— 10 —
UNPACKING
NOTE: All Thermodyne cabinets are factory tested
for performance and certied free from
defects.
Thermodyne Damaged Goods Policy
There are two types of damaged merchandise:
A.Visible Damage and B. Concealed Damage.
A. Visible Damage: The product being received
is visibly damaged.
1. The receiver should refuse the damaged
merchandise.
2. Receiver should sign the bill of lading indicating
which merchandise is being refused due to
damage.
3. Contact Thermodyne Customer Service
Representatives immediately.
B. Concealed Damage: Damaged merchandise
cannot be externally detected.
Your receiving operation should inspect for this type
of damage. Please inspect your delivery carefully.
If the product is damaged:
1. Save all packing material.
2. Contact Thermodyne Customer Service
Representatives immediately.
3. Receiver must call the carrier to schedule an
inspection of the damaged merchandise within
5 business days.
INSTALLATION CODES
AND STANDARDS
In the United States, the Thermodyne cabinet
must be installed in accordance with:
1. State and local codes.
2. National Electrical Code (ANSI/NFPA No. 70,
latest edition) available from the National Fire
Protection Association, Batterymarch Park,
Quincy, MA 02269.
In Canada, the cabinet must be installed in
accordance with:
1. Local codes.
2. Canadian Electrical Code (CSA C22.2 No. 3,
latest edition) available from the Canadian
Standards Association, 5060 Spectrum Way,
Mississauga, Ontario, Canada L4W 5N6.
INSTALLATION
Before installing, verify the required electrical
supply agrees with the specications on the data
plate located on the back or side of the unit. If
the supply and equipment requirements do not
agree, do not proceed with installation. Contact
your dealer or Thermodyne Foodservice Products,
Inc. immediately.
CAUTION
Models 200CT, 300CT, 550CT and 700CT
have glass doors. Remove carton carefully.
CAUTION
Packaging may have sharp edges and
banding; leather work gloves and safety
glasses are recommended for safe
unpacking.
1. Allow ample overhead clearance for removal
of carton.
2. Cut banding (2 pieces) and remove nails (not
for all units).
3. To remove cabinet from carton, slide carton
up and o the cabinet.
4. Check packing list against items received:
A. Thermodyne Heat Transfer Fluid.
B. Installation & Operation Manual
5. Use proper lifting equipment to raise the
cabinet.
6. Remove the plastic covering from glass door
frames and hinges. Mount doors on cabinet,
then check doors for alignment (on certain
models).
7. Set cabinet on a level surface.
