF before or after calculated sunrise

8.0 AUTO (AUTOMATIC) MODE

9.0 MAN (MANUAL) MODE

HOUR MIN ENTER

ENTER

To skip

Pour passer

Para ignorar

NOTE: Press HOUR to move from after sunrise (“AF”) to before sunrise (“bF”)

MODE

NOTE: AUTO mode will follow the programmed schedule. OVERRIDE sets

ON/OFF until the next event.

NOTE: Press RND to put unit in optional random mode. ON events will be

delayed up to 30 minutes and the OFF events will be delayed up to 45 minutes.

NOTE: MAN mode will bypass programmed schedule. OVERRIDE set ON/OFF

until next OVERRIDE push

NOTE: Press RESET to clear time and date. To clear all press ENTER, press

DEL, then ENTER again.

MODE

To skip

ENTER ENTER ENTER ENTER

OR MODE

MODE

Ce manuel convient aux modèles suivants

Manuels Minuteur populaires d'autres marques

Intermatic

Intermatic P1131 Manuel utilisateur

Learning Resources

Learning Resources Time Tracker mini Manuel utilisateur

CEBEK

CEBEK I-215 Manuel utilisateur

Somogyi

Somogyi home TS MD 5 Manuel utilisateur

Profile

Profile 010200280 Manuel utilisateur

Gizmo

Gizmo T4 Manuel utilisateur

Tekmar

Tekmar Timer 031 Manuel utilisateur

Daikin

Daikin DST301B61 Manuel utilisateur

sisel

sisel ENDA ETM2432 Manuel utilisateur

B&Q

B&Q TE103 Manuel d'utilisation et d'entretien

Hozelock

Hozelock AC Plus 2700 Manuel utilisateur

GIC

GIC Eliro V7DDSS3Eliro V7DFTS3 Manuel utilisateur

Emos

Emos EMT400F Manuel utilisateur

FarmTek

FarmTek Polaris Manuel utilisateur

Maximum

Maximum CRONUS Manuel utilisateur

Uberhaus

Uberhaus TD133B Manuel utilisateur

Clas Ohlson

Clas Ohlson 31-3766 Manuel utilisateur

Gewiss

Gewiss 90 AM Series Manuel utilisateur