Sony SU-PT3M Manuel utilisateur

2-179-717-E1 (1)

Table-Top Stand

SU-PT3M

For Customers and Sony Dealers

To Customers

WARNING

If the following precautions are not observed,

serious injury or death through fire, electric

shock, the product toppling over, or the product

dropping can result.

Be sure to subcontract the

installation to Sony dealers.

If persons other than Sony dealers do the installation

work, this may result in serious injury, as the TV is

very heavy.

Be sure to take measures to prevent

the stand from toppling over.

If you fail to do so, the Table-Top Stand may topple

over and cause injury or property damage. Anchor the

TV to the wall, pillar, etc., to prevent it from toppling

over.

Be sure to install the Table-Top Stand

on a solid and flat surface.

Do not install the Table-Top

Stand so that it leans in one

direction. If you do so, the

Table-Top Stand may topple

over or the TV may fall. This

may cause injury or property

damage.

Be sure to install the Table-Top Stand

on a stable surface.

If you install the Table-Top

Stand on an unstable surface, it

may lose its balance and topple

over or fall off. This may cause

injury or property damage.

Thank you for purchasing this product.

To customers

Sufficient expertise is required for installing this

product. Be sure to subcontract the installation to

Sony dealers or licensed contractors and pay

special attention to safety during the installation.

Sony is not liable for any damages or injury caused

by mishandling or improper installation.

WARNING

If the safety precautions are not observed or the

product is used incorrectly, it may result in serious

injury or fire.

This instruction manual shows the correct handling of

the product and important precautions necessary to

prevent accidents. Be sure to read this manual

thoroughly and use the product correctly. Keep this

manual available for future reference.

To Sony dealers

Sufficient expertise is required for installing this

product. Be sure to read this instruction manual

thoroughly to do the installation work safely. Sony is

not liable for any damages or injury caused by

mishandling or improper installation. Please give this

manual to the customer after installation.

On Safety

Products by Sony are designed with safety in mind. If

the products are used incorrectly, however, it may

result in a serious injury through fire, electric shock,

the product toppling over, or the product dropping. Be

sure to observe the precautions for safety to prevent

such accidents.

CAUTION

Specified product (As of April 2005)

Plasma TV KDE-W50A10

This Table-Top Stand is designed for use with the

specified product above.

For other TVs, refer to their operating instructions to

check if the Table-Top Stand can be used.

Do not lean on or hang from the TV

with the TV installed on the Table-

Top Stand.

The Table-Top Stand may

topple over, or the TV may fall

and cause serious injury or

death.

Do not cover the ventilation hole of

the TV.

If you cover the ventilation hole

(with a cloth, etc.), heat may

build up inside and cause fire.

Do not allow the mains lead or the

connecting cable to be pinched.

•Do not allow the mains lead

or the connecting cable to be

pinched when you install the

TV on the Table-Top Stand. If

the mains lead or the

connecting cable is damaged,

this may result in a fire or an

electric shock.

•Do not step on the mains lead

or the connecting cable when

you carry the Table-Top

Stand. The mains lead or the

connecting cable may be

damaged, and this may result

in a fire or an electric shock.

Do not stumble over the mains lead

or the connecting cable.

If you stumble over the mains lead or the connecting

cable, the Table-Top Stand may topple over and cause

injury.

CAUTION

If the following precautions are not observed,

injury or property damage may occur.

Do not install any equipment other

than the specified product.

This stand is designed for use with the specified

product only. If you install equipment other than

specified, it may fall and cause injury or property

damage.

Be sure to secure the TV.

Secure the TV to the Table-Top Stand using the

supplied screws. If the TV is not installed securely, it

may fall and cause injury.

Notes on installation

Install the stand on a solid and flat surface. Do not

allow the stand to be installed at an angle or incline. To

avoid this, observe the following precautions.

–If you install the stand on a soft surface such as a

mat or a carpet, lay a board over the designated

location beforehand.

–Do not install the stand in a place subject to direct

sunlight or near a heater.

–Do not install the stand in a hot or humid place, or

outdoors.

