Simrad RF40 Manuel utilisateur

| 1

RF40 Rudder Feedback unit

Installation guide

The RF40 is a resistive rudder feedback unit, suitable for autopilot systems with a

NAC-1 or NAC-2 autopilot computer.

¼Note: The RF40 can not be used with the NAC-3 autopilot computer.

The RF40 might also be used with autopilot computers that have analog rudder

feedback input.

¼Note: Do not remove the transmitter lever from the feedback unit.

¼Note: The unit is factory adjusted and requires no further adjustment at

installation than described below.

Mounting location

The RF40 unit (A) mounts close to the rudder, and is mechanically linked to the

rudder tiller arm (B) or rudder quadrant.

Select a mounting location for the RF40 unit according to the illustration

• X1 = X2: min 150 mm (5.9”), max 345 mm (13.6”)

• Y1 = Y2: min 44 mm (1.7”), max 130 mm (5.1”)

Y1 Y2

X1 = X2

Y1 = Y2

2 |

Installation

The RF40 lever (C) has two slots for the transmitter link (D). The slots enable

maximum exibility to provide the 1:1 mechanical linkage relationship.

Y1 Y2

1. Turn the helm to set the rudder tiller arm (B) to approximate center position

2. Mount the RF40 unit to a suitable platform

• If required:

-add blocking material under the RF40 to adjust the height of the

transmitter lever to be level with the rudder tiller arm

-cut the length of the transmitter rod (D) to move the feedback unit closer

to the rudder post

3. Rotate the RF40 lever to center position

• the marks (E) on unit and on the lever should be aligned

4. Rotate the RF40 unit so that the rudder lever is parallel with the rudder tiller arm

5. Set the transmitter link to the inner limit of the outer slot if possible

6. Drill and tap the rudder tiller arm so that the Y2 dimension is equal to the Y1

dimension

7. Attach the ball joint to the tiller arm, and connect the transmitter rod to the ball

joint at the rudder tiller arm

8. Tighten the mounting screws for both the RF40 and the transmitter rod ball

joint.

9. Observe the feedback unit while someone turns the helm through the complete

rudder travel hard-over to hard-over, and verify that the mechanical linkage

moves freely.

| 3

Wiring

The RF40 is equipped with a 15 m (49 feet) cable with connector (A). The unit

connects to the NAC-1/NAC-2 autopilot computer’s three pins rudder feedback

socket (B).

A B

1 2

Function Color

1+5 V DC Red

2Signal Yellow

3-0 V DC Black

Dimensional drawings

RF40

177 mm (6.97”)

55 mm

(2.16”)

99 mm (3.90”)

65 mm

(2.56”)

Transmitter link

345 mm (13.6”)

4 |

Spare part

20193454 Transmitter link

Technical specications

¼Note: The most up-to-date specications list is available at

www.simrad-yachting.com

Physical

Dimensions See gure

Weight 0.5 kg (1.1 lbs.)

Material Arnite T06 200 PBT

Compass safe distance 1.0 m (3.1 ft.)

Mounting Horizontal, vertical or upside down

Cable 15 m (49 feet) with connector

Transmitter link Stainless 345 mm (13.6”) with 2 ball joints

Electrical

Supply voltage 5 V DC

Power consumption 2.5 mW

Environmental

Operating temperature -25 to +55 °C (–13 to +130 °F)

Storage temperature -30 to +70 °C (–22 to + 158 °F)

Waterproof rating IP56

Interface

Rudder angle +/-120 degrees

Output signal 0 - 5 V DC

Resistance value 10 K ohms

Accuracy +/-0.25° within +/-5°, otherwise +/-0.5°

Repeatability +/-0.1°

*988-12045-001*

Table des matières

Autres manuels Simrad Équipement marin

Simrad

Simrad ITI Manuel utilisateur

Simrad

Simrad IS42J Manuel utilisateur

Simrad

Simrad Mercury Manuel utilisateur

Simrad

Simrad ITI - INSTALLATION REV C Manuel utilisateur

Simrad

Simrad SD1 Instructions d'utilisation et d'entretien

Simrad

Simrad ITI TRAWL SYSTEM - SERIAL DATA COMMUNICATION REV... Manuel utilisateur

Simrad

Simrad Navico WP10 Manuel utilisateur

Simrad

Simrad ES60 - DATASHEET REV A Mode d’emploi

Simrad

Simrad RS25-E Manuel utilisateur

Simrad

Simrad AP70 Manuel utilisateur

Simrad

Simrad IS42J Manuel utilisateur

Simrad

Simrad IS20 Combi Manuel utilisateur

Simrad

Simrad ES60 - REFERENCE MANUAL REV H Manuel utilisateur

Simrad

Simrad GO XSE Series Manuel utilisateur

Simrad

Simrad ES70 - DOWNLOAD AND INSTALLATION REV B Manuel utilisateur

Simrad

Simrad ES70 - REV A Manuel utilisateur

Simrad

Simrad NSO evo3S MPU Manuel utilisateur

Simrad

Simrad EK80 Manuel utilisateur

Simrad

Simrad GC80 Compact MK2 Manuel utilisateur

Simrad

Simrad ITI Manuel utilisateur

Simrad

Simrad EK15 Manuel utilisateur

Simrad

Simrad BSM-3 Manuel utilisateur

Simrad

Simrad CS90 Manuel utilisateur

Simrad

Simrad ITI TRAWL EYE - REV D Manuel utilisateur

Manuels Équipement marin populaires d'autres marques

Clarion

Clarion CMS2 Manuel de réparation

EBS

EBS M7000 Manuel utilisateur

Kongsberg

Kongsberg M3 Bathy Manuel utilisateur

NPK

NPK SCS-1002 Manuel utilisateur

Furuno

Furuno FE-800 Manuel utilisateur

Harken

Harken 1561 Manuel utilisateur

Notifier

Notifier FS-BSO Manuel utilisateur

Raymarine

Raymarine ST40 Manuel utilisateur

E2S

E2S E2XS112UL Manuel utilisateur

R2Sonic

R2Sonic 2026 Manuel utilisateur

COBHAM

COBHAM SAILOR 6000 Manuel utilisateur

Clarion

Clarion GR10BT Manuel de réparation

Raymarine

Raymarine Maxiview ST80 Guide de l'utilisateur

GUIDANCE MARINE

GUIDANCE MARINE 20- Series Instructions de montage

Raymarine

Raymarine ST60 Tridata Guide de l'utilisateur

olympia electronics

olympia electronics ΒS-531/1/MAR Manuel utilisateur

Sonic

Sonic 2024 Manuel utilisateur

Quicksilver

Quicksilver 88688A25 Manuel