Dynamics Toolbox Processor User Manual Page 5
This unit must be earthed.
This unit should only be connected to a
mains supply of the type mar ed on the
rear of the appliance. Ta e special note of
the required mains voltage.
The IEC mains connecting lead originally
supplied with this unit has been fitted with a
3A mains fuse. Always replace with a fuse
of the same rating. (UK plugs only)
This unit is fitted with an externally
accessible fuse. Always replace with a
fuse of the same type and rating. The fuse
type and rating are shown on the rear of
the unit just below the fuse receptacle.
Always disconnect the unit from the mains
supply before replacing this fuse.
Optional transformer cards may be fitted to
this unit. Ensure that fitting instructions are
closely followed and if in doubt always have
the fitting done by a qualified technician.
The operating mains voltage may be
selected inside the unit. Ensure that the
selection instructions are closely followed
and if in doubt always have this done by a
qualified technician.
