
www.simonds-inc.com
WARRANTY
Simonds Inc. power packs and jaws are warrantied to be free from defects in materials and
workmanship for a period of one year, barring alterations, abuse or misuse. All products re-
turned for warranty repair must be sent to Simonds Inc., Southbridge, MA at end users ex-
pense. Simonds will either repair or replace the tool if it is found defective due to material de-
fect or workmanship at Simonds discretion.
Warranty repairs accepted only through distributors with proper RMA’s.
SAFETY INSTRUCTIONS
• Inspect tools and hoses each day prior to operation. Air hose that is frayed, cut or abraded should
be replaced. Be sure that threads are clean and not worn.
• If the tool is not in use and not positively disconnected from the energy supply, the energy supply
system must facilitate isolation and dissipation of pressure by a suitable and lockable shutoff
device in order to prevent unexpected start-up.
• Beware of hair, fingers, ties, loose clothing etc. when operating the tool. Keep away from moving
parts.
• Always wear eye protection when operating the tool. Beware of ejection of cuttings or chips. Turn
head to avoid being exposed to this operation.
• Beware that working on brittle material may cause harmful splinters.
• Always disconnect from air supply when changing tool, during repair, adjusting and inserting tools,
maintenance and cleaning operations.
• Simonds tools are not designed for use in explosive atmospheres.
• Simonds tools are not insulated for coming in to contact with electric power sources.
• Do not use tools near personnel where risk of flying debris may hit them.
• Do not point or aim tool at another person.
• Unsecured or cut air hose may cause a whipping action which may result in injury.
• Do not use any attachments not manufactured by Simonds for this tool. Injury may result.
• If the tool is used on a bench stand or a work station be sure that the tool is fastened properly.
• Dispose of tool and material as recommended by local disposal regulations.
• Simonds tools are not for use other than on production line. Tool should not be used as a hammer
or pry bar. A “two hand control” may be required depending on the attached tool.
• DO NOT EXCEED RECOMMENDED WIRE SIZE OR AIR PRESSURE. Exceeding the
recommended wire size for the jaws may cause damage to tool or injury to user.