Symbol WSS 1000 Manuel utilisateur

WSS 1000 System

Symbol reserves the right to make changes to any product to improve

reliability, function, or design.

Symbol does not assume any product liability arising out of, or in

connection with, the application or use of any product, circuit, or

application described herein.

No license is granted, either expressly or by implication, estoppel, or

otherwise under any patent right or patent, covering or relating to any

combination, system, apparatus, machine, material, method, or process in

which Symbol products might be used. An implied license only exists for

equipment, circuits, and subsystems contained in Symbol products.

Symbol and the Symbol logo are registered trademarks of Symbol

Technologies, Inc. Other product names mentioned in this manual may be

trademarks or registered trademarks of their respective companies and are

hereby acknowledged.

Symbol Technologies, Inc.

One Symbol Plaza

Holtsville, N.Y. 11742-1300

http://www.symbol.com

Quick Reference

Introduction

The WSS 1000 is a wearable data entry system consisting

of a laser bar code scanner, usually worn on the

operator’s fingers or back of hand, and a wrist computer

(WWC 1000) worn on the operator’s forearm.

The detachable components work equally well for right-

and left-handed individuals. Detachable personal mounts

allow multiple operators to share both scanner and wrist

computer without having to use the same mount.

About This Guide

This guide presents information on system components,

assembling the WWC 1000, battery installation and

charging, attaching the system, using the keyboard, and

disassembly for use by others. For wearable scanner

information, refer to the WSS 1000 Product Reference

Guide, or the Quick Reference Guide provided with your

scanner.

WSS 1000 System

Parts of the WSS 1000 System

Keyboard

Display

Speaker

Battery

Latch

Power

Switch

Battery Charging

Contacts

Lithium-Ion

Battery

WWC 1000 Top

WWC 1000 (Wrist Computer) Front

Adjustable

Straps Snap-On

Bar

WWC 1000 Wrist Mount

Quick Reference

Installing and Charging the Battery

The wrist computer and scanner are powered by a

Lithium-Ion battery pack. The pack provides power for

a typical 8-hour shift.

Note: Before using the wrist computer, install and

fully charge the Lithium-Ion battery pack.

To install the battery pack in the WWC 1000:

1. Insert the battery pack, base first, in the battery

compartment.

2. Line up the pack’s locking mechanism with the

notch in the battery compartment wall by sliding

the battery latch, and press the pack into place.

3. Release the battery latch to lock in place.

Battery

Latch

Notch

Battery

Compartment

Battery Pack

Base

WSS 1000 System

Charging the Battery in WWC 1000

To charge the Lithium-Ion battery in the WWC 1000:

1. Place the WWC 1000 in the cradle as shown be-

low:

2. The cradle’s CHARGING light illuminates (RED)

if the WWC 1000 is properly seated and the bat-

tery is charging.

3. The battery requires approximately 2 hours to

charge fully. The CHARGING light changes to

GREEN when the battery is fully charged.

4. To remove the WWC 1000 from the cradle, tilt the

WWC 1000 upward and pull out.

For more information on the CS 1000 Cradle, re-

fer to the CS 1000 Single-Slot Cradle QRG, p/n

70-16237-xx, or the CS 1000 4-Slot Cradle QRG,

p/n 70-17661-xx.

Quick Reference

Charging the Spare Battery

Spare battery packs can be charged separate from the

WWC 1000. To charge a spare battery pack in the cradle:

1. Insert the pack in the cradle’s spare charging slot.

2. The CHARGING light illuminates red.

3. The spare pack is charged in approximately two

hours, even if the WWC 1000 is charging at the

same time. The CHARGING light changes to

green when the battery is fully charged.

WSS 1000 System

Assembling the WSS 1000 System

To assemble the WWC 1000 (wrist computer):

1. Place the WWC 1000 wrist computer onto the

wrist mount, facing you. Be sure the mount is ori-

ented so that the longer strap will be further up the

forearm.

2. Snap the bar over the WWC 1000 using the snaps

on either side of the mount. The straight part of the

bar should lay across the front of the WWC 1000;

the curved part in back.

Quick Reference

Note: The snaps on the wrist mount act as a tear-

away device allowing the wrist computer to

detach from the mount if it catches on an

object.

3. Plug the cable connector from the WWC 1000 in

the interface port on the back of the scanner.

4. Place the WWC 1000 on your arm:

a. Slide the wrist mount on your arm, so that the

WWC 1000 wrist computer faces you.

WSS 1000 System

b. Pull the straps through the buckles so the wrist

mount is secure but not tight.

c. Use the Velcro to secure the straps.

5. Assemble and mount your scanner. See your scan-

ner’s Quick Reference Guide, or the WSS 1000

Product Reference Guide.

Autres manuels pour WSS 1000

Table des matières

Langues :

Autres manuels Symbol Lecteur de codes-barres

Symbol

Symbol 3366 Manuel utilisateur

Symbol

Symbol Phaser P460 Manuel d'installation et d'exploitation

Symbol

Symbol PPT 8800 Manuel d'installation et d'exploitation

Symbol

Symbol LS3408-FZ20005 Manuel utilisateur

Symbol

Symbol LS 4208 Manuel utilisateur

Symbol

Symbol LS 5300 Manuel utilisateur

Symbol

Symbol LT 1850 Manuel utilisateur

Symbol

Symbol PDT 3100 Series Manuel d'installation et d'exploitation

Symbol

Symbol LS2208-SR20001R Manuel utilisateur

Symbol

Symbol DS3508 Manuel utilisateur

Symbol

Symbol LS1203-1AZU0100ZR Manuel utilisateur

Symbol

Symbol DS4308 Manuel utilisateur

Symbol

Symbol LS4278 Manuel utilisateur

Symbol

Symbol LS 4208 Manuel utilisateur

Symbol

Symbol LS3578 Manuel d'installation et d'exploitation

Symbol

Symbol LS3400 Manuel d'installation et d'exploitation

Symbol

Symbol LS9203 Manuel

Symbol

Symbol LS 4208 Manuel utilisateur

Symbol

Symbol SYMBOL DS6707 Manuel d'installation et d'exploitation

Symbol

Symbol P470/P370 Manuel d'installation et d'exploitation

Symbol

Symbol MiniScan MS-804FZY Guide de configuration rapide

Symbol

Symbol LS 6005i Manuel d'installation et d'exploitation

Symbol

Symbol LS 4071 Manuel utilisateur

Symbol

Symbol SE 2223 Guide de configuration rapide

Manuels Lecteur de codes-barres populaires d'autres marques

POSMicro

POSMicro Datalogic PowerScan D7100 Manuel utilisateur

Marson

Marson MT780 Guide de configuration rapide

NCR

NCR RealPOS Manuel utilisateur

Motorola

Motorola SE3300 Guide de configuration rapide

Element

Element P130BT Manuel utilisateur

Motorola

Motorola Symbol LS3008 Manuel d'installation et d'exploitation

Meec tools

Meec tools OBD-II / VAG Manuel utilisateur

SICK

SICK CLP 100 Manuel utilisateur

Royal Tag SA

Royal Tag SA I-Read Manuel utilisateur

Welch Allyn

Welch Allyn IMAGETEAM 3800 Manuel utilisateur

Meteor

Meteor 8310 Manuel utilisateur

Denso

Denso BHT-500B Manuel utilisateur

Datalogic

Datalogic Heron HD3130 Manuel utilisateur

Motorola

Motorola MP6000 Instructions de montage

Newland

Newland NLS-HR15-BT Manuel utilisateur

ARTDEV

ARTDEV AS-1310 Manuel utilisateur

Aopos

Aopos AS290 Manuel utilisateur

ENS

ENS 367-5455 Manuel utilisateur