Note on use

Cleaning

To keep the stand clean, occasionally wipe the stand

with a dry soft cloth. Stubborn stains may be removed

with a cloth slightly dampened with diluted detergent.

Then wipe the area with a dry soft cloth. Do not use

chemicals, such as thinner or benzine, as they damage

the finish of the stand.

Magnet influence

This TV contains strong magnet in the speaker unit

which generates a magnetic influence. Keep any items

that are susceptible to magnetic influence away from

the TV speaker.

Checking the parts

Name Quantity

Bottom plate

Rear panel

Rear panel securing screw

Hexagonal wrench

Anchor attachment

TV securing screw

Cable band

Cable band securing screw

Prepare a Phillips screwdriver that fits the screws

indicated above before the assembly.

WARNING

To Sony Dealers

The following instructions are for

Sony Dealers only. Be sure to read

safety precautions described above

thoroughly and pay special attention

to safety during the installation,

maintenance, checking and repair of

this product.

Be sure that two or more persons do

the installation work.

Be sure that two or more persons install the TV on the

Table-Top Stand. If one person does the installation

work alone, this may result in an accident or an injury.

Be sure to install the TV securely,

following the instructions in this

manual.

Be sure to tighten the screws firmly. If the TV is not

installed securely, it may fall and cause injury.

Be careful not to hurt your hands or

fingers during installation.

Be careful not to hurt your hands or fingers when

installing the TV.

Woofer speaker

(Hexagonal socket

countersunk screw

(Hexagonal

socket screw

with washer 2)

Assembling the Table-

Top Stand

WARNING

If you allow the mains lead to be pinched under or

between pieces of equipment, this may result in a

short circuit or an electric shock.

If you stumble over the mains lead or the

connecting cable, the stand may topple over and

cause injury.

Decide on the installation location and work

near there.

Since the TV is heavy, it is recommended that you

decide on the installation location and lay the

Table-Top Stand down before installing the TV.

Note

Do not drag the Table-Top Stand. The rubber footings on

the base of the Table-Top Stand may come off.

1Change the position of the

woofer speaker.

1Loosen the screws (two each on the left and

right pillars) used to secure the woofer

speaker in place (about three turns).

2Slide the woofer speaker as shown in the

illustration until it stops.

3Tighten the screws loosened in Step 1at the

position indicated by the fmark to secure

the woofer speaker.

Note

If you fail to slide the woofer speaker completely in

Step 2, you cannot secure the screws in Step 3.

Screw position before sliding. (Loosen the

screws, but do not remove them.)

Screw position after sliding.

(fmark)

Soft cloth

2Secure the rear panel to the

bottom plate.

1Place the rear panel on the bottom plate so

that the projections on both ends of the metal

part of the bottom plate fit into the slots on

the base of the rear panel.

2Tighten the four rear panel securing screws

using the supplied hexagonal wrench to

secure the rear panel to the bottom plate.

Rear side

Hexagonal socket

screw with washer

Front side

Hexagonal socket

countersunk screw

Installing the TV

1Place the TV on the Table-Top

Stand.

Be sure to insert the dowels on the Table-Top

Stand into the slots of the TV.

Note

Do not hold the transparent part locating at the lower

part of the TV, otherwise your hands may be pinched

when installing the TV on the stand.

TV front

Woofer speaker connector

TV base

Slots

Woofer speaker connector

2Secure the TV.

1Insert the anchor attachments in the second

screw holes from the top on the left and right

pillars of the rear panel and tighten them to

secure the TV at the center of its rear.

2Insert four TV securing screws in the

elongate holes on the lower part of the both

pillars of the rear panel and tighten them to

secure the TV at the lower part of its rear.

Notes

•Be sure to secure the anchor attachments first, as it

will be easier to align the TV securing screws with

their screw holes.

• When using an electric screwdriver, set the torque

setting to about 1.5 N·m.

3Connect the mains lead and the

connecting cables to the TV.

zTip

For details on connecting the mains lead and the

connecting cables, refer to the instruction manual of

the Plasma TV (KDE-W50A10).

TV securing screw

Anchor attachment

Connecting

cable

Mains lead

4Bundle the mains lead and the

connecting cables.

