Sony SDX-D420V Series Manuel utilisateur

2-108-661-01(2)

Operating Instructions

AIT Drive

SDX-D420V Series

2Safety Regulations

Safety Regulations

Owner’s Record

The model and serial numbers are located on the bottom. Record the serial

number in the space provided below.

Refer to them whenever you call upon your dealer regarding this product.

Model No. Serial No.

Information

WARNING

To prevent fire or shock hazard, do not expose the

unit to rain or moisture.

To avoid electrical shock, do not open the cabinet.

Refer servicing to qualified personnel only.

MODEL No. for Regulatory Compliance

Your AIT-1 is assigned the MODEL No. ATDEA2A (respectively) for

regulatory compliance certifications. The number is indicated on the model

number label on your drive along with the rated voltage and current.

For customers in the USA

You are cautioned that any changes or modifications not expressly approved

in this manual could void your authority to operate this equipment.

FCC Compliance

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

The shielded interface cable recommended in this manual must be used with

this equipment in order to comply with the limits for a digital device pursuant

to Subpart B of Part 15 of FCC Rules.

Safety Regulations 3

English

CAUTION

The mains plug on this equipment must be used to disconnect mains power.

Please ensure that the socket outlet is installed near the equipment and shall

be easily accessible.

ACHTUNG

Zur Trennung vom Netz ist der Netzstecker aus der Steckdose zu ziehen,

welche sich in der Nähe des Gerätes befinden muß und leicht zugänglich

sein soll.

Hinweis: Der höchste Schalldruckpegel beträgt 70 dB (A) oder weniger

gemäß ISO 7779

NOTICE

Use the power cord set approved by the appropriate testing organization for

the specific countries where this unit is to be used.

HINWEIS

Die 3-adrige Geräteanschlußleitung muß Typ H05VV-F oder H05VVH2-F

sein und nach DIN VDE 0625 geprüft sein. Der Stecker und die

Gerätesteckdose müssen nach DIN VDE 0620 bzw DIN VDE 0625 geprüft

sein. Der Leitungsquerschnitt kann 0,5 mm2betragen wenn die

Anschlußleitung eine Länge von 2 m nicht überschreitet. Anderenfalls muß

der Leitungsquerschnitt mindestens 0,75 mm2betragen.

If you have any questions about this product, please refer to Sony contact in

the instruction manual.

DECLARATION OF CONFORMITY

Trade Name: SONY

Model: ATDEA2A

Responsible Party: Sony Electronics Inc.

Address: 16450 W. Bernardo Dr., San Diego, CA

92127 U.S.A.

Telephone number: 858-942-2230

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including

interference that may cause undesired operation.

Für Kunden in Deutschland

Diese Ausrüstung erfüllt die Europäischen EMC-Bestimmungen für die

Verwendung in folgender/folgenden Umgebung(en):

–Wohngegenden

–Gewerbegebiete

–Leichtindustriegebiete

(Diese Ausrüstung erfüllt die Bestimmungen der Norm EN 55022, Klasse B.)

4Safety Regulations

Safety Regulations 5

IMPORTANT SAFEGUARDS

For your protection, please read these safety

instructions completely before operating the

appliance, and keep this manual for future reference.

Carefully observe all warnings, precautions and

instructions on the appliance, or the one described in

the operating instructions and adhere to them.

USE

Power Sources – This unit should be operated only

from the type of power source indicated on the

marking label. If you are not sure of the type of

electrical power, consult your dealer or local power

company.

For the unit with a three-wire grounding type ac

plug:

If you are unable to insert the plug into the outlet,

contact your electrician to have a suitable plug

installed. Do not defeat the safety purpose of the

grounding plug.

AC Power cord:

The AC power cord should have appropriate safety

approvals or marking for the country in which the

equipment will be used. Consult your dealer or

local power company.

Cleaning – Unplug the unit from the wall outlet

before cleaning or polishing it. Do not use liquid

cleaners or aerosol cleaners.

Use a cloth lightly dampened with water for

cleaning the exterior of the unit.

