Steren AMP-040AR Manuel utilisateur

ENGLISH

ENGLISH-02

IMPORTANT

Before using your new Audio amplier, please read the following

recommendations.

Verify Line Voltage Before Use

Connecting the amplier to a line voltage other than that for which it

is intended can create a safety and re hazard, and may damage the

amplier.

If you have any questions about the voltage requirements for your

specic model, or about the line voltage in your area, contact your

selling dealer before plugging the unit into a wall outlet.

Do Not Use Extension Cords

To avoid safety hazards, use only the power cord supplied with your

unit. If a replacement cord is used, make certain that it is of a similar

gauge. We do not recommend using extension cords with this product.

As with all electrical devices, do not run power cords under rugs or

carpets or place heavy objects on power cords.

Damaged power cords should be replaced immediately with cords

meeting factory specications.

Handle the AC Power Cord Gently

When disconnecting the power cord from an AC outlet, always pull the

plug; never pull the cord. If you do not intend to use the amplier for a

considerable length of time, disconnect the plug from the AC outlet.

ENGLISH

ENGLISH-03

Do Not Open the Cabinet

There are no user-serviceable components inside this product.

Opening the cabinet may present a shock hazard, and any modication

to the product will void your guarantee. If water enters the unit, or any

metal object such as paper clip, wire or staple accidentally falls inside

the cabinet, disconnect the unit from the AC power source immediately

and consult an authorized warranty station.

Installation Location

- To ensure proper operation and to avoid the potential for safety

hazards, place the unit on a  rm and level surface. When placing the

unit on a shelf, be certain that the shelf and any mounting hardware can

support the amplier’s weight.

- Make certain that the proper space is provided both above and below

the unit for ventilation. If the amplier will be installed in a cabinet or

other enclosed area, make certain that there is sufcient air movement

within the cabinet. Consult with your dealer or installer for more

information.

- Do not place the unit directly on a carpeted surface.

- Avoid installation in extremely hot or cold locations, in an area that is

exposed to direct sunlight or near heating equipment.

- Avoid moist or humid locations. This may produce malfuction or elec-

tric shock.

- Do not obstruct the ventilation slots on the top of the unit or place

objects directly over them. Remember, power ampliers generate heat,

and the heatsink ns and ventilation slots that form part of the cabinet

are specially designed to remove this heat.

ENGLISH

ENGLISH-04

Placing other electronic equipment near these heat dissipation systems

may possibly affect the long-term reliability of both your amplier and

the objects placed above it. The carton and shipping materials used in

protecting your new amplier were specially designed to cushion it from

the shocks and vibration of shipping. We suggest that you save the

carton and packing materials for use in shipping if you move or if the

unit ever needs repair.

Cleaning

When the unit gets dirty, wipe it with a clean, soft and dry cloth. If

necessary, rst wipe the surface with a soft cloth slightly dampened

with mild soapy water, followed by a fresh cloth with clean water. Wipe

immediately with a dry cloth. Never use benzene, thinner, alcohol or any

other volatile cleaning agent.

Do not use abrasive cleaners, as they may damage the nish of metal

parts. Avoid spraying insecticide near the unit.

Moving the Unit

Before moving the unit, be certain to disconnect any interconnection

cords with other components, and make certain that you disconnect the

unit from the AC outlet.

ENGLISH

ENGLISH-05

FEATURES

Your new audio amplier has two microphone inputs and one auxiliary

input to connect an external audio system. This amplier counts with an

Auto Reverse tape player and it counts with a built-in siren. The power

output is 45W and you can connect speakers with an impedance of 4, 8

and 16 . Also it has a short-circuit protector.

• 2 microphone inputs

• 1 auxiliary input

• 1 tape player with auto stop

• 2 microphone volume knobs

• 1 auxiliary volume knob

• 1 use indicator

• 1 siren switch

• 1 On / Off switch

ENGLISH

ENGLISH-06

CONTROLS

1.- On / Off

Turn on / Turn off the equipment

2.- Microphone 1 input

3.- Microphone 2 input

4.- Auxiliary input

Connect an external audio system

5.- Use indicator

Lights on when the equipment is in use

6.- Siren

Activates / deactivates the built-in siren

ENGLISH

ENGLISH-07

7.- Tape player

8.- Auxiliary volume knob

9.- Microphone 2 volume knob

10.- Microphone 1 volume knob

11.- Stop / Eject buttons

12.- Backward / Forward buttons

INSTALLATION

Low impedance speaker output: 4ohms

4ohms end has been designed for connections with a few speakers in a

range of less than 50 meters.

