Smeg SE900 Manuel utilisateur

Contents

1INSTRUCTIONS FOR SAFE AND PROPER USE______________________22

2INSTALLATION_________________________________________________24

3DESCRIPTION OF CONTROLS____________________________________27

4USE OF THE OVEN _____________________________________________29

5AVAILABLE ACCESSORIES ______________________________________30

6COOKING HINTS _______________________________________________31

7CLEANING AND MAINTENANCE __________________________________35

8EXTRAORDINARY MAINTENANCE ________________________________37

INSTRUCTIONS FOR THE INSTALLER: these are intended for th

qualified technician who must install the appliance, set it functionin

and carry out an inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice, descriptio

of the commands and the correct procedures for cleaning an

maintenance of the appliance.

Introduction

1 INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND

THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN

ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE

OVEN. WE ADVISE CAREFUL READING OF THIS MANUAL AND ALL

THE INSTRUCTIONS THEREIN BEFORE USING THE OVEN.

INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL

IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS

APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS

TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN

BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING

AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED

IMPROPER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY

FOR IMPROPER USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT.

SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO

THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE.

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE

GROUNDED ACCORDING TO THE METHODS REQUIRED BY SAFETY

RULES.

WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE

THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A

POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS

BEEN BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

DO NOT OBSTRUCT VENTILATION OPENINGS AND HEAT

DISPERSAL SLITS.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF

INSPECTION TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS

BELOW. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT

FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL

ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO”

(OFF) POSITION WHEN YOU FINISH USING THE OVEN.

Introduction

NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD

BE ACCIDENTALLY LIGHTED AND CAUSE FIRES.

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO

TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.

THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER

AND BRAND NAME IS POSITIONED VISIBLY ON THE OVEN DOOR

FRAME.

THE PLATE MUST NOT BE REMOVED.

THE OVEN IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW

CHILDREN TO GO NEAR OR PLAY WITH IT.

REPLACED APPLIANCES MUST BE TAKEN TO A SPECIAL GARBAGE

COLLECTION CENTRE.

The manufacturer declines all responsibility for damage to persons o

things caused by non-observance of the above prescriptions or b

interference with any part of the appliance or by the use of non-origina

spares.

Instructions for the installer

2 INSTALLATION

2.1 Electrical connection

Check that mains voltage and power cable ratings are as per the

indications provided on the label attached to the oven door frame.

This label must never be removed.

It is obligatory for the electrical system to be grounded according to the

methods required by safety rules.

If a plug and socket connection is being used make sure that the plug

and socket are compatible. Avoid use of adapters and shunts as these

could cause overheating and risk of burns.

If a fixed connection is being used fit power line with an omnipolar circuit

breaker with a contact opening gap equal to or greater than 3 mm in an

easily accessible position in proximity to the oven.

Remove rear cover by loosening relevant screws to gain access to the

terminal strip. Secure power cable to oven by means of the appropriate

fitting.

If the power cable is replaced, the wire

section on the new cable must not be

less than 1.5 mm2(3 x 1.5 cable),

keeping in mind that the end to be

connected to the hob must have the

ground wire (yellow-

reen) longer by

at least 20 mm.

The manufacturer declines all responsibility for damage to person

or things caused by non-observance of the above prescriptions or b

interference with any part of the appliance.

Instructions for the installer

2.2 Mounting the oven

The oven is designed for mounting into any piece of furniture as long as

heat-resistant. Proceed according to the dimensions shown in Figures 1,

2 and 3. For installing under a work top, follow the dimensions given in

Figure 1-3. For installing under a work top with combined heating plates,

ensure a minimum clearance from any side walls of at least 110 mm as

shown in Figure 1.

For installing in a column, follow the dimensions given in Figure 1-2

allowing for a clearance of 80 to 90 mm at the top and sides of the

column. Tighten the four screws A inside the frame to secure (Fig. 1).

For installing beneath a non-integrated top, allow for a rear and bottom

clearance as shown in Figure 1 (ref. B). See relevant instructions for

fitting and securing the cook top.

Instructions for the installer

Never use the oven door to lever the oven into plac

when fitting.

Avoid exerting too much pressure on the oven doo

when open.

Never use the oven door handle to move th

appliance.

Instructions for the user

3 DESCRIPTION OF CONTROLS

3.1 Front control panel

All the oven controls are grouped together on the front panel.

FUNCTION SWITCH KNOB

Ruotare la manopola in uno dei due sensi per

scegliere una funzione tra le seguenti:

NO FUNCTION SET

UPPER AND LOWER

HEATING ELEMENT LOWER HEATING

ELEMENT + VENTILATED

HEATING ELEMENT

GRILL ELEMENT UPPER AND LOWER

HEATING ELEMENT +

VENTILATION

WIDE GRILL

ELEMENT DEFROSTING

GRILL ELEMENT +

VENTILATION VENTILATED

HEATING ELEMENT

THERMOSTAT KNOB

Cooking temperature is selected by turning the

knob clockwise to the desired setting, between 50°

and 250°C.

THERMOSTAT INDICATOR LIGHT (ORANGE)

When this light comes on, the oven is heating up.

When this light goes out, the preset heating temperature

has been reached.

When the light flashes, the temperature inside the oven is

steady at the set temperature.

Instructions for the user

FUNCTION PILOT LIGHT (BLUE/RED)

When on, indicates that the function selector knob has been

set on any one of the functions and that the oven is

receiving power. However, to start cooking the thermostat

knob also has to be turned until the relative pilot light comes

on.

