Sony P41 Manuel utilisateur

Table des matières

Autres manuels Sony Appareil photo numérique

Sony

Sony Alpha DSLR-A350 Manuel utilisateur

Sony

Sony DSC-W310 Manuel utilisateur

Sony

Sony Cyber-shot DSC-TX100V Manuel utilisateur

Sony

Sony CYBER-SHOT DSC-W12 Manuel utilisateur

Sony

Sony DSC-H90 Manuel utilisateur

Sony

Sony DSC-H55 - Cyber-shot Digital Still Camera Manuel utilisateur

Sony

Sony Cyber-Shot DSC-RX10M2 Manuel utilisateur

Sony

Sony a7 III Manuel utilisateur

Sony

Sony Cyber-Shot DSC-P32 Manuel utilisateur

Sony

Sony DSC-S45 - Cyber-shot Digital Still Camera Manuel utilisateur

Sony

Sony Cyber-shot DSC-P30 Manuel utilisateur

Sony

Sony Cyber-shot H50 Manuel utilisateur

Sony

Sony ILCE-3000K Manuel utilisateur

Sony

Sony Cyber-shot DSC-QX30 Manuel utilisateur

Sony

Sony Cyber-Shot DSC-KW1 Manuel utilisateur

Sony

Sony Cyber-shot DSC-W800 Manuel utilisateur

Sony

Sony A390L2LENSKIT Manuel utilisateur

Sony

Sony DSC-F88 - Cyber-shot Digital Still Camera Manuel utilisateur

Sony

Sony Alpha NEX-6 Manuel utilisateur

Sony

Sony SSC-M370 Manuel utilisateur

Sony

Sony Alpha SLT-A99V Manuel utilisateur

Sony

Sony Cyber-shot DSC-S600 Manuel utilisateur

Sony

Sony Cyber-shot DSC-W730 Manuel d'instructions d'installation

Sony

Sony DSC-W370CSD Manuel utilisateur

Manuels Appareil photo numérique populaires d'autres marques

Mercury

Mercury 350K Manuel utilisateur

Pentax

Pentax Optio LS 465 Manuel utilisateur

Sanyo

Sanyo VPC-S1085 Manuel utilisateur

GE

GE SMART A1255 Manuel utilisateur

Point Grey

Point Grey Gazelle Manuel utilisateur

Nikon

Nikon COOLPIX A Manuel utilisateur

Pentax

Pentax P-5 Manuel utilisateur

BlazeVideo

BlazeVideo A280 Manuel utilisateur

ATIK Cameras

ATIK Cameras One Manuel utilisateur

CohuHD Costar

CohuHD Costar 3930 Series Manuel utilisateur

Leica

Leica M10-R Manuel utilisateur

FujiFilm

FujiFilm FinePix A700 Manuel utilisateur

Lorex

Lorex LNZ81P25 Series Manuel utilisateur

GE

GE J1470S Manuel utilisateur

Canon

Canon EOS ELAN7 Manuel utilisateur

Nikon

Nikon Coolpix 100 Manuel utilisateur

Samsung

Samsung SCC-C4253 Manuel utilisateur

JVC

JVC GT-HM890 Manuel utilisateur

Sony P41 modification with external power

www.BFoutdoors.com

Just a reminder I assume no responsibility to any damage that can occur when this modification

is attempt

(Also a

s always modification of commercial products is done at your own risk. Use

extreme caution since high oltage exists within these units

The first thing I will do with either camera is power it on. It is good now before we start to

shutter a few pictures and to double check the cameras operation and focus. Take the batteries

out with camera on lea ing the shutter co er open this way we can disable the shutter motor to

silence the camera.

To open the camera 4 screws must be remo ed

To open the camera pry it open and fold the back o er to the right side Taking care not to pull or

twist the ribbon cable

The shutter co er motor connector it easily unplugs with tweezers lea ing this out after we are

finished will disable the motor and since it was open when we took the batteries out it will stay

in the open position.

The main board and lens assembly will now pry right out of the front shell I lay it back into the

back section again gentle with the ribbons. There is a small more fragile ribbon holding the front

to the main board

First heat the solder iron and tin both the wires and the battery contacts in the camera as shown

Also apply a small amount of solder on the solder pads on the Hagshouse shutter assembly.

Slide the wires through the holes in the cameras plastic frame

I solder the wires to the top edge of the battery contacts then cut the excess wire off and adjust

the wires as tight and close to allow mo ement in the spring of the battery contacts.

Flip the main board back into the front section it takes a little jogging and positioning to get the

main board and the lens assembly back into place

Also getting the hea y wires out of the cam and not pinching those takes patience and care.

Mark the 4 contacts that you can see in the power ribbon onto the white cable block on the main

board. Align to the 4 contacts on the right side.

Once you insert the shutter assembly in the block line the 4 contacts to the lines on the block and

fold it o er onto the main board in a clean straight fold. Twisting or doing this at an angle will

cause the modification to not work when we reassemble the camera

Gently use your finger to press the ribbon back into the block. If you would use too much

pressure you will destroy the fragile contacts in the cable use a wiggling motion side to side

pressure to gently get the cable seated.

Once it has been inserted tape the shutter assembly so it can’t be mo ed.

Also this is a good time to check that the modification was a success.

Remember with tehse shutter assemblys the P is actually the COMMON on a p41 and the C is

actually the POWER

With batteries in the camera short/Jumper between the C pad and the P pad and the camera

should turn on. Then short the P to the S and it should shutter a picture. I use tweezers to do this.

Never connect a power supply or battery to the shutter assembly’s contacts as you will

destroy the camera

Once satisfied that the mod was successful Cover the solder pads with electrical tape.

Now you need to close the camera up. Getting the wires as flat and smooth to the cameras main

circuit board is important and this will allow it to close tightly without pinching any wires.

I cut a small notch in the cameras back for the wires to get out of the camera. I secure the ser o

connector to the bottom of the camera with pt1100 tape and seal the holes and protect the wires

with a dab of goop.