TomTom ONE XL HDT Manuel utilisateur

TomTom ONE XL HDT

What’s in the box1.

What’s in the box

aYour TomTom ONE XL HDT

ACharging light

BTouchscreen

COn/off button

DSpeaker

EExternal antenna connector

FUSB connector

GMemory card slot (SD card not

included) for optional additional

maps

HReset button

bCar charger cDocumentation

pack

dWindscreen

holder eUSB cable

ACB

Before you start...2.

Before you start...

Safety Notice

Your TomTom ONE XL HDT contains a GSM module which can interfere with

electrical devices such as cardiac pacemakers, hearing aids and aviation

equipment.

Interference with these devices may endanger the health or life of others.

Do not use near unprotected electrical units nor in areas where the use of

mobile telephones is prohibited, such as hospitals and airplanes.

Switching on and off

To switch your TomTom ONE XL HDT on or off, press and hold the On/Off

button for 2 seconds. The first time you switch on, it may take a short while for

your device to start.

Note: In rare cases, your ONE XL HDT may not start correctly. If this happens,

press the reset button, then switch on the device again.

Setting up

To set up your TomTom ONE XL HDT you need to answer a few questions by

tapping the screen.

Important: Take care to select the correct language, since the language you

choose will be used for all menus and written instructions.

Battery notes

We recommend that you fully charge your TomTom ONE XL HDT the first time

that you use it. To do this, you need to connect the device to your computer

using the USB cable and then turn on your computer. It takes up to 2 hours to

charge the battery completely.

For information on connecting your computer, see Using TomTom HOME

(53).

Note: Your TomTom ONE XL HDT uses a small amount of battery power to

remember the last screen being shown when the device is switched off.

If you do not charge your ONE XL HDT for a prolonged period of time, the next

time you start your ONE XL HDT it will show the default starting screen. All

other device settings will still be maintained.

Improving reception

If your TomTom ONE XL HDT takes longer than 5 minutes to find your current

position, make sure that the device is in an open space away from tall objects,

such as buildings or trees.

Important: Some vehicles have heat reflective shielding in the windscreen.

This may prevent your ONE XL HDT from locating your current position.

The TomTom External Antenna Kit (available for purchase as an accessory)

can help to improve reception.

Windscreen holder

Use the windscreen holder to install your TomTom ONE XL HDT inside your

car.

To attach the holder, press the suction cup firmly to the windscreen in your

car, in an area of the windscreen where the glass is flat.

Make sure that both the holder and your windscreen are clean and dry before

you attach the holder. Place the holder so that it does not interfere with your

view of the road.

Take care of your TomTom ONE XL HDT

Never leave your TomTom ONE XL HDT or accessories on view when you

leave the car or they may become an easy target for thieves.

You can set a password for your TomTom ONE XL HDT which must be

entered every time you start your ONE XL HDT. For more information, see

Using TomTom HOME (53).

It is important to take care of your ONE XL HDT.

• Your ONE XL HDT is not designed for use in extreme temperatures and any

such exposure may cause permanent damage.

• Do not open the casing of your ONE XL HDT under any circumstances.

Doing so may be dangerous and will invalidate the warranty.

• Wipe or dry the screen of your ONE XL HDT using a soft cloth. Do not use

any liquid cleaners.

Driving View3.

Driving View When your TomTom ONE XL HDT starts, you are shown the Driving View

along with detailed information about your current location.

Tap the centre of the screen at any time to open the Main Menu.

Note: The Driving View is shown in black and white until your ONE XL HDT

locates your current position.

ATap + and - to zoom in and out.

BYour current position.

CThe name of the next major road or road sign information, if applicable.

DNavigation instruction for the road ahead.

Tap this area to repeat the last spoken instruction and to change the

volume.

EThe name of the next street to turn onto.

FThe name of the street you are on.

GInformation about your journey such as journey time, remaining distance

and arrival time.

To select what will be shown, tap Status bar preferences in the Preferences

menu.

HGPS signal strength.

IHD Traffic sidebar.

Making your first journey4.

Making your first journey Planning a route with your TomTom ONE XL HDT is easy. To plan your first

route, follow the steps below.

Important: You should always plan your journey before you start driving. It is

dangerous to plan a route while driving.

