Page 10 Page 11
Now that you’ve successfully soldered down your
first SMD component, use the same method to
place and solder the following components.
10uF Capacitor
MBRA140 Diode
22uH Inductor
10
12
11
10uF Capacitor To help you find this part in your kit, the capacitor
is labeled with a red marker. The white end of the capacitor
should point towards the rounded end on the PCB’s silkscreen.
MBRA140 Diode To help you find this part in your kit, the diode
is labeled with a yellow marker. Before soldering, double-check
that the white line on the diode matches the line on the PCB’s
silkscreen. The white line is similar to the line on the 10uF
capacitor in step 10.
22uH Inductor Make sure the inductor remains inside its white
outline after you’ve soldered both legs.
BOTTOM OF BOARD
CONTINUE WITH THE BOTTOM OF THE BOARD [ STEPS 10 T0 16 ]
Remember, components highlighted yellow are polarized.
