Sony SU-W210 Manuel utilisateur
Wall-Mount Bracket
© 2004 Sony Corporation
SU-W210
4-095-518-E1 (2)
Operating Instructions
•This Wall-Mount Bracket is designed for use with the Sony KLV-SG21M1
LCD Color TV.
2
Thank you for purchasing this product.
For Customers
Sufficient expertise is required for installing this product, especially to
assure the strength of the wall. Be sure to entrust the attachment of this
product on the wall (Step 1 to Step 3 in “Installation”) to qualified service
personnel and pay adequate attention to safety during the installation. We
are not liable for any damage or injury caused by mishandling or improper
installation.
WARNING
To avoid risk of serious injury or damage to the TV caused by dropping it,
observe the following precautions.
•Do not hang from the TV or the Wall-Mount Bracket installed on the wall.
• Be careful not to trap the AC power adaptor cord of the TV when you secure
the TV to the Wall-Mount Bracket.
•Follow the installation procedures and installation direction described in this
manual.
For a safety installation, consult qualified service personnel.
•Before installing, confirm that the wall has sufficient strength to support the
TV and the Wall-Mount Bracket. The installation location should be a flat,
perpendicular wall with a reinforcing material inside.
• Do not apply a weight other than the TV to the Wall-Mount Bracket installed
on the wall.
•Do not disassemble, modify or change the parts of the Wall-Mount Bracket.
For qualified service personnel
Sufficient expertise is required for installing this product. Be sure to read this
instruction manual thoroughly to do the installation work safely. We are not
liable for any damage or injury caused by mishandling or improper
installation. After installation, please hand this instruction manual to the
customers.
3
Caution
•This Wall-Mount Bracket is only for the specified Sony LCD Color TVs.
Do not use the bracket with a TV whose operating instructions do not specify
the use of this bracket.
•Be especially careful not to drop the TV when you install it high on a wall.
Installation
For the installation, have ready eight commercially available mounting screws,
anchor bolts, etc. that are appropriate for the wall.
The type and length of the screws required depend on the material and
strength of the wall. If you do not know which material your wall is made of,
consult qualified service personnel.
Step 1: Check the parts
Check all the parts are included in the package.
For qualified service personnel
Bracket A(1) Bracket C(3)
(0°, 5°, 10°) Bracket E(1) Screw (6)
(with washer)
Bracket B(1) Bracket D(1) Locking rod (1)
continued
4
Step 2: Decide the installation location
Decide the location on the wall to install the TV.
Then, place bracket Aon the installation location and mark the four screw
holes on the wall using a pencil.
Before marking the location of the holes, make sure that the distance between the
upper edge of bracket Aand the ceiling is 15 cm or more, and that between the
side edge of bracket Aand the side wall is 25 cm or more.
Note
Attach bracket Alevel with the floor.
Bracket A
Ceiling
15 cm
or more
Wall
Mark this
portion using
a pencil.
25 cm or more
5
Step 3: Secure bracket Ato the wall
1Insert four of the screws you prepared at the positions
marked in Step 2 (page 4).
Do not tighten the screws completely for the moment. Keep a space of
2 to 3 mm from the wall.
2Press bracket Ato the wall and slide it down. Then fully
tighten the four screws on the wall.
3Insert four of the screws you prepared in the screw holes,
and tighten them securely in the order of 1to 4as
shown below.
Screws you
prepared
Wall
2 - 3 mm
Bracket A
Bracket A
continued
Screws you
prepared Bracket A
1
3
2
4
Wall
Wall
6
Step 4: Attach bracket Bto the TV
Before attaching bracket B, remove the rear cover of the TV and disconnect all
the cables from the TV.
See the Operating Instructions for the KLV-SG21M1 for details on detaching
the rear cover.
1Remove the five screws and detach the TV stand from the TV.
To protect the LCD panel surface from possible damages, lay the TV face
down on a soft cloth.
Notes
•Lay the TV face down on a stable and level surface, letting the TV stand stick out in
the air. Putting the TV face and the stand on the same level surface makes the TV
unit inclined, thus unstable, causing any danger.
•When removing the TV stand, hold it firmly.
Soft cloth Rear of the TV
Remove these screws.
TV stand
7
2Align the four holes on bracket Bto the corresponding
holes on the rear panel then secure the bracket to the TV
using four of the five screws you removed previously.
Note
Keep the remaininig screw for future use. Use it to secure the stand to the TV again.
Step 5: Connect the cables
1Connect the cables.
Bundle the cables and secure them with the clips.
Do not attach the rear cover.
Rear of the TV
Bracket B
Rear of the TV
Clips
continued
8
Step 6: Attach brackets C, D, and Eto the TV
1Attach bracket Cof the desired angle to bracket B.
Insert the hooked part of bracket Cinto bracket Bas illustrated below.
Confirm that both sides of bracket Care outside bracket B, and secure
them firmly with two of the supplied screws.
There are three types of bracket C, each with a different angle: 0°, 5°,
and 10°. Choose the bracket Cwith the desired angle to attach.
The illustration below shows an example of how to attach bracket C
with an angle of 0°.
Bracket C
The angle “0°,” “5°,” or
“10°” is marked on the
side of bracket C.
9
2Attach bracket Dto bracket C, and secure them firmly
with two of the supplied screws.
Place bracket Donto bracket Cas illustrated below, and secure them
with the two screws.
3Attach bracket Eto bracket C, and secure them firmly
with two of the supplied screws.
Slide the shaft of bracket Einto the notches of bracket Cas illustrated
below, and secure them with the two screws one on each side.
Note
Be careful not to get your fingers caught between the brackets when attaching them.
Bracket D
Bracket E
Shaft
continued
10
Step 7: Secure the TV to the wall
1Hook bracket Eon bracket A.
Notes
•Hold the TV firmly. Be especially careful when you secure the TV in a high place.
•Do not release the TV until you confirm that bracket Eis firmly secured to bracket
Aat three locations.
Bracket E
Bracket A
Wall
Autres manuels pour SU-W210
3
Table des matières
Autres manuels Sony Support TV
Sony
Sony SS-FRF7ED Manuel utilisateur
Sony
Sony KLV-S40A10 Manuel utilisateur
Sony
Sony SU-TS1U Manuel utilisateur
Sony
Sony SU-WL53 Manuel utilisateur
Sony
Sony KDL-32VL140 - Bravia Lcd Television Mode d’emploi
Sony
Sony WS-X10W Manuel utilisateur
Sony
Sony SU-PW1 Instructions et recettes
Sony
Sony SU-LW1 Instructions (SU-LW1 Wall-Mount... Manuel utilisateur
Sony
Sony MB-514 Manuel utilisateur
Sony
Sony SU-WL700 Mode d’emploi
Sony
Sony PLP-91/D Manuel utilisateur
Sony
Sony BRAVIA KDL-52XBR Manuel utilisateur
Sony
Sony SU-RG12S Manuel utilisateur
Sony
Sony SU-W200 Manuel de la liste des pièces
Sony
Sony SU-WL450 Manuel de service
Sony
Sony SU-40XBR8 Manuel utilisateur
Sony
Sony SU-PW1 Manuel utilisateur
Sony
Sony KDS-R50XBR1 - 50" Grand Wega™ Sxrd™ Rear Projection... Manuel utilisateur
Sony
Sony SU-WL500 Instructions (SU-WL500 Wall-Mount... Manuel utilisateur
Sony
Sony SU-WL450 Manuel de service
