SOMFY RAINER MAESTRIA 50 RTS Mode d'emploi

FACTORY MODE

BEFORE YOU BEGIN

Motors are shipped in FACTORY MODE without limit settings and the

transmitter ID’s. Power must ONLY be connected to current screen

being programmed. All other screens must be disconnected from their

respective power while programming.

Note - If motor is 120V AC hardwired and cannot be disconnected,

please contact an electrician prior to calling Somfy customer service

for assistance.

UICK PROGRAMMING GUIDE FOR

MAESTRIA™ 50 RTS MOTORS

CONNECT TO POWER MODE

With the motor installed in the screen, connect power to the motor (120V AC).

While programming, screens should not be inactive for longer than 2 minutes

or motor will exit PROGRAMMING MODE.

Side View

50mm motor diameter

INITIATE PROGRAMMING

On the transmitter, press and hold both UP and DOWN

simultaneously until the screen jogs.

CHECK THE DIRECTION OF OPERATION

If hand-held transmitter direction is not properly programmed,

Eolis/Soliris RTS sensor will not function in the manner it was

intended. Damage to the screens and injury may occur as a result.

Check the direction of rotation by pressing UP or DOWN.

If necessary change the direction of rotation by simply

pressing and holding the MY button until the screen jogs.

MAESTRIA™ 50 RTS

MOTORIZATION FOR EXTERIOR SCREENS

UICK PROGRAMMING GUIDE FOR

MAESTRIA™ 50 RTS MOTORS

PROGRAMMING MODE

MANUAL ADJUSTMENT OF THE UPPER END LIMIT AND

THE LOWER END LIMIT

1) Position the screen at the desired UPPER Limit

2) Press MY and DOWN simultaneously:

the screen lowers.

3) Position the screen at the desired

LOWER Limit.

4) Press MY and UP simultaneously:

the screen raises.

5) Press MY until the screen jogs to

validate the end limit setting.

6) Flip the remote over and push the program button

on the back until the screen jogs to finalize the

programming

UICK PROGRAMMING GUIDE FOR

MAESTRIA™ 50 RTS MOTORS

OBSTACLE DETECTION

CHOICE OF THE LEVEL OF DETECTION

his function gives the possibility to adjust the obstacle detection

during the downward movement to deactivate it or adjust the

sensitivity.

1) Starting from the screen in half-way position, press MY and UP brieﬂy and again

MY and UP for 2 seconds. The screen jogs.

ESD level 0: the obstacle detection is more sensitive. The

screen moves up and down slowly.

ESD level 1: (DEFAULT) - the obstacle detection is reliable

on most zip screens. The screen jogs.

The Factory default is OK for Tall Hem Bar (unless narrow

opening).

For short hem bar units, put the motor in more sensitive

mode (ESD level 0).

ESD level 2: the obstacle detection is deactivated. The

screens moves up and down slowly.

3) Press MY for 2 seconds to validate the setting.

The screen jogs.

2 sec.

2) Within 10 seconds press UP or DOWN to change the level of detection.

(without feedback within 10 seconds the actuator goes back to USER MODE.

Go back to Step 1.)

2 sec.

Slow jog

Short jog

Table des matières

Autres manuels SOMFY Moteur

SOMFY

SOMFY J4 1TN Manuel utilisateur

SOMFY

SOMFY Altus RTS Instructions d'utilisation

SOMFY

SOMFY Elite Smart Shades R28 WireFree RTS Mode d'emploi

SOMFY

SOMFY ALTUS 40 RTS Manuel utilisateur

SOMFY

SOMFY Maestria 50 RTS Mode d'emploi

SOMFY

SOMFY LT50 CMO Manuel utilisateur

SOMFY

SOMFY Sonesse 30 DCT Manuel utilisateur

SOMFY

SOMFY Sonesse Utra 50 DC Manuel utilisateur

SOMFY

SOMFY HOME MOTION Roll Up 28 WT Manuel utilisateur

SOMFY

SOMFY LV25 Manuel utilisateur

SOMFY

SOMFY Pergola io Instructions de montage

SOMFY

SOMFY Centreo RTS Manuel utilisateur

SOMFY

SOMFY Sonesse Ultra 50 Manuel utilisateur

SOMFY

SOMFY LT 50 CSI Manuel utilisateur

SOMFY

SOMFY J4 RTS Instructions de montage

SOMFY

SOMFY Orea 60 WT Instructions de montage

SOMFY

SOMFY Oximo WT Manuel utilisateur

SOMFY

SOMFY ILMO WT Manuel d'utilisation

SOMFY

SOMFY Oximo Series Manuel utilisateur

SOMFY

SOMFY Sonesse 40 RS485 Manuel utilisateur

SOMFY

SOMFY Tilt Only 50 WF RTS Manuel utilisateur

SOMFY

SOMFY ILT 2 Manuel utilisateur

SOMFY

SOMFY OXIMO 40 AUTO io Manuel utilisateur

SOMFY

SOMFY Ilmo 40 WT Manuel utilisateur

Manuels Moteur populaires d'autres marques

Rotax

Rotax 125 senior MAX evo Manuel utilisateur

Kohler

Kohler K361 Manuel utilisateur

MTD

MTD OHV Series Manuel utilisateur

Kohler

Kohler COMMAND CH18-745 Manuel utilisateur

Mercury

Mercury D4.2L D-Tronic Manuel utilisateur

Selve

Selve SE Plus-RC Series Manuel utilisateur

Perkins

Perkins 1206E-E66TA Manuel utilisateur

Skov

Skov DA 174 Manuel

Rossi

Rossi TX11 Series Manuel utilisateur

Siemens

Siemens SIMOTICS T-1FW3 Feuille d'instructions

AL-KO

AL-KO PRO 350 Manuel utilisateur

MTU

MTU 12 V 4000 Lx4 Manuel utilisateur

Nanni

Nanni N3.30 Manuel d'instructions

Nanni

Nanni N5.160 CR2 Manuel utilisateur

KSB

KSB SuPreme Series Instructions d'installation

Hiwin

Hiwin EM1 Series Manuel utilisateur

Rotax

Rotax 912 i series Mode d'emploi

Siemens

Siemens SIMOTICS XP 1MB1 Manuel utilisateur