Spirit SPT0063 Manuel utilisateur

Treadmill

Please carefully read this entire manual before operating your new treadmill

OWNER’S MANUAL

XT185

SPT0063

TABLE OF CONTENTS

Important Safety Instructions 2

Important Electrical Instructions 3

Grounding Instructions 3

Important Operation Instructions 4

Assembly Instructions 5

Folding/Transport Instructions 10

Features 11

Console Operation 12

Programmable Features 13

General Maintenance 20

Exploded View Diagram/Parts List 25

XT185/SPT0063_Ver.A

IMPORTANT SAFETY INSTRUCTIONS

WARNING - Read all instructions before using this appliance.

DANGER - To reduce the risk of electric shock disconnect your treadmill from the electrical

outlet prior to cleaning and/or service work.

WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons, install the

treadmill on a flat level surface with access to a 230-volt, 10-amp grounded outlet with only

the treadmill plugged into the circuit.

DO NOT USE AN EXTENSION CORD UNLESS IT IS A 14AWG OR BETTER, WITH

ONLY ONE OUTLET ON THE END.

The treadmill should be the only appliance in the circuit in which it is connected.

DO NOT ATTEMPT TO DISABLE THE GROUNDED PLUG BY USING IMPROPER

ADAPTERS, OR IN ANY WAY MODIFY THE CORD SET. A serious shock or fire hazard

may result along with computer malfunctions. See Grounding Instructions, page 3.



Do not operate treadmill on deeply padded, plush or shag carpet. Damage to both carpet

and treadmill may result.



Do not block the rear of the treadmill. Provide a minimum of 3 1/2 feet clearance between

the rear of the treadmill and any fixed object.



Keep children away from the treadmill. There are obvious pinch points and other caution

areas that can cause harm.



Keep hands away from all moving parts.



Never operate the treadmill if it has a damaged cord or plug. If the treadmill is not

working properly, call your dealer.



Keep the cord away from heated surfaces.



Do not operate where aerosol spray products are being used or where oxygen is being

administered. Sparks from the motor may ignite a highly gaseous environment.



Never drop or insert any object into any openings.



Do not use outdoors.



To disconnect, turn all controls to the off position, then remove the plug from the outlet.



Do not attempt to use your treadmill for any purpose other than for the purpose it is

intended.



The hand pulse sensors are not medical devices. Their purpose is to provide you with an

approximate measurement in relation to your target heart rate. Use of a chest transmitter

strap is a much more accurate method of heart rate analysis. Various factors, including

the user’s movement, may affect the accuracy of heart rate readings. The pulse sensors

are intended only as exercise aids in determining heart rate trends in general.



Use handrails provided; they are for your safety.



Wear proper shoes. High heels, dress shoes, sandals or bare feet are not suitable for

use on your treadmill. Quality athletic shoes are recommended to avoid leg fatigue.

SAVE THESE INSTRUCTIONS - THINK SAFETY!

IMPORTANT ELECTRICAL INSTRUCTIONS

WARNING!

NEVER use a ground fault circuit interrupt (GFCI) wall outlet with this treadmill. As with any appliance with a

large motor, the GFCI will trip often. Route the power cord away from any moving part of the treadmill

including the elevation mechanism and transport wheels.

NEVER remove any cover without first disconnecting AC power. If voltage varies by ten percent (10%) or more,

the performance of your treadmill may be affected. Such conditions are not covered under your warranty. If you

suspect the voltage is low, contact your local power company or a licensed electrician for proper testing.

NEVER expose this treadmill to rain or moisture. This product is NOT designed for use outdoors, near a pool

or spa, or in any other high humidity environment. The safe operating termperature range is 40 to 120 degrees

Fahrenheit or 5 to 48 degrees Celsius, and humidity is 95% non-condensing (no water drops forming on

surfaces). Circuit Breakers: Some circuit breakers used in homes are not rated for high inrush currents

that can occur when a treadmill is first turned on or even during use. If your treadmill is tripping the house

circuit breaker (even though it is the proper current rating) but the circuit breaker on the treadmill itself

does not trip, you will need to replace the home breaker with a high inrush type. This is not a warranty

defect.

This is a condition we as a manufacture have no ability to control. This part is available through most

electrical supply stores. Examples: Grainger part # 1D237, or available online at www.squared.com

part # QO120HM.

GROUNDING INSTRUCTIONS

This product must be grounded. If the treadmill should malfunction or breakdown, grounding provides a path

of least resistance for electric current, reducing the risk of electric shock. This product is equipped with a cord

having an equipment-grounding plug. The plug must be plugged into an appropriate outlet that is properly

installed and grounded in accordance with all local codes and ordinances.

