Questions? |Contact the DASH Line
M-F 8:30AM –7:00PM EST
P: 800.654.6061
Test:
Quick Install Guide
Cradlepoint IBR600
FlexIP, iBase & FlexiBase
7
q Central Station must Reset the Panel.
q Remove all other communications from the panel, leaving only the Cellular.
q Send a Test Signal from a keypad. Ensure that Central Station receives this.
q Arm a partition and send an Audio Activation. Ensure the Central Station can hear the audio clearly.
q Central Station must Reset the Panel and confirm that there are no alarms reporting.
q Reconnect all communication paths.
q Log into router via web browser, and save a screenshot of the Status/Dashboard for your records.
Using wired internet through the IBR600 to the iBase:
8
WARNING
While servicing, downloading,
or uploading a Cell equipped
panel, disconnect the
Cradlepoint router so that
data usage does not exceed
the wireless data limit!
8A. Obtain a valid IP address, Gateway, Subnet Mask, and DNS Server from the customer’s network administrator.
iBase ONLY STEP (Not applicable on FlexiBase)
8B. Apply the necessary Cradlepoint configuration file.
1. Unplug the iBase WAN cable from the IBR600 LAN port and
connect your PC in its place.
2. Log into the router:
· Open a web browser on your PC and go to address: 192.168.0.17
· Enter the password: 65535
3. Find the System Settings drop down.
4. Select System Software.
5. In the ‘System Config Save/Restore’ field, select Upload from file
button.
6. Select the Choose File button.
7. Browse your PC for the Cradlepoint® router configuration file,
named: “10 iBase ONLY alternate config Rev C.bin”.
Note: If IP address provided falls within the range of
10.0.0.1 –10.0.127.255 , use the file
”192 iBase ONLY alternate config Rev C.bin”instead.
8. Click the Restore Settings button.
8C. Assign the IP Address to the IBR600
1. In a web browser, go to “192.168.0.17” or “10.0.0.17".
2. Log into the router using the password 65535.
3. Expand the Internet tab, and select Connection Manager.
4. In the WAN Interface area, select Ethernet: Ethernet 1.
5. Select the Edit button.
6. In the WAN Configuration window, select the Ethernet Settings tab.
7. Change the Connection Method drop-down to Static (Manual).
8. Fill in the blank fields using the information provided from the
customer.
Note: If no Primary DNS Server was provided, then use a public DNS
such as: 8.8.8.8.
9. Select the Submit button.
10. Verify successful network connection:
q Go to the Connection Manager window
q Ensure that a green circle is beside Ethernet: Ethernet 1
q Ensure the State column shows Connected.
8D. Test the new WAN connection.
1. Disconnect the RJ-11 dial modem cable from the iBase if connected.
2. Connect the iBase WAN to the IBR600's LAN
3. Connect the wired internet connection to the IBR600's WAN Port (right)
4. Log into router, from Internet>Connection Manager, un-check the enabled checkbox for everything except “Ethernet: Ethernet 1".
(Cell must be disabled to test the wired network).
5. Ensure that your iBase is able to :
6. Restore all communication paths to your panel, including those cell paths that were disabled from the IBR600's web interface.
7. Log into router via web browser, and save a screenshot of the Status/Dashboard for your records.
q Send a Test Signal
q Receive an Options Download
q Arm
q Send Audio for more than 75 seconds continuously
q Accept a Reset Panel command from SonIP
1/13/2015 19810075 Rev A . Cradlepoint IBR600 Quick Guide 3/3
