TC Electronic D22 Instructions d'installation et d'utilisation

ADDENDUM for the D22 MANUAL

Max Delay time

The D22 is now delivered with a max Delay time of

5200ms per channel. This applies for units with serial

numbers above 2000990 (see backpanel of unit).

If your unit has a serial number below 2000990 the max.

Delay time is either 1300ms or 2600ms.

For these units an upgrade-kit is available. Contact your

local dealer for more information.

• This addendum cover changes to the manual revision 3.1.

• Newest software is now 2.50.

The Complete manual including the changes below can be downloaded from www.tcelectronic.com

Frequently Asked Questions

Question: What parameters can be set using serial

remote control of the D22?

Answer: Preset change, Delay time and Bypass using an

RS485/422/232 controller.

Question: What serial protocol is used?

Answer: The serial protocol is 9600, N, 8, 1.

This means 9.6 kbaud, no parity, 8 bit, 1 stop.

Question: What is the command structure for the

remote protocol?

Answer: #AA,CMD,VALUE<CR>

AA is Unit Address number as set on the Utility page.

CMD is command. Commands could be:

• PRE for preset change,

• BYP for Bypass,

• DEL for delay.

VALUE is (RAM) Preset number, 0 for Not Bypass,

1 for Bypass or amount of Delay.

<CR> is carriage return, the same as Enter or hex 0D.

Examples:

#05,PRE,10<CR> =Recall RAM preset no. 10 on D22

address 5.

#03,BYP,1<CR> =Bypass D22 address 3.

All commands and numbers are shown as ASCII.

Question: What is the data length of the delay time?

Answer: The delay is always a decimal number related to

the given delay unit of the D22. It is not possible to change

delay unit via the RS-485, so you must set this manually

before you send the command lines.

Example 1:

The delay unit is ms and you would like to set the delay to

10.5 ms:

#05,DEL,10.5<CR>

Example 2:

The delay unit is frames and you would like to set the delay

to 10.5 frames: #05,DEL,10.5<CR>

As you can see there is no difference between Example 1

and 2.

Example 3: The delay unit is ms and you would like to set

the delay to 10.5 frames:

You have to calculate the delay in ms yourself based on

the fps setting and then send a command-line.

Question: What ASCII characters should be sent for

Recall of RAM preset no. 10 on D22 address 5?

Answer: #05,PRE,10<CR> means these values (hex)

actually transmitted 23 30 35 2C 50 52 45 2C 31 30 0D

If you have questions left unanswered by the manual and

this addendum please refer to TC Support Interactive:

www.tcsupport.tc

TC Electronic, Sindalsvej 34, DK-8240 Risskov - [email protected]

D22 manual addendum

Rev 1 - SW - V 2.50

Prod. No. 608022311

Autres manuels pour D22

Table des matières

Autres manuels TC Electronic Équipement d'enregistrement

TC Electronic

TC Electronic G-System Manuel utilisateur

TC Electronic

TC Electronic M2000 Manuel utilisateur

TC Electronic

TC Electronic Konnekt Live Manuel utilisateur

TC Electronic

TC Electronic Flashback X4 Delay Manuel utilisateur

TC Electronic

TC Electronic 2290 P DYNAMIC DIGITAL DELAY Manuel utilisateur

TC Electronic

TC Electronic Multi-effects Processor G-Natural Manuel utilisateur

TC Electronic

TC Electronic TC ICON PEQ 3000 NATIVE Manuel utilisateur

TC Electronic

TC Electronic DVR250 NATIVE Manuel utilisateur

TC Electronic

TC Electronic FirewarX Manuel utilisateur

TC Electronic

TC Electronic TC2290 Manuel utilisateur

TC Electronic

TC Electronic FireworX Manuel utilisateur

TC Electronic

TC Electronic M-ONE Manuel utilisateur

TC Electronic

TC Electronic DB6 Manuel utilisateur

TC Electronic

TC Electronic DVR250-DT Manuel utilisateur

TC Electronic

TC Electronic G-Major Manuel utilisateur

TC Electronic

TC Electronic Finalizer Epress Manuel d'utilisation

TC Electronic

TC Electronic M-ONE Manuel utilisateur

TC Electronic

TC Electronic Konnekt 24D Manuel utilisateur

TC Electronic

TC Electronic Konnekt 24D Manuel utilisateur

TC Electronic

TC Electronic Desktop Konnekt 6 Manuel utilisateur

TC Electronic

TC Electronic DRIP SPRING REVERB Manuel utilisateur

TC Electronic

TC Electronic NR-I Nova Reverb Manuel utilisateur

TC Electronic

TC Electronic G-MAJOR 2 Manuel utilisateur

TC Electronic

TC Electronic NOVA System Manuel utilisateur

Manuels Équipement d'enregistrement populaires d'autres marques

KV2 Audio

KV2 Audio 500 Series Manuel utilisateur

Robotics Technologies

Robotics Technologies microBus-Cam II Manuel utilisateur

Seca

Seca 460 Manuel utilisateur

Cognex

Cognex MVS-8000 Series Manuel utilisateur

Mect

Mect MPNC006 Series Manuel utilisateur

Bad Caf

Bad Caf THE LEASH Manuel utilisateur

Strymon

Strymon NIGHTSKY Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manuel utilisateur

Tews Technologies

Tews Technologies TPMC465 Manuel utilisateur

Honeywell

Honeywell Excel 50 Manuel utilisateur

SeaLevel

SeaLevel COMM+8.LPCI Manuel utilisateur

Arturia

Arturia AUDIOFUSE STUDIO Manuel utilisateur

Rukra

Rukra RK-1240 Manuel utilisateur

Samson

Samson SCOM Manuel utilisateur

Dynacord

Dynacord DPS260 Manuel utilisateur

Nice

Nice Core Manuel utilisateur

Pyle Pro

Pyle Pro PSS8 Manuel utilisateur

RF-System

RF-System TinyGate Manuel d'utilisation et d'entretien