3.2 Clock + timer with end of cooking

Permits to select manual cooking or to set timer and cooking time.

Always rotate the small knob A ANTICLOCKWISE.

Select function and cooking temperature before setting cooking time.

3.2.1 Adjusting the clock

To adjust to correct time, PULL and rotate the small knob A clockwise.

3.2.2 Manual cooking

For manual cooking, rotate small knob A clockwise until pointer is

aligned with .

3.2.3 Setting cooking time

To set cooking time, rotate small knob A clockwise to the desired length

of time (maximum 90 minutes).

3.2.4 End of cooking

At end of cooking the oven turns off automatically and the alarm starts

sounding.

3.2.5 Muting the alarm

To mute the alarm turn small knob A anticlockwise until pointer is

aligned with .

Instructions for the user

4 USE OF THE OVEN

Before using the oven make sure that all procedures described in point

“3.2.2 Manual cooking” have been carried out.

4.1 Warnings and general advice

Before using the oven for the first time, pre-heat it to maximum

temperature (250°C) long enough to burn any manufacturing oily

residues which could give the food a bad taste.

During cooking, do not cover the bottom of the oven with aluminium o

tin foil and do not place pans or oven trays on it as this may damage th

enamel coating. If you wish to use greaseproof paper, place it so that i

will not interfere with the hot air circulation inside the oven.

To prevent any steam in the oven creatin

problems, open the door in two stages: half ope

(5 cm approx.) for 4-5 seconds and then full

open. To access food, always leave the doo

open as short a time as possible to prevent th

temperature in the oven from falling and ruinin

the food.

4.2 Cooling system

The oven is equipped with a cooling system

which automatically comes on upon the oven

being turned on.

Fans cause a steady outflow of air from above

the door which may continue for a brief period of

time even after the oven has been turned off.

4.3 Oven light

the inside oven light may be turned on by simultaneously rotating the

function selector knob and the timer knob.

When the oven is not working, the light comes on by simply opening the

door.

Instructions for the user

5 AVAILABLE ACCESSORIES

The oven features 4 support positions for plates

and racks of different height.

Grill: useful for holding cooking vessels.

Plate grill: for placing above plate for cooking foods

that might drip.

Oven plate: useful for catching fat from foods on the

grill above.

Pastry plate: for baking cakes, pizza and oven

desserts.

Roof liner/Grill guard: removing this simplifies

cleaning procedures inside the oven.

Chromium-plated tubular gripper for removing hot

racks and plates from the oven.

Accessories available on request

Original accessories may be ordered from any Authorised Servic

Centre.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Smeg Four

Smeg

Smeg Oven Manuel utilisateur

Smeg

Smeg ALFA31XE Manuel utilisateur

Smeg

Smeg 3961I Instructions de montage

Smeg

Smeg LEV 31RU Instructions de montage

Smeg

Smeg Linear SAP112-8 Manuel utilisateur

Smeg

Smeg C9CMXA1 Manuel utilisateur

Smeg

Smeg S300X Manuel utilisateur

Smeg

Smeg Classica SF6302GVK Manuel utilisateur

Smeg

Smeg SCT109-8 Manuel utilisateur

Smeg

Smeg SY92IPX8 Manuel utilisateur

Smeg

Smeg SF4920MCX1 Manuel utilisateur

Smeg

Smeg SFA304X Manuel utilisateur

Smeg

Smeg SA704X-5 Manuel utilisateur

Smeg

Smeg F65-7 Manuel utilisateur

Smeg

Smeg SA304X-8 Manuel utilisateur

Smeg

Smeg SFPA6300TVX Manuel utilisateur

Smeg

Smeg Oven APL360XC Manuel utilisateur

Smeg

Smeg Cortina SF4750VC Manuel utilisateur

Smeg

Smeg SF700PO Manuel utilisateur

Smeg

Smeg S1055MF-5 Manuel utilisateur

Smeg

Smeg Oven ALFA41XE2 Manuel utilisateur

Smeg

Smeg SFA4603MCNX Manuel utilisateur

Smeg

Smeg SOPA6102TS Manuel utilisateur

Smeg

Smeg SA304X-8 Manuel utilisateur

Manuels Four populaires d'autres marques

Bosch

Bosch HVA531NS0 Manuel utilisateur

Electrolux

Electrolux EOF6P46X Manuel utilisateur

NEFF

NEFF B44S32 5GB Series Manuel utilisateur

Combi

Combi BLODGETT BC142GDS Manuel utilisateur

AEG

AEG COMPETENCE 311704300 Manuel utilisateur

Falcon

Falcon DOMINATOR PLUS G3106 Series Guide de l'utilisateur

Rational

Rational SCC WE 61G Manuel utilisateur

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manuel utilisateur

Miele

Miele HR 1954-2 Manuel utilisateur

KHIND

KHIND OT50 Manuel utilisateur

Henny Penny

Henny Penny Smoker Box Manuel utilisateur

Lang

Lang ECOD-AP Manuel utilisateur

AEG

AEG BEK455310M Manuel utilisateur

Frigidaire

Frigidaire FNGE90JGR Manuel utilisateur

Hotpoint

Hotpoint FE9 S831 JSH IX Manuel utilisateur

GE Advantium SCB2000 Manuel utilisateur

AEG

AEG DE401301DM Manuel utilisateur

DeLonghi

DeLonghi XA660 Manuel