1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Introduction......................................................................................................3
1.1 About the FLEX Development Kit ................................................................................................ 3
1.2 Kit Contents ............................................................................................................................. 4
CANbus basics..................................................................................................5
Making an on desk simulation.......................................................................8
3.1 Preparation.............................................................................................................................. 8
3.2 Hardware setup....................................................................................................................... 8
3.3 Start the second FLEX “2” as interface to the telematics unit / PC ................................................. 9
3.4 Monitor the RS232 output of the Flex with iCheck ......................................................................10
3.5 Monitor the RS232 output of the FLEX with Docklight..................................................................12
Make scan file from vehicle CANbus or test device.................................15
4.1 Hardware setup ......................................................................................................................15
4.2 In vehicle setup with wired connection ......................................................................................15
4.3 Record a CANbus scan with iUpload .......................................................................................16
J1708 signals...................................................................................................18
5.1 Hardware setup wired.............................................................................................................18
5.2 Read data from J1708 bus.......................................................................................................18
5.3 Hardware setup DatacliQ........................................................................................................19
K-Line signals wired ......................................................................................20
6.1 Hardware setup ..................................................................................................................... 20
What to do next? ............................................................................................21
CANbus Termination.....................................................................................22
Abbreviations and Terminology..................................................................23
Technical Support..........................................................................................24
because you want to knowwww.squarell.com
Content
Appendix ...............................................................................................................25