DANGER - Improper connection of the equipment-grounding conductor can result in a risk of electric

shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the product is

properly grounded. Do not modify the plug provided with the product if it will not fit the outlet; have a

proper outlet installed by a qualified electrician.

This product is for use on a nominal 230-volt circuit, and has a grounding plug that looks like the plug

illustrated below. A temporary adapter that looks like the adapter illustrated below may be used to connect

this plug to a 2-pole receptacle as shown below if a properly grounded outlet is not available. The temporary

adapter should be used only until a properly grounded outlet, (shown below) can be installed by a qualified

electrician. The green colored rigid ear-lug, or the like, extending from the adapter, must be connected to a

permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be

held in place by a metal screw.

IMPORTANT OPERATION INSTRUCTIONS

NEVER operate this treadmill without reading and completely understanding the results

of any operational change you request from the computer.

Understand that changes in speed and incline do not occur immediately. Set your

desired work level on the computer console and release the adjustment key. The

computer will obey the command gradually.

NEVER use your treadmill during an electrical storm. Surges may occur in your

household power supply that could damage treadmill components. Unplug the treadmill

during an electrical storm as a precaution.

Use caution while participating in other activities while walking on your treadmill; such

as watching television, reading, etc. These distractions may cause you to lose balance

which may result in serious injury.

Do not use excessive pressure on console control keys. They are precision set to

function properly with little finger pressure.

SAFETY TETHER CORD

A safety tether cord is provided with this unit. It is a simple magnetic design that should

be used at all times. It is for your safety should you fall or move too far back on the

tread-belt. Pulling this safety tether cord will stop tread-belt movement. To Use:

1. Place the magnet into position on the round metal portion of the console control head.

Your treadmill will not start and operate without this. Removing the magnet also

secures the treadmill from unauthorized use.

2. Fasten the plastic clip onto your clothing securely to assure good holding power. Note:

The magnet has strong enough power to minimize accidental, unexpected stopping.

The clip should be attached securely to make certain it does not come off. Be familiar

with its function and limitations. The treadmill will stop, depending on speed, with a

one to two step coast anytime the magnet is pulled off the console. Use the Stop /

Pause switch in normal operation.

ASSEMBLY INSTRUCTIONS

!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE READ BEFORE

UNPACKING YOUR FOLDING TREADMILL!!

Serious injury could occur if this folding treadmill is not unpacked properly.

There is a Velcro strap installed around the treadmill base that prevents the treadmill from

unfolding accidentally during shipping. If this strap is not removed properly the treadmill

could spring open unexpectedly and cause injury if someone is standing near the

treadmill when the strap is removed.

To ensure your personal safety during removal of the shipping strap please make sure

the treadmill is positioned flat on the ground, in the orientation it would be in if you were

using the treadmill. Do not turn the treadmill up on its side while removing the shipping

strap. This could cause the treadmill’s folding mechanism to spring open. If the end of the

Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck,

reach under the deck to grab it, but do not tilt the treadmill up to gain access to the strap

end.

Cut the banding straps with a short box cutter (razor knife); separate the carton from the

one underneath it by prying up on the staples (if applicable). Pull the carton over the

treadmill parts and locate the hardware pack. The hardware pack is separated into five

sections; one section containing tools and four sections labeled steps 1-4 which contain

the hardware needed for assembly of each step. The assembly steps below are

numbered one through four and correspond to the hardware in the numbered sections of

the hardware pack. Remove only the hardware for the step you are currently assembling

to avoid confusion and mix ups.

Then remove the treadmill from the carton and lay it on a level surface.

ASSEMBLY TOOLS

. Combination M5 Allen Wrench &

Phillips Head Screw Driver

#122. Phillips Head Screw Driver

#58. Deck/Belt Lubricant

#97. M6 Allen Wrench

#33. Safety Key

UPRIGHT TUBE ASSEMBLY

Take the Left and Right upright tubes (part numbers 5 &4) and slide the upright covers (99 &100

right) onto the tubes (observe the cover orientation is correct). Connect the Middle Console Cable

(38) that exits from the bottom of the right upright tube with the lower Console Cable (39). Insert the

Left and Right (5& 4) Uprights into the Left and Right Receiving Tubes (holes are on the outside of

the tubes). Be careful not to pinch the wire when installing the upright.

NOTE: Partially tighten all bolts in this Step. This will allow for easier console assembly.

