Texas Instruments TUSB3200EVM2 Manuel utilisateur

6ĆChannel TUSB3200EVM2

for the TUSB3200A USB

Streaming Data Controller

January 2003 Digital Audio

User’s Guide

SLAU062A

IMPORTANT NOTICE

Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications,

enhancements, improvements, and other changes to its products and services at any time and to discontinue

any product or service without notice. Customers should obtain the latest relevant information before placing

ordersandshouldverifythatsuchinformationiscurrentandcomplete.AllproductsaresoldsubjecttoTI’sterms

and conditions of sale supplied at the time of order acknowledgment.

TI warrants performance of its hardware products to the specifications applicable at the time of sale in

accordance with TI’s standard warranty. Testing and other quality control techniques are used to the extent TI

deems necessary to support this warranty. Except where mandated by government requirements, testing of all

parameters of each product is not necessarily performed.

TI assumes no liability for applications assistance or customer product design. Customers are responsible for

their products and applications using TI components. To minimize the risks associated with customer products

and applications, customers should provide adequate design and operating safeguards.

TIdoesnotwarrantorrepresentthatanylicense, eitherexpress orimplied, isgranted underanyTIpatentright,

inwhichTIproductsorservicesareused.InformationpublishedbyTIregardingthird–partyproductsorservices

does not constitute a license from TI to use such products or services or a warranty or endorsement thereof.

Use of such information may require a license from a third party under the patents or other intellectual property

of the third party, or a license from TI under the patents or other intellectual property of TI.

Reproduction of information in TI data books or data sheets is permissible only if reproduction is without

alteration and is accompanied by all associated warranties, conditions, limitations, and notices. Reproduction

of this information with alteration is an unfair and deceptive business practice. TI is not responsible or liable for

such altered documentation.

Resale of TI products or services with statements different from or beyond the parameters stated by TI for that

product or service voids all express and any implied warranties for the associated TI product or service and

is an unfair and deceptive business practice. TI is not responsible or liable for any such statements.

Mailing Address:

Texas Instruments

Post Office Box 655303

Dallas, Texas 75265

Related Documentation From Texas Instruments

iii

Read This First

Preface

Read This First

About This Manual

This user’s guide describes the setup and operation of the TUSB3200EVM2

platform.

How to Use This Manual

This document contains the following chapters:

Chapter 1—Equipment

Chapter 2—Detailed Description of the TUSB3200EVM2

Appendix A—Schematic Diagrams

Related Documentation From Texas Instruments

TUSB3200A Literature Number SLES018

TLV2362 Literature Number SLOS195A

TPS7233QD Literature Number SLVS102G

CS4228 www.crystal.com for product detail information

FCC Warning

Thisequipmentisintendedforuseinalaboratorytestenvironmentonly.Itgen-

erates,uses,andcanradiateradiofrequencyenergyandhasnotbeentested

for compliance with the limits of computing devices pursuant to subpart J of

part 15 of FCC rules, which are designed to provide reasonable protection

against radio frequency interference. Operation of this equipment in other en-

vironmentsmaycauseinterferencewithradiocommunications,inwhichcase

the user at his own expense will be required to take whatever measures may

be required to correct this interference.

Running Title—Attribute Reference

Contents

1 Equipment 1-1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.1 Hardware 1-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.1.1 EEPROM Evaluation (Internal Mode) 1-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.1.2 In-Circuit Emulator (ICE) Evaluation 1-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2 Detailed Description of the TUSB3200EVM2 2-1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.1 TUSB3200EVM2 Setup 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.2 Interfaces and Ports 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.3 Power Supplies 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.4 Light Emitting Diode (LED) 2-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.5 Jumpers 2-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.6 Complete Analog Stage 2-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.7 EEPROM 2-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.8 TUSB3200A Development Tool Recommendations 2-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2.9 TUSB3200EVM2 Design Platform Schematic/Layout 2-4. . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figures

1–1 TUSB3200EVM2 Design Platform Equipment 1-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Tables

1–1 Jumpers Set Up for Internal Mode 1-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2–1 Jumpers and Switches 2-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1-1

Equipment

This user’s guide describes the setup and operation of the TUSB3200EVM2

platform.ThisPCB contains two main activeparts:TUSB3200ASTC(TIUSB

streamingcontroller)andcrystalCS4228codec.ThisPCBisreferredtoasthe

TUSB3200EVM2 from this point on. Familiarity with emulator hardware and

software is required and assumed throughout this user’s guide.

Topic Page

1.1 Hardware 1-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Chapter 1

Hardware

1-2

1.1 Hardware

Figure 1–1 shows the equipment necessary to perform evaluation of the

TUSB3200EVM2.

Figure 1–1.TUSB3200EVM2 Design Platform Equipment

USB EVM2

The TUSB3200EVM2 hardware platform measures 6.0′′ X 5.5′′ (W ×L).