1Attach the cable band to the left pillar of the

rear panel with the supplied cable band

screw, and then pass the mains lead through

the cable band.

2Remove the screw fastening the cable cover.

Open the cable cover and place the cables

underneath it.

3Tighten the screw removed in Step 2to

fasten the cable cover again.

Note

Be careful not to pinch the mains lead and the

connecting cables with the screw that fastens the cable

cover. The mains lead and connecting cables may be

damaged and result in malfunction.

Cable band

securing

screw

Cable

cover

Checking the operation

of the woofer speaker

This Table-Top Stand is equipped with a woofer

speaker. Turn on the power of the TV after

installing it on the Table-Top Stand and check if

the woofer speaker is operating properly. If the

TV is not properly installed, no sound will be

heard from the woofer speaker.

Note

The distance between the TV and the wall may

affect how the bass sounds from the woofer

speaker. If you need to adjust the sound quality

(bass frequencies) after installation, change the

distance between the stand and the wall or adjust

the woofer level setting from the TV's menu option.

Refer to the instruction manual of the TV for more

details on adjusting the sound quality.

Adjusting the angle for

easy viewing (Swivel)

The Table-Top Stand can face to the left or right

so that you can obtain the best possible viewing

angle.

For details on the adjustable angle, see

Specifications.

Specifications

When the woofer

When purchased speaker position

is adjusted

Dimensions: mm

A580 580

B360 360

C524 524

D508 593

E110 110

F480 480

G618 703

Weight: kg 15.5

Swivel 15 degrees each to the left and right

(Adjustable angle)

Safety measures to

prevent toppling over

WARNING

Be sure to take measures to prevent the stand from

toppling over.

If you fail to do so, the TV may topple over and

cause injury. Anchor the TV to a wall, pillar, etc., to

prevent it from toppling over.

Prepare a commercially available strong rope or

chain and wall anchor bracket beforehand.

1Secure the wall anchor bracket to a solid wall

or pillar.

2Pass the rope or chain through both holes of

the anchor attachments and then tighten the

other end of the rope or chain to the wall

anchor bracket.

SPEAKER

Speaker unit 10 cm (2)

Impedance 4 Ω

Max. power 50 W

Design and specifications are subject to change without

notice.

Wall anchor bracket

Strong rope

or chain

Printed in Japan

Table des matières

Autres manuels Sony Support et étagère

Sony

Sony SU-PT2M Manuel utilisateur

Sony

Sony SU-RG11S Manuel utilisateur

Sony

Sony SU-WL51 Manuel utilisateur

Sony

Sony Walkman BCR-NWA800 Manuel utilisateur

Sony

Sony SU-RG11M Manuel utilisateur

Sony

Sony SU-52NX1 Manuel utilisateur

Sony

Sony SU-B401S Manuel utilisateur

Sony

Sony XBR-46HX909 - Lcd Panel For Kdl-42xbr950 Tv Manuel utilisateur

Sony

Sony RHT-G550 Manuel utilisateur

Sony

Sony SU-GW3 Manuel utilisateur

Sony

Sony KDL-46EX600 - 46" Bravia Ex Series Hdtv Mode d’emploi

Sony

Sony Operating Instructions SU-EF41 Manuel utilisateur

Sony

Sony WSFV11 Manuel d'utilisation et d'entretien

Sony

Sony PEG-NX80V - Clie Handheld Manuel utilisateur

Sony

Sony SU-B551S Manuel utilisateur

Sony

Sony KDL-32L504 - 32" Class Bravia L Series Lcd... Manuel utilisateur

Sony

Sony STR-DH830 Manuel utilisateur

Sony

Sony PROFORMA WM60 Manuel utilisateur

Sony

Sony MB-532 Manuel utilisateur

Sony

Sony RHT-G5 Manuel utilisateur

Sony

Sony SU-GW11 Manuel utilisateur

Sony

Sony SUFL71M - SU - Stand Manuel utilisateur

Sony

Sony SU-MD1 Instructions d'utilisation et d'entretien

Sony

Sony SU-36HX1 Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur