10-6
TECEone – Operation
TECEone
• Fully turn the right rotary knob: The shower arm now
extends completely and you can start washing with water
(pictured right).
• You can increase or reduce the volume of water by turn-
ing the right rotary knob until you achieve the required
result.
• You can set the required temperature of water by turning
the left rotary knob – including during operation.
• To turn o the shower function, turn the knob back as far
as it will go.
Remove the toilet lid.
• Lift up the toilet lid and toilet seat.
• Remove the two set screws from the hinges using an
Allen key (2.5mm).
• Hold the toilet lid and seat with both hands and pull them
gently upwards.
Note: During assembly, after mounting both hinges, press
down on the attachment bolts – at the same time, applying
slight pressure.
Replacing the shower nozzle caps
The scope of delivery also includes three shower nozzle
caps (standard 75°).
To replace them, proceed as follows:
• Turn the right rotary knob until the shower arm extends
a little.
• Pull out the shower arm with your hand and turn o the
water supply (pictured left).
• Hold the shower arm firmly with one hand and with the
other, pull the cap forwards until it comes o the shower
arm (pictured right).
• Then push your chosen shower cap – with the opening
pointing upwards – onto the shower arm until it gently
locks into position.
As an option, additional shower caps can be ordered
which dier from each other in terms of the intensity and
position of the shower spray (see “Replacement parts”
section).
Operation
Operating elements
TECEone is operated intuitively using the right and left
rotary knobs:
• “Water regulation” right rotary knob (pictured left): use
this knob to open the water supply to the shower nozzle
and to regulate the intensity of the water jet. After a
certain volume of water starts to flow, the shower arm
extends “automatically” outwards.
• “Temperature setting” left rotary knob (pictured right):
use this knob to set the temperature of the water for
washing your backside and intimate areas.
Testing the temperature of the water when using for the
first time
• Turn the temperature regulator as far as it will go to the
highest possible temperature.
• Hold a suitable container (e.g. cup) in front of the shower
arm.
• Turn the right knob and test the water to check the tem-
perature. If the temperature is higher than 38°C, it must
be reset. The corresponding procedure can be found
in the Installation and Assembly/Temperature setting
chapter.
• Turn the left rotary knob to the required temperature or
to the middle position.
• Turn the right rotary knob as far as it will go to turn o
the water supply.
Starting the shower function
• If necessary, turn the right rotary knob only slightly: the
shower arm does not yet extend and cooled water may
run into the ceramic, at the same time the shower nozzle
is rinsed and washed with water (pictured left).
