Star Micronics TSP600 Series Manuel

Replacing the interface board

“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”

Federal Communications Commission Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.

This statement will be applied only for the printers marketed in U.S.A.

Statement of The Canadian Department of Communications Radio Interference Regulations

ThisdigitalapparatusdoesnotexceedtheClassAlimitsforradionoiseemissionsfrom digitalapparatussetoutintheRadioInterferenceRegulations

of the Canadian Department of Communications.

Leprésentappareilnumériquen’émetpasdebruitsradioélectriquesdépassantleslimitesapplicablesauxappareilsnumériquesdelaclasseAprescrites

dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

The above statement applies only to printers marketed in Canada.

The interface board is an option for the printer TSP600/TUP900 series.

When replacing the interface board, please use the following procedure.

Interface Board Applicable printer

IFBD-HD04 ......................RS-232C (25pin)

IFBD-HN04 ......................RS-232C (9pin) TSP

600 Series

IFBD-HC04 ......................Parallel TUP900 Series

Replacement

1. Make sure that the power cord is unplugged.

2. Remove the 2 screws.

3. Remove the interface board unit in the direction of the arrow.

4. When the new board is RS-232C interface board unit, change the setting of the

DIP Switches if necessay, referring to TSP600 User’s Manual or TBD900

Specification Manual.

5. Slide the new interface board in until it is firmly seated.

Note: Insert the interface board so that it connects with the connector.

6. Secure the interface board using the two screws.

80871230 IFTBD600

TSP600

DIP switch

(On RS

232C interface board)

Screw

Autres manuels pour TSP600 Series

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Star Micronics Imprimante

Star Micronics

Star Micronics TSP1000 Series Manuel

Star Micronics

Star Micronics TMP900 Manuel d'instructions d'installation

Star Micronics

Star Micronics LaserPrinter 8III Manuel utilisateur

Star Micronics

Star Micronics SP300 Series Manuel d'utilisation et d'entretien

Star Micronics

Star Micronics TUP500 series Instructions d'installation

Star Micronics

Star Micronics DP8340 Series Manuel utilisateur

Star Micronics

Star Micronics LaserPrinter 4III Manuel utilisateur

Star Micronics

Star Micronics TSP400 Series Manuel utilisateur

Star Micronics

Star Micronics futurePRNT TSP100 Manuel

Star Micronics

Star Micronics LC-240C Manuel utilisateur

Star Micronics

Star Micronics LC-100+ Manuel utilisateur

Star Micronics

Star Micronics Radix Manuel utilisateur

Star Micronics

Star Micronics FVP10 SERIES Manuel utilisateur

Star Micronics

Star Micronics SP500 Series Instructions de montage

Star Micronics

Star Micronics SM-T300I SERIES Manuel utilisateur

Star Micronics

Star Micronics Star DP8340 Manuel utilisateur

Star Micronics

Star Micronics SP700 Series Manuel utilisateur

Star Micronics

Star Micronics SF-10HA Manuel utilisateur

Star Micronics

Star Micronics Multi-Font NX-2415 Manuel utilisateur

Star Micronics

Star Micronics DP8340RC Series Manuel utilisateur

Star Micronics

Star Micronics TSP400 Series Manuel d'utilisation et d'entretien

Star Micronics

Star Micronics SP500 Series Manuel utilisateur

Star Micronics

Star Micronics LC-1011C Manuel utilisateur

Star Micronics

Star Micronics TSP043 Series Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Canon

Canon i70 Series Manuel utilisateur

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Canon

Canon LASER SHOT LBP-1210 Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Canon

Canon PIXMA PRO-1 Series Manuel utilisateur

Canon

Canon PIXMA G3560 Guide de configuration

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Epson

Epson ET-7750 Mode d'emploi

Canon

Canon CLBR 460ps Manuel utilisateur

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Epson

Epson SC-F7100 series Manuel utilisateur

Epson

Epson Stylus C40UX Manuel utilisateur

Canon

Canon imagePASS-A2 Manuel utilisateur

Canon

Canon S820D Manuel utilisateur