Thuraya seastar Manuel utilisateur
Thuraya SeaStar
SYSTEM USER GUIDE
Thuraya SeaStar
2
REGULATORY INFORMATION 3
1. INTRODUCTION 6
2. GETTING STARTED 16
3. USING THE SeaStar 19
TABLE OF CONTENTS
......................................... ...........................
........................................................................
How to make call .................................
SMS .................................
.................................
GEO fencing & Tracking
Black & White List
GmPRS
Firmware Upgrade
................ ........................
...............................
..............................
............
23
33
41
47
60
63
Safety Summary
REGULATORY INFORMATION
EC Declaraon of Conformity
Westone Communicaons co. ltd, be seated on YunHua Road No.333, Chengdu,
Sichuan Province, China declares under our sole responsibility that the Product,
brand name as Thuraya SeaStar and model: Is a voice/SMS/GmPRS Satellite
terminal with a built in GPS tracking system, to which this declaraon relates, is in
conformity with the following standards and/or other normave documents:
IEC 60945/ EN 60945 edion 2008
For the sake of safety and protecon, please read the user guide before you
aempt to use the Thuraya SeaStar system. In parcular, read this safety secon
carefully. Keep this safety informaon where you can refer to it if necessary.
Westone Communicaons co. ltd, assumes no liability for the customer's failure to
comply with these requirements.
The following general safety precauons must be observed during all phases of
operaon, service and repair of this equipment. Failure to comply with these
precauons or with specific warnings elsewhere in this user guide violates safety
standards of design, manufacture and intended use of the equipment.
WARNING
During transmission, the antenna in the system radiates high power levels of radio
frequency. This radiaon is considered health hazardous to any personnel that
comes very close to the antenna.
Antenna Radiaon Warning
It is important to maintain a separaon distance from the transming antenna to
any personnel of at least 30cm.
Service
User access to the interior of the terminal is not allowed. Only qualified personnel
authorized by its manufacturer may perform service. Failure to comply with this
rule will result in the warranty being void.
Grounding and Antenna Cables
The terminal has a grounding stud to ground the terminal to the hull of the ship by
using a ground cable.
The antenna cables are shielded and they should not be affected by any magnec
field. It is recommended to avoid the cables being installed in parallel with any AC
wiring as it may possibly cause malfuncon of the equipment.
Ship's Power Supply
The Thuraya SeaStar (including to the Terminal and the Acve Antenna) standby
power is only less than 10W, and the standard operaon average power
consumpon is only 16W. When low signal strength, burst power may beyond
20W. For the steady operaon, the input voltage for SeaStar System needs a 36W
power supply (may be 12V DC@3A or 24V [email protected]). It is recommended to use a
24V DC power line, if available on the ship.
In case of unavailability of a 12V or 24V DC power line on the ship, on external
AC/DC power supply (110/220V AC to 24V DC @ Min 1.5A) can be used, please
3 4
This equipment shall not operate when mains power is lost.
contact the vendor when you need it.
To ensure adequate cooling of the terminal, 5cm of unobstructed space must be
maintained around all sides of the unit except the boom side. The ambient
temperature range of the below decks terminal is: -15°C to +55°C.
Equipment Venlaon
The equipment should not be operated in the presence of flammable gases or
fumes as well as any explosive atmosphere. Operaon of any electrical equipment
in such an environment constutes a safety hazard.
Obtaining Licensing for Thuraya SeaStar System
Under rights given under ITU Radio Regulaons, local telecommunicaons
administraons establish and enforce naonal rules and regulaons governing
types of emissions, power levels, and other parameters that affect the purity of
signal, which may be radiated in the various frequency bands of the radio spectrum.
To legally operate the Thuraya SeaStar system, it is necessary to obtain permission
from the local telecommunicaons regulatory authories of the country you are
operang from. Using your equipment in any country without permission causes
you to run the risk of confiscaon of the equipment by the local authories. The
normal procedure to bring such equipment into another country is to apply for a
license before travel. If a license has not been obtained before travel, the
equipment may be put in to storage by local authories unl such me license is
obtained.
Informaon in this document is subject to change without noce and does not
represent a commitment on the part of Westone Communicaons co. ltd.
Copyright
© 2016 Westone Communicaons co. ltd. All rights reserved.
1. INTRODUCTION
The Thuraya SeaStar is a voice satellite terminal with a built-in GPS tracking system
specially designed for reliable performance in the harsh marime environment.
This affordable, easy-to-install and user-friendly terminal enables users to make
satellite voice calls to normal PSTN phones, mobile phones and other satellite
phones through the Thuraya satellite network.
The SeaStar supports SMS services through its easy-to-use menu on the large color
LCD screen on the terminal. An Alert buon is available to nofy pre-configured
contacts during an emergency. When the Alert buon is acvated, the SeaStar will
send a pre-determined SOS message which includes the me-stamped GPS
coordinates of the posion to a maximum of five preset contacts for emergency
response. The terminal has a RJ11 socket for connecng to an analogue phone or
PBX. A RJ45 socket is available to provide GmPRS data via LAN cable to a laptop or
PC to give access to the internet.
Features
Base Terminal
Supports basic telephony funcons, Calling Line Idenficaon Presentaon (CLIP)
and Short Message Services (SMS), network funcon and link to circuit switch
phone or PBX funcon.
Phone book retrieval from the terminal, storage 3000 contacts max.
Call log: last missed, received and dialed calls each with date and me stamps,
storage 100 call log max.
Menu-driven graphical user interface with 65K colors, 320 x 240 pixels, 2.4 inch
TFT LCD screen
MMI Language in English.
5 6
RJ11 port for analogue phone connecon
RJ45 port for GmPRS LAN connecon
Geo-fencing. Up to 5 areas (circular or rectangular) can be configured. Sends an
SMS alert when the vessel enters or leaves an area
Polling for an on demand posion report base on GPS Tracking
Automac Posion Reports (APR)
Configuraon to support
3.5mm port is use for output the ring or voice in calling
External loudspeaker plays incoming ring and SMS noficaon ring
External Alert buon input port
Back-lit keypad
Desk and wall mounng
Alert buon for triggering an emergency alert to pre-configured contacts via SMS
Antenna Unit
Acve Antenna
Omni-direconal acve Thuraya satellite antenna with build-in acve GPS
antenna
Up to 75 meters of LMR400 (or equivalent) co-axial satellite antenna cable
Standard cable 25m for longer cable contact supplier
Recommended Cable lengths for Acve antenna
SAT & GPS Cables
Cable Type [email protected]
(dB/m)
MaxCable
Length (m)
Recommenda
tion Cable
Length(m)
Min Cable
Length (m)
LMR400 0.174 75 67 52
LMR240 0.335 40 36 28
LMR195 0.493 28 25 20
Operang Environment
Antenna Unit (ADU)
Operang Temperature -25°C to +55°C
Storage Temperature -40°C to +80°C
Base Terminal (BDU)
Operang Temperature -15°C to +55°C
Storage Temperature -20°C to +70°C
7 8
Mechanical specificaons
System
Power Supply 10.8 to 31.2V
Standby / Working Average Power
Consumpon
Operang Humidity Up to 95% (non-condensing) at 40°C
10W / 16W
General specificaons
Thuraya Approved
Compliant to CE, RoHS, WEEE, REACH, IEC60945
Service
Voice
SMS Up to 140 Characters
GmPRS 40Kbps / 15Kbps (Download / Upload)
Ingress Protecon Rang Base Terminal (BDU) IP 32
Antenna (ADU) IP 66
GPS specificaons
Number of Tracking Channels 20
GPS Posion Accuracy <10m
Time to First Fix Hot start < 1 seconds
Warm start < 30 seconds
Cold start < 35 seconds
Size
Base Terminal (L x W x H) 210×205×85mm
Acve Antenna (D x H) 164×170mm
SAT Cable 25m
GPS Cable 25m
Weight
Base Terminal 1.2kg
Acve Antenna 1.1kg
Antenna Mounng Kit 0.5kg
SAT Feeder Line 0.67kg @ 25m
GPS Feeder Line 0.65kg @ 25m
Packing list
Base Terminal
9 10
Base Terminal
Acve Antenna
Antenna Mounng Kit
GPS RF Cable (25 meters with
N-type Male connectors)
SAT RF Cable (25 meters with
TNC Male connectors)
Power Cable
USB OTG Cable (For upgrading the
SeaStar’s firmware)
Port introduce
Alert Buon: For emergency usage. To nofy pre-configured contacts during
an emergency. Press and hold the RED key for 2 seconds to
trigger the alert
SIM Card Slot: To insert Thuraya SIM Card
Mini USB Port: It is for Terminal maintenance and Firmware upgrade. For more
informaon, please contact your distributor
Reset Port: To restart the Terminal
RJ-9 Port: Link to the handset line
Alert Buon
Reset Port
RJ-9 Slot
SIM Card Slot Micro USB Port
11 12
Serial Port
RJ-45 Port Power ON/OFF
Serial Port: This is a 3 wires (TX, RX and ground) RS232 port. It is for
communicaon module maintenance and Firmware upgrade.
For more informaon, please contact your distributor
RJ-45 Port: This is a port which a computer could use GmPRS to surf the
Internet by a single network cable
Power ON/OFF: This is the system power On/Off switch.
3.5mm Port: This is the system voice port, which could connect a loud
speaker to play the calling voice
3.5mm Port
RJ-11 Port RJ-9 Port
RJ-11 Port: This is the port which can be connected to a common switched
circuit voice phone to extend the satellite phone funcon
RJ-9 Port: Link to the handset line
DC Input: Power input connector is used for connecng the external power
source (10.8 - 31.2V) to the Base Terminal and acve antenna.
SAT Port: SAT ANT port is used for the physical connecon - via an RF cable
between the satellite acve Antenna unit and the Base Terminal.
DC Input
SAT Port GPS Port Grounding Stud
GPS Port: GPS ANT port is used for the physical connecon between the
GPS antenna and the Base Terminal.
Grounding Stud: To ground the terminal with a grounding cable.
Antenna Unit
13 14
The Antenna unit has two RF (female) connectors at its base. One connector is the
SAT signal port (N-type connector), and the other is the GPS signal port (TNC
connector).
SAT RF Cable: The SAT RF cable is 25 meters in length and is terminated with
an N-type (male) connector at each end
GPS RF Cable: The GPS RF cable is 25 meters in length and is terminated with
a TNC (male) connector at each end
Mounng Port: Install the stainless steel stand to fix the Antenna
Mounng Port
SAT signal Port
GPS signal Port
2. GETTING STARTED
Before proceeding, please refer to “SeaStar Installaon Guide” and install the
Thuraya SeaStar system and connect all the cables according
The Thuraya SeaStar system requires a valid SIM card to access the satellite
network and configure the sengs of the Base Terminal
Follow these steps to install the SIM card:
Installing the SIM card
1. Flip down the SIM card cover
2. With the SIM card's gold contact facing down, posion the card as indicated
and slide it into the slot
3. Ensure that the SIM card is correctly located
4. Close the SIM card cover
Power Up the SeaStar
Follow these steps to power up the SeaStar
Tip the Power On/Off Switch to the le
Tip it to the le
15 16
The Modem is inializing ( status indicator should be on) this shall be
replaced by the modem is inialized ( status indicator) and then The
Terminal is registered for CS (Voice) service ( status indicator) this shall
then be replaced by signal strength indicator shown below.
Making the first voice call
Note:
Before making a voice call, please make sure that:
Signal strength could be usable (
status indicator should be on)
The Thuraya SIM card isn’t inside ( status indicator should be on)
17 18
Note:
If the security code open and user change another card or do not insert SIM
card, SeaStar will turn into the protected mode and display the figure below.
When this is displayed, that means no SIM card insert or the wrong SIM card
has been inserted, please restore the original SIM card and restart SeaStar to
go out of the protected mode.
Handset locking mechanism:
When placed on hook, the handset is locked onto the cradle. When going
off-hook (picking up the handset from the cradle), please make sure to push
the handset forward before liing it off the cradle
When you are replacing the handset, make sure it is locked onto the cradle
Autres manuels pour seastar
3
Table des matières
Autres manuels Thuraya Terminal tactile
Manuels Terminal tactile populaires d'autres marques
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Manuel utilisateur
Ingenico
Ingenico AXIUM EX4000 Manuel utilisateur
Heisei Electronics
Heisei Electronics Q-POS 815 Manuel utilisateur
Amano
Amano MTX-15 Manuel utilisateur
FLOWBIRD
FLOWBIRD CWT Compact Touch Manuel utilisateur
Demco
Demco SP7 Manuel utilisateur
