Seite 6 / 8
5) Internal Power Supply TTT-S
The TTT-S is fitted with a high-power-battery-pack. The turntable is driven by the internal
power supply only. The external charger is to be used for charging the battery only.
Please refer to the table on the right.
Important notes:
-A fully charged battery-pack will keep the turntable running in playback mode
for at least 20 hours.
-If the unit is kept in the standby-mode (On), a small control-current is needed.
Therefore, the battery will be discharged after 200 hours, even if the platter is
not turning.
-We are using most modern LiMn batteries. These accumulators do have no
memory-effect. This means, you are free to charge them no matter what the ac-
tual charge state is. The battery can be recharged for at least 1’000 cycles.
-The battery-pack can provide power up to 100 Watts. This energy is set free by
incorrect handling of the accumulator as well. Therefore, the battery needs to be
exchanged by your distributor / dealer only.
-Depending on the charge state, the external charger can produce emissions
(electrical field, noise). Therefore we recommend to unplug it completely from
the power-plant and turntable while playing music.
Charge: If the external charger is connected,
the battery will be charged. The charge state
is shown on the external charger.
Off: The unit is disconnected completely
from the internal and external power-
supply. The battery keeps its charge state
for many months.
On: The device is switched on, the external
power supply is disconnected electrically
from the circuit.
The green LED shows good condition of the
batteries. If the red LED starts glowing, the
accumulators shall be charged within one to
two hours.