1. Tap the screen to bring up the Main Menu.

Note: The buttons on your ONE XL HDT are shown in full colour unless a

button is currently unavailable. For example, the button named Find

alternative... in the Main Menu is not available until you have planned a route.

2. Tap Navigate to...

3. Tap Address.

When you enter an address, you can choose from the following options:

•City centre - tap this button to set your destination as the centre of a city

or town.

•Street and house number - tap this button to set an exact address as your

destination.

•Postcode - tap this button to enter a postcode as your destination.

Note: You can enter a postcode for any country. In the UK and the

Netherlands, postcodes are detailed enough to identify a house on their own.

In other countries you can enter a postcode to identify a town or area. You will

then have to enter a street and house number.

•Crossing or intersection - tap this button to set your destination as the

point where two streets meet.

For your first journey, we will enter an exact address.

4. Tap Street and house number.

Note: When planning a trip for the first time your ONE XL HDT asks you to

choose a country. Your choice is saved and used for all routes you plan.

You can change this setting at any time by tapping the country flag.

5. Start to type the name of the town where you want to go.

As you type, the names of the towns that match what you have typed are

shown. When your destination appears in the list, tap the name of the town

to set the destination.

6. Start to type the name of the street and select it when it is shown.

As with the name of the town, the names of the streets that match what you

have typed are shown. When your destination appears in the list, tap the

name of the street to set the destination.

7. Now enter the house number of your destination and then tap Done.

8. Your ONE XL HDT asks if you need to arrive at a particular time. For this

exercise, tap NO.

The route is calculated by your ONE XL HDT.

9. When the route has been calculated, tap Done.

Your ONE XL HDT will warn you about any traffic delays and immediately

begin to guide you to your destination, using both spoken instructions and on-

screen directions.

Arrival times

When you plan a route, your TomTom ONE XL HDT asks you if you need to

arrive at a particular time.

Tap YES to enter a preferred arrival time.

Your ONE XL HDT calculates your arrival time and shows you whether you will

arrive on time.

You can also use this information to work out when you need to leave. If your

ONE XL HDT shows that you will arrive 30 minutes early, you can wait and

leave in 30 minutes time, rather than arrive early.

Your arrival time is constantly recalculated during your journey. The status bar

shows whether you will arrive on time or if you are going to be late, as shown

below:

You will arrive 55 minutes before the arrival time you entered.

If the estimated arrival time is more than five minutes before

the time you entered, it is shown in green.

You will arrive 3 minutes before the arrival time you entered.

If the estimated arrival time is less than 5 minutes before the

time you entered, it is shown in yellow.

You will arrive 19 minutes late.

If the estimated arrival time is later than the time you entered,

it is shown in red.

Status bar

preferences

Tap Status bar preferences in the Preferences menu, to enable or disable

arrival time notifications.

Select the required options on the first menu screen and then tap Done.

To enable arrival time notifications, select Show leeway to arrival time.

To disable arrival time notifications, unselect Show leeway to arrival time.

What are the other navigation options?

When you tap Navigate to..., you can set your destination in many ways, not

just by entering the address. The other options are listed below:

Home

Tap this button to navigate to your Home location.

You will probably use this button more than any other.

For information about setting your Home location, see Change Home

location (45).

Favourite

Tap this button to select a Favourite as your destination.

For more information about Favourites, see Favourites (23).

Address

Tap this button to enter an address as your destination.

Recent

destination

Tap this button to select your destination from a list of places you have

recently used as destinations.

Point of

Interest

Tap this button to navigate to a Point of Interest (POI).

For more information about POIs and navigating to a POI, see Points of

Interest (28).

GPS position

Tap this button to select your GPS position, as your destination.

For more information about GPS, see Global Positioning System (GPS)

(54).

Point on map

Tap this button to select a point on the map as your destination using the

map browser.

For more information about the map browser, see Driving View (5).

Latitude

Longitude

Tap this button to enter a destination using latitude and longitude values.

Position of

last stop

Tap this button to select your last recorded position, as your destination.

For more information about the GPS, see Global Positioning System (GPS)

(54).

Planning a route in advance

You can also use your ONE XL HDT to plan journeys in advance by selecting

both your starting point and your destination. You could, for example, do the

following:

• Find out how long a journey is going to take before you start.

• Check the route of a journey you are planning.

• Check a route for someone who is coming to visit you, so that you can

explain the route to them.

To plan a route in advance, follow these steps:

1. Tap the screen to bring up the main menu.

2. Tap the arrow button to move to the next menu screen and tap Prepare

route.

3. Select the starting point for your journey in the same way that you would

select your destination.

4. Set the destination for your journey.

5. Choose the type of route that should be planned.

•Fastest route - the route which takes the least time.

•Shortest route - the shortest distance between the locations you set. This

may not be the quickest route, especially if the shortest route is through

a town or city.

•Avoid motorways - a route which avoids motorways.

•Walking route - a route designed for making the journey on foot.

•Bicycle route - a route designed for making the journey on a bicycle.

•Limited speed - a route for a vehicle which can only be driven at a limited

speed. You have to specify the maximum speed.

6. Your TomTom ONE XL HDT plans the route between the two locations you

selected.

More information about a route

You can access these options for the route you last planned, by tapping View

route in the Main Menu.

To find out about your route in detail, tap the Details button on the route

summary screen.

You can then select from the following options:

Prepare route

Browse as

text

Tap this button for a list of all the turn instructions on the route.

This is very useful if you need to explain a route to someone else.

Table des matières

Autres manuels TomTom GPS

TomTom

TomTom Go Via Manuel utilisateur

TomTom

TomTom Go 920 Manuel utilisateur

TomTom

TomTom LINK 3000 Manuel utilisateur

TomTom

TomTom GPS Receiver Manuel utilisateur

TomTom

TomTom GO 740 LIVE Manuel utilisateur

TomTom

TomTom GO Manuel utilisateur

TomTom

TomTom XL 340 Manuel utilisateur

TomTom

TomTom Car Navigation System ONE Manuel utilisateur

TomTom

TomTom Traffic Receiver Manuel utilisateur

TomTom

TomTom NAVIGATOR Manuel utilisateur

TomTom

TomTom GO Manuel utilisateur

TomTom

TomTom GO 740 LIVE Manuel utilisateur

TomTom

TomTom LINK 300 Manuel utilisateur

TomTom

TomTom ONE Manuel utilisateur

TomTom

TomTom NAVIGATION SYSTEM Manuel utilisateur

TomTom

TomTom Navigator Navigator 3 Manuel utilisateur

TomTom

TomTom RDS-TMC Manuel utilisateur

TomTom

TomTom TNS400 Manuel utilisateur

TomTom

TomTom GO Manuel utilisateur

TomTom

TomTom Navigator SDK and Manuel d'utilisation

TomTom

TomTom PRO Manuel utilisateur

TomTom

TomTom ONE Manuel utilisateur

TomTom

TomTom ONE Manuel utilisateur

TomTom

TomTom Hands-Free Car Kit Manuel utilisateur

Manuels GPS populaires d'autres marques

Raven

Raven Cruizer II Manuel

Hama

Hama 53118 Manuel utilisateur

Garmin

Garmin SOUNDER 125 Manuel utilisateur

Garmin

Garmin DEZL 580 Manuel utilisateur

Jigabot

Jigabot EX Manuel utilisateur

Pointer

Pointer Cellocator CelloTrack XT LTE Guide d'installation

Queclink

Queclink GV55LITE Manuel utilisateur

Voxson

Voxson Voxtrack GPS500 Manuel d'instructions

Garmin

Garmin ECHOMAP PLUS Manuel utilisateur

Starcom Systems

Starcom Systems Kylos Compact Manuel utilisateur

Garmin

Garmin 15 H Series Manuel utilisateur

Cobra

Cobra Marine MC 600Ci Manuel utilisateur

Cellocator

Cellocator CelloTrack T Manuel utilisateur

Enfora

Enfora Mini-MT GSM2228UG001 Manuel utilisateur

Magellan

Magellan eXplorist 100 Manuel utilisateur

LTE

LTE G50B Manuel utilisateur

Garmin

Garmin DEZL OTR500 Manuel utilisateur

SkyGolf

SkyGolf SkyCaddie SG1 Manuel utilisateur