The total impedance from the speaker must be the same as in the

amplier output, for a better current distribution.

Make sure that the total impedance from the speakers are higher than 4

ohms.

Do not increase the output power from the amplier more than

allowable by the speakers. Otherwise, may cause damages on the

speakers.

ENGLISH

ENGLISH-08

ENGLISH

ENGLISH-09

SPECIFICATIONS

Input: 127V~ 60Hz 12V

Current: 520mA 2.15A

Output: 15W rms 40W max

Microphone input: 45dB 10kohms / 50kohms

Output: 40W max. 15W RMS

Frequency response: 150Hz to 15kHz 3dB

Total distortion: Less than 3%

Impedance: 4, 8 & 16ohms

Line out: 70V

Dimensions: 245 x 220 x78mm

Weight: 7,4lb

Product design and specications are subject to change, without

notice.

WARRANTY

This Steren product is warranted under normal usage against defects in workmanship and

materials to the original purchaser for one year from the date of purchase.

CONDITIONS

1.- This warranty card with all the required information, invoice or purchase ticket, product

box or package, and product, must be presented when warranty service is required.

2.- If the product stills on the warranty time, the company will repair it free of charge.

3.- The repairing time will not exceed 30 natural days, from the day the claim was received.

4.- Steren sell parts, components, consumables and accessories to customer, as well as

warranty service, at any of the addresses mentioned later.

THIS WARRANTY IS VOID IN THE NEXT CASES:

If the product has been damaged by an accident, acts of God, mishandling, leaky batteries,

failure to follow enclosed instructions, improper repair by unauthorized personnel, improper

safe keeping, among others.

a) The consumer can also claim the warranty service in the purchase establishment.

b) If you lose the warranty card, we can reissue it, if you show the invoice or purchase ticket.

Product: Audio amplier

Part number: AMP-040AR

Brand: Steren

Table des matières

Langues :

Autres manuels Steren Amplificateur

Steren

Steren AMP-012 Manuel utilisateur

Steren

Steren AMP-025 Manuel utilisateur

Steren

Steren AMP-020 Manuel utilisateur

Steren

Steren AMP-160 Manuel utilisateur

Steren

Steren AMP-016 Manuel utilisateur

Steren

Steren AMP-013 Manuel utilisateur

Steren

Steren AMP-120 Manuel utilisateur

Steren

Steren AMP-160 Manuel utilisateur

Steren

Steren AMP-010 Manuel utilisateur

Steren

Steren AMP-014 Manuel utilisateur

Steren

Steren AMP-600 Manuel utilisateur

Steren

Steren BAF-1280 Manuel utilisateur

Steren

Steren AMP-045CD Manuel utilisateur

Steren

Steren AMP-200 Manuel utilisateur

Steren

Steren AMP-009 Manuel utilisateur

Steren

Steren BAF-1595 Manuel utilisateur

Steren

Steren AMP-020/GTR Manuel utilisateur

Steren

Steren 208-100 Manuel utilisateur

Steren

Steren EP-128 Manuel utilisateur

Steren

Steren PWS-250D Manuel utilisateur

Steren

Steren AMP-210CD Manuel utilisateur

Steren

Steren AMP-210CD Manuel utilisateur

Steren

Steren AMP-005 Manuel utilisateur

Steren

Steren AMP-005 Manuel utilisateur

Manuels Amplificateur populaires d'autres marques

ASTRO

ASTRO HVO V40 P Manuel utilisateur

Marantz

Marantz SUPERSCOPE BLA-545 Instructions de montage

NAD

NAD CI980 Manuel utilisateur

Technics

Technics SE-CH770 Manuel utilisateur

Harman Kardon

Harman Kardon HK6300 Manuel utilisateur

NAD

NAD T975 Manuel utilisateur

McIntosh

McIntosh MA6850 Manuel utilisateur

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuel utilisateur

Viatron

Viatron Autrix Manuel utilisateur

GME

GME GA9800 Manuel utilisateur

Atlas

Atlas CP700 Manuel utilisateur

Roland

Roland KC-1000 Manuel utilisateur

Pyle

Pyle PFMRA350BW Manuel utilisateur

Advantage

Advantage S-250 Manuel utilisateur

IRT Electronics

IRT Electronics DVA-3007 Manuel utilisateur

Dimavery

Dimavery BA-100 Series Manuel utilisateur

Sony

Sony XM-S400D Manuel utilisateur

Schertler

Schertler ROY X Manuel utilisateur