Object and Liquid Entry – Never push objects of any

kind into the unit through openings as they may

touch dangerous voltage points or short out parts

that could result in a fire or electric shock. Never

spill liquid of any kind on the unit.

6Safety Regulations

INSTALLATION

Water and Moisture – Do not use power-line

operated units near water - for example, near a

bathtub, washbowl, kitchen sink, or laundry tub, in a

wet basement, or near a swimming pool, etc.

Power-Cord Protection – Route the power cord so

that it is not likely to be walked on or pinched by

items placed upon or against them, paying particular

attention to the plugs, receptacles, and the point

where the cord exits from the appliance.

Accessories – Do not place the unit on an unstable

cart, stand, tripod, bracket, or table. The unit may

fall, causing serious injury to a child or an adult, and

serious damage to the unit. Use only a cart stand

tripod, bracket, or table recommended by the

manufacturer.

Ventilation – The slots and openings in the cabinet

are provided for necessary ventilation. To ensure

reliable operation of the unit, and to protect it from

overheating, these slots and openings must never be

blocked or covered.

•Never cover the slots and openings with a cloth or

other materials.

•Never block the slots and openings by placing the

unit on a bed, sofa, rug or other similar surface.

•Never place the unit in a confined space, such as a

bookcase, or built-in cabinet, unless proper

ventilation is provided.

SERVICE

Damage Requiring Service – Unplug the unit from

the wall outlet and refer servicing to qualified

service personnel under the following conditions:

•When the power cord or plug is damaged or

frayed.

•If liquid has been spilled or objects have fallen

into the unit.

•If the unit has been exposed to rain or water.

•If the unit has been subject to excessive shock by

being dropped, or the cabinet has been damaged.

•If the unit does not operate normally when

following the operating instructions. Adjust only

those controls that are specified in the operating

instructions. Improper adjustment of other

controls may result in damage and will often

require extensive work by a qualified technician

to restore the unit to normal operation.

• When the unit exhibits a distinct change in

performance - this indicates a need for service.

Servicing – Do not attempt to service the unit

yourself as opening or removing covers may expose

you to dangerous voltage or other hazards.

Refer to all servicing to qualified service personnel.

Table of Contents 7

• Sony cannot accept liability for data written to cartridges lost as a result of using this product.

• Sony bears no responsibility for any financial damages, lost profits, or claims made by third parties

arising from the use of this product.

Table of Contents

How to Use this Guide 8

Chapter 1

Introduction

About the AIT Drive........................................................................... 9

Features .................................................................................................... 9

System Requirements ............................................................................ 10

Useable Cartridges ................................................................................. 10

Part Names and Functions ............................................................. 11

Front Panel ............................................................................................. 11

Rear Panel .............................................................................................. 12

Chapter 2

Preparation

Supplied Items................................................................................. 13

Interconnections ............................................................................. 13

Option Switches (DIP Switch) ........................................................ 14

Chapter 3

Operation

How to use the AIT Drive ................................................................ 16

Cartridge Removal ................................................................................. 17

Attaching the Dust Cover ............................................................... 18

Chapter 4

Care and

Maintenance

Taking Care of the Drive ................................................................. 20

Safety Considerations ............................................................................ 20

Avoiding Damage .................................................................................. 20

Taking Care of Cartridges .............................................................. 22

Usage Precautions ................................................................................. 22

Storage Precautions ............................................................................... 22

Head Cleaning ................................................................................. 23

How to Clean ......................................................................................... 23

Appendix Specifications .................................................................................. 24

Sony Contacts ................................................................................. 25

8How to Use this Guide

How to Use this Guide

This guide describes how to use and care for the SDX-D420V. Please read it

carefully before using the drive and save it for future reference.

The guide consists of four chapters and an appendix. Refer to the chapters

that relate to your use of the drive.

Chapter 1 Introduction

Describes the features of the drive, system requirements, and the names and

functions of each part.

Chapter 2 Preparation

Describes the necessary connections between the drive and the host

computer. Read this chapter when you install the drive.