Throughout this document text inside of parentheses (ex.) represents

reference designators that identify components located on the

TUSB3200EVM2.

The hardware setup for the TUSB3200EVM2 can be accomplished by two

separate methods—EEPROM evaluation and in-circuit emulator (ICE)

evaluation.UseoftheEEPROMinstalledon theboardisrecommendedwhen

performing a quick initial check to verify if the board works properly. The

respective evaluation procedures are detailed in the following section.

1.1.1 EEPROM Evaluation (Internal Mode)

The TUSB3200EVM2 comes with a preprogrammed EEPROM. This

EEPROM is inserted in the 8-pin DIP socket. The jumper configuration for the

internalmode is listed inTable 1–1.Usethefollowingprocedurefor EEPROM

evaluation:

Set J8 to position 1–2 to bus-power the TUSB3200EVM2; set J8 to 2–3

to put the TUSB3200EVM2 in self-powered mode (a power supply is

required).

In self-powered mode, a single 9-V dc at 500-mA supply must be

connected to the power terminals 9V and ground (GND) of the

TUSB3200EVM2. Once the board is powered, GPIO, and the LEDs

should turn on, and the power drawn from the supply should not exceed

the USB specification of 500 mA.

Connect a USB cable from the root hub of the PC to type-B connector J1

on the EVM. This should start the USB enumeration on a host PC.

Enumeration signals that a USB (audio) device has been detected by the

Hardware

1-3

Equipment

hostPCandthedeviceisreadytostreamaudioviaaUSB.Aspeakericon

should show up once the enumeration is complete. Double click this icon

to confirm that the USB is the preferred device for audio output; if not,

reconfigure the PC for USB audio output.

Table 1–1.Jumpers Set Up for Internal Mode

Jumper Position

JP1 Open

JP2 Open

JP3 Position 2–3

JP4 Open

JP5 Open

JP6 Open

JP7 Open

JP8 Position 2–3

JP9 Position 2–3

JP10 Position 2–3

JP11 Position 2–3

JP12 Position 2–3

JP13 Position 2–3

JP14 Open

JP15 Close

JP16 Open

JP17 Open

JP18 Open

1.1.2 In-Circuit Emulator (ICE) Evaluation

Use the following procedure for in-circuit emulator evaluation:

Installtheemulator.RefertotherespectiveICEuser’sguidefortheemula-

tor.

Attach emulator POD to TUSB3200EVM2 ICE Socket (J3). A 40-pin ex-

tension adapter may be required to allow enough clearance for access to

thebuttons,jumpers, and connectors. Pin 1 isdesignatedbyatriangleon

the opposite side of the J3 reference designator.

1-4

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Texas Instruments Contrôleurs

Texas Instruments

Texas Instruments LM5020 Manuel utilisateur

Texas Instruments

Texas Instruments TMS320x2833 series Manuel utilisateur

Texas Instruments

Texas Instruments EDMA3 Manuel utilisateur

Texas Instruments

Texas Instruments TMDSHVMTRPFCKIT Manuel utilisateur

Texas Instruments

Texas Instruments TPS40100 Manuel utilisateur

Texas Instruments

Texas Instruments TMS320C674X Manuel utilisateur

Texas Instruments

Texas Instruments LM2734 Manuel utilisateur

Texas Instruments

Texas Instruments DRV2511Q1EVM Manuel utilisateur

Texas Instruments

Texas Instruments bq78350-R1 Manuel d'utilisation et d'entretien

Texas Instruments

Texas Instruments bq24010/2 Manuel utilisateur

Texas Instruments

Texas Instruments UCD90320 Manuel utilisateur

Texas Instruments

Texas Instruments LM10524EVM Manuel utilisateur

Texas Instruments

Texas Instruments AM335 Series Manuel utilisateur

Texas Instruments

Texas Instruments TMS320DM644x Manuel utilisateur

Texas Instruments

Texas Instruments Sitara AM335x Manuel utilisateur

Texas Instruments

Texas Instruments MSP430x5 series Manuel utilisateur

Texas Instruments

Texas Instruments DLP LightCrafter Dual DLPC900 Feuille d'instructions

Texas Instruments

Texas Instruments TIDA-00642 Manuel utilisateur

Texas Instruments

Texas Instruments TMS370 Series Manuel utilisateur

Texas Instruments

Texas Instruments TMS320C6452 DSP Manuel utilisateur

Texas Instruments

Texas Instruments TPS211 AEVM Series Manuel utilisateur

Texas Instruments

Texas Instruments TPS59640EVM-751 Manuel utilisateur

Texas Instruments

Texas Instruments PCI7621 Guide d'installation et d'utilisation

Texas Instruments

Texas Instruments TUSB3210 Guide d'installation et d'utilisation

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur