Stahls WEEDING TABLE Manuel de service
Installation Instructions
& Manual
WEEDING TABLE
STAHLS‘ Europe GmbH • Dieselstraße 62 • D-66763 Dillingen • Tel. +49 (0)6831/9733-0 • www.stahls.eu
Stand 130418
Installation Instructions
Step 1
Carefully unbox your Weeding Table
and place it on a secure surface.
Step 2
Using the four (4) bolts and nuts provided,
attach the material hold down bracket to
the table.
Step 3
Secure the plug to the weeding table and
plug into a 240 V power outlet.
Step 4
Turn on the Weeding Table by the
power rocker switch located on the left
side of the table. Select the temperature.
Low - approx. 40°C
Medium - approx. 48°C
High - approx. 54 °C
The temperature light will turn GREEN
when proper temperature is reached.
Manual
Step 1
Adjust your Weeding Table to one of the
3 elevated heights, by lifting the outside
edge of the table and tilting. Be sure the
crossbar is secure before releasing.
Step 2
Secure medio to the Weeding Table
using the material hold down bracket or
simply place material on top of the table.
Step 3
The Weeding Table comes equipped
with a storage compartment on the front
of the unit
Step 4
The Weeding Table also has a ledge
for holding your STAHLS‘ EZ-Weeder®.
Autres manuels Stahls Outils électriques
Stahls
Stahls Hotronix Air Fusion Manuel utilisateur
Stahls
Stahls STXBP-120 Manuel utilisateur
Stahls
Stahls Hotronix Fusion XF Manuel de la liste des pièces
Stahls
Stahls A2Z HEAT PRESS Manuel utilisateur
Stahls
Stahls A2Z HEAT PRESS Manuel utilisateur
Stahls
Stahls Hotronix MAXX CAP Manuel utilisateur
Stahls
Stahls Hot Berry Manuel utilisateur
Stahls
Stahls Hotronix Manuel utilisateur
Stahls
Stahls Hotronix Air Fusion Manuel utilisateur
Stahls
Stahls HOTRONIX AIR FUSION IQ Manuel utilisateur