Chapter 3 Operation

Describes how to use the drive, including how to turn it on, and how to insert

and remove cartridges. Read this chapter when you are going to use the drive.

Chapter 4 Care and Maintenance

Describes how to take care of the drive and cartridges, and how to clean the

drive head. Read this chapter before using the drive.

Appendix

Contains the specifications of the drive.

Trademarks

• Microsoft and Windows are either registered trademarks or trademarks of

Microsoft Corporation in the United States and/or other countries.

• All other system names, products, and services are either registered

trademarks or trademarks of their respective owners. The ™ or ® marks do

not appear in this manual.

Chapter 1 Introduction 9

Chapter 1 Introduction

About the AIT Drive

The SDX-D420V is an external AIT drive using data cartridges that conform

to the AIT-1 format.

Features

The SDX-D420V has the following features.

•Uses the Advanced Intelligent Tape (AIT) format AIT-1 data cartridges.

AIT-1 data cartridges provide 35 GB of storage (no compression) on a

230-m tape. The Read After Write function and Third Level Error

Correction Code ensure high data reliability.

•The drive comes with a data compression function, providing a maximum

of 91 GB of storage on an AIT-1 data cartridge (230-m tape).*1

•Stored data is automatically checked for compression. The drive can also

read data recorded with other devices.

•The drive is equipped with a USB interface. You can therefore connect the

drive to either connector to your computer.

Note

You cannot use the USB interface simultaneously.

• The drive supports Hot Plug, which means that you can connect and

disconnect it while the drive and/or your computer is on.

*1 Assuming a 2.6:1 hardware compression ratio.

The actual degree of compression during recording depends on the system environment and

the type of data.

10 Chapter 1 Introduction

System Requirements

The following are the minimum system requirements to use the drive.

•PC/AT-compatible computer (300 MHz or faster)

•Running Windows Server 2003, Windows XP, Windows 2000

• CD-ROM drive (to install the software necessary to the drive)

•USB interface

Useable Cartridges

The SDX-D420V can be used with data cartridges marked with the AIT-1 logo.

AIT-1 Logo

AIT-1 Data Cartridges

Name Capacity (no compression)

SDX1-35C 35 GB

SDX1-25C 25 GB

AIT Cleaning Cartridges

Name Description

SDX1-CL AIT drive cleaning cartridge

Note

•Be sure to use only data cartridges designed specifically for AIT.

•Do not use anything but AIT cartridges with this system, as doing so can

damage the AIT drive. Although commercially available 8mm videotapes

resemble AIT cartridges in appearance, they have entirely different

specifications and cannot be used.

Table des matières

Autres manuels Sony Stockage

Sony

Sony Memory Stick PRO Duo MS-MT Series Manuel utilisateur

Sony

Sony USM32D Manuel utilisateur

Sony

Sony VGN-BX660P Mode d’emploi

Sony

Sony BKMA-U70 Manuel utilisateur

Sony

Sony USD5G Manuel utilisateur

Sony

Sony CSM100B Manuel utilisateur

Sony

Sony SDT-S11000 Manuel utilisateur

Sony

Sony SDT-9000 Series Manuel utilisateur

Sony

Sony PSZ Series Manuel utilisateur

Sony

Sony HD-EG5U Manuel utilisateur

Sony

Sony USM16 Manuel utilisateur

Sony

Sony ODS-L30M Manuel utilisateur

Sony

Sony SF16UX Manuel utilisateur

Sony

Sony PCV-RZ49 VAIO Mode d’emploi

Sony

Sony XDCAM PDW-D1 Manuel utilisateur

Sony

Sony StorStation LIB-D81 Manuel utilisateur

Sony

Sony SxS PRO Manuel utilisateur

Sony

Sony SRR1000 Manuel utilisateur

Sony

Sony VPCL135FX Mode d’emploi

Sony

Sony QD Series Manuel utilisateur

Sony

Sony PDW-1 Manuel utilisateur

Sony

Sony SLW-MG2 Manuel utilisateur

Sony

Sony ODS-L10 Manuel utilisateur

Sony

Sony USM32A, USM64A, USM128A, USM256A Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur