Siemens HMS-S Manuel utilisateur

Siemens Building Technologies

Fire Safety

P/N 315-033200-2

INTRODUCTION The SIEMENS Model HMS-S and HMS-D Manual

Stations a e add essable devices containing advanced

cont ol panel communication technology. This technol-

ogy, which p ovides two-di ection communication with

the cont ol panel, p oduces an Intelligent Initiating

Device. The HMS-S is single action; the HMS-D is

double action.

PROGRAMMING Refe to Figu e 1 to locate the opening on the HMS cove that allows access to the

p og amming holes which a e on the HMS p inted ci cuit boa d.

To connect the HMS to the DPU P og amme /Teste , inse t the plug f om the DPU

cable p ovided with the P og amme /Teste into the opening on the HMS as shown

in Figu e 2. Because HMS devices a e pola ity insensi-

tive, the p og amming plug can be inse ted into the

p og amming holes in eithe di ection.

To prevent potential damage to the DPU DO NOT

connect an HMS to the DPU until at least one wire is

removed from terminals 1 or 2 of the HMS.

Follow the inst uctions in the DPU Manual

(P/N 315-033260) to p og am the HMS to the desi ed

add ess. Reco d the device add ess on the label

located on the HMS f ont panel. The HMS can now

be installed and wi ed to the system.

OPERATION The HMS-S and HMS-D manual stations ope ate with the Fi eFinde -XLS Cont ol

Panel via the DLC Device Loop Ca d.

The HMS-S and HMS-D manual station housings have a pull down leve that locks in

position afte eleasing a sp ing loaded switch. (See Figu e 4.) To indicate the manual

station is activated, the pull down leve emains down and locked until the station is

physically eset.

The HMS-D has an additional leve labeled PUSH IN which must be ope ated fi st.

Both models a e eset by opening the hinged housing cove with an Allen key and

then closing and locking the cove .

Figure 1

HMS Cover

Single/Dual Action Manual Pull Station

Installation Instructions

Models HMS-S / HMS-D

OPENING TO

PROGRAMMING

POINTS

PLUG FROM

DPU

LOCATING TAB

PROGRAMMING

POINTS

Figure 2

Connecting the DPU Plug

INSTRUCTIONS

WIRING

INSTALLATION Dist ibute the manual station boxes th oughout the p otected a ea so that they

a e unobst ucted, eadily accessible, and located in the no mal exit path. Place the

manual station acco ding to the egulations of the autho ities having ju isdiction.

Su face Mounting Mount the backplate to a SIEMENS Model SB-5R Backbox as shown in Figu e 4.

Flush Mounting Mount the backplate to a use supplied single gang switchbox.

Do not overtighten the screws. Overtightening ma distort the backplate.

Figure 4

Mounting The HMS

Figure 3

Wiring Inform tion

TO NEXT ADDRESSABLE DEVICE

DLC LINE 1

DLC 1LINE

DLC 2LINE

EARTH GROUND

FROM INITIATING CONTROL PANEL

OR PREVIOUS ADDRESSABLE DEVICE

NOTES:

1. Recommended wire sizes:

18 AWG minimum, 14 AWG maximum

2. Wire larger than 14 AWG can damage the connector.

3. When using shielded cable without metal raceway or with nonmetallic

raceway, the shields should e terminated at the device ground

terminal. If the device ox is already grounded y another means, such as

eing mounted to a grounded structure, the wire shields should e

continuous and must e grounded solely at the point of origin; for

example, at the control panel.

4. When using shielded cable with metal raceway, the wiring shields shall

e continuous and grounded solely at the point of origin. The device

ground terminal shall e connected to the grounded device ox.

5. When using metal raceway without shielded cable, connect the device

ground terminal to the grounded device ox.

6. Metal raceway should e thoroughly grounded throughout the system.

7. In supervisory: HMS-S and HMS-D draw 1mA.

8. The HMS-S and HMS-D are polarity insensitive devices. Line 1 and Line 2

can e either line of the loop.

Siemens Building Technologies, Inc.

8 Fernwood Road

Florham Park, New Jersey 07932

Siemens Building Technologies

Fire Safety

Siemens Building Technologies, Ltd.

2 Kenview Boulevard

Brampton, Ontario L6T 5E4 CN

P/N 315-033200-2

3½ INCH DEEP

SWITCH BOX

(USER SUPPLIED)

MODEL

SB-5R

BACKPLATE

SURFACE

MOUNTING

ENCLOSURE

FLUSH

MOUNTING

ENCLOSURE

HOUSING HINGED

TO BACKPLATE

HOUSING

LOCKING

SCREW

5½ in.

3 in.

4 in.

2¾ in.

3½ in.

NAMEPLATE

Ce manuel convient aux modèles suivants

Autres manuels Siemens Système de sécurité

Siemens

Siemens CERBERUS PYROTRONICS ADB-3 Manuel utilisateur

Siemens

Siemens SINAMICS S120 Manuel utilisateur

Siemens

Siemens IGS6-10 Manuel utilisateur

Siemens

Siemens PCA2005-A1 Manuel utilisateur

Siemens

Siemens milltronics MFA 4P Manuel utilisateur

Siemens

Siemens FT2009-U1 Manuel utilisateur

Siemens

Siemens Cerberus PACE Compact Manuel de service

Siemens

Siemens Cerberus PACE Mode d’emploi

Siemens

Siemens FDM275 Mode d’emploi

Siemens

Siemens IC60 Manuel utilisateur

Siemens

Siemens IMKW6-10 Manuel utilisateur

Siemens

Siemens HFPO-11 Manuel utilisateur

Siemens

Siemens 3SX3235 Manuel utilisateur

Siemens

Siemens Sensor Light Manuel utilisateur

Siemens

Siemens NCC-G16 Manuel utilisateur

Siemens

Siemens FDS221-W Manuel utilisateur

Siemens

Siemens Cerberus PACE Manuel utilisateur

Siemens

Siemens SIRIUS 8WD42 Manuel utilisateur

Siemens

Siemens FXS901 Manuel utilisateur

Siemens

Siemens RB-6 L-801A Manuel utilisateur

Siemens

Siemens CP-48 Mode d’emploi

Siemens

Siemens WAC 12 Manuel utilisateur

Siemens

Siemens FDM225 Manuel utilisateur

Siemens

Siemens FS20 Mode d'emploi

Manuels Système de sécurité populaires d'autres marques

Inner Range

Inner Range Concept 2000 Manuel utilisateur

Climax

Climax Mobile Lite R32 Instructions de montage

CADDX

CADDX NX-6 Manuel utilisateur

FBII

FBII XL-31 Series Manuel utilisateur

Johnson Controls

Johnson Controls PENN Connected PC10 Manuel utilisateur

Aeotec

Aeotec Siren Gen5 Manuel utilisateur

Blaupunkt

Blaupunkt SA 2700 Manuel utilisateur

IDEAL

IDEAL Accenta Manuel du propriétaire

AJAX

AJAX DoubleButton Manuel utilisateur

Swann

Swann SW-P-MC2 Manuel utilisateur

Ecolink

Ecolink Siren+Chime Manuel utilisateur

Digital Monitoring Products

Digital Monitoring Products XR150 Manuel utilisateur

EDM

EDM Solution 6+6 Wireless-AE Manuel utilisateur

Highway Safety Group

Highway Safety Group EA401 Manuel utilisateur

Siren

Siren LED GSM Manuel utilisateur

Detection Systems

Detection Systems 7090i Instructions de montage

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manuel utilisateur

DSC

DSC PC 4010 Manuel du propriétaire