Attach the tubes with three Button Head Socket Bolts (93) from each side and two Button Head

Socket Bolts (93) and two Curved Washers (94) from the front. Partially tighten using the Combi-

nation M5 Allen Wrench & Phillips Head Screw Driver (96).

HARDWARE

. 5/16” x 15mm

Button Head Socket Bolt

(8 pcs)

. 5/16” x 19 x 1.5T

Curved Washer (2 pcs)

CONSOLE ASSEMBLY

Connect the Speed Adjustment Switch Cable (128) to the Speed Cable (Upper)(126).

Connect the Incline Adjustment Switch Cable (129) to the Incline Cable (Upper)(127). Connect the

Computer Cable (Middle)(37) to the Computer Cable (Upper)(38).

Insert Console Assembly (40) into right and left Uprights (4) and (5) and secure with four Button

Head Socket Bolts (90) and four Split Washers (82) using the M6 Allen Wrench (97). Now go back

and completely tighten the 8 bolts (93) inserted in Step 1 that join the upright tubes (4& 5) to the

main frame.

HARDWARE

. 3/8” x 2.0T

Split Washer (4 pcs)

. 3/8” x 1-3/4”

Button Head Socket Bolt

(4 pcs)

PLASTIC PARTS ASSEMBLY

Attach the Console Covers (Left - 99) and (Right - 100) to the console (6) with ten Sheet Metal

Screws (89) using the Phillips Head Screw Driver (122).

HARDWARE

#89. 3.5 x 12mm

Sheet Metal Screw (10 pcs)

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Spirit tapis roulant

Spirit

Spirit CT800ENT Manuel utilisateur

Spirit

Spirit 1622778 Manuel utilisateur

Spirit

Spirit XT375 Manuel utilisateur

Spirit

Spirit ESP0030 -Esprit CT100 Manuel utilisateur

Spirit

Spirit XT275 Manuel utilisateur

Spirit

Spirit CT900 Manuel utilisateur

Spirit

Spirit 1622775 Manuel utilisateur

Spirit

Spirit XT485 Manuel utilisateur

Spirit

Spirit 16007604850-1 Manuel utilisateur

Spirit

Spirit CT850 ENT Manuel utilisateur

Spirit

Spirit XT175 Manuel utilisateur

Spirit

Spirit 1611800-1 Manuel utilisateur

Spirit

Spirit Z100-A81 Manuel utilisateur

Spirit

Spirit CT900ENT Manuel utilisateur

Spirit

Spirit XT285 Manuel utilisateur

Spirit

Spirit CT850 ENT Manuel utilisateur

Spirit

Spirit Esprit T10 Manuel utilisateur

Spirit

Spirit XT10 Manuel utilisateur

Spirit

Spirit Z100 Manuel utilisateur

Spirit

Spirit CT850 Manuel utilisateur

Spirit

Spirit XT385 Manuel utilisateur

Spirit

Spirit CT 900 TFT Manuel utilisateur

Spirit

Spirit 1610800 Manuel utilisateur

Spirit

Spirit Z8 Manuel utilisateur

Manuels tapis roulant populaires d'autres marques

Treadly

Treadly TREADLY 2 Manuel utilisateur

HEALTH ONE

HEALTH ONE Walk Ro Manuel utilisateur

NordicTrack

NordicTrack NTL12941 Manuel utilisateur

NordicTrack

NordicTrack T7.5 S Manuel utilisateur

Gold's Gym

Gold's Gym ADVANTAGE GGTL12920 Manuel utilisateur

Merax

Merax MS282992 Manuel utilisateur

FYTTER

FYTTER RU-2SX Manuel utilisateur

Precor

Precor 903 Manuel utilisateur

FitLogic

FitLogic freewill d225 Manuel utilisateur

HOP-SPORT

HOP-SPORT ESTIMA HS-3200LB Manuel utilisateur

Horizon Fitness

Horizon Fitness Adventure 5 Plus Manuel utilisateur

Stamia

Stamia InMotion II Manuel utilisateur

Smooth Fitness

Smooth Fitness EVO 3i Manuel utilisateur

NordicTrack

NordicTrack NETL81810.0 Manuel utilisateur

Schwinn

Schwinn 830/Journey 8.0 Manuel utilisateur

Keys Fitness

Keys Fitness HealthTrainer HT-740T Manuel utilisateur

NordicTrack

NordicTrack T 14.0 Treadmill Manuel utilisateur

Master

Master F22 Manuel utilisateur