8
DESCRIPTION OF DISPLAY ELEMENTS
Tank1 / Tank2 / Tank3 / Tank4
Trek can support up-to 4 tank sensors and can be set-up as fresh water and/or waste water
tanks. By default, only Tank 1 and Tank 2 are set-up, as fresh water tanks. These indicate the
approximate water level in each of the tanks.
Fresh water tank
When the tank is installed and set-up as a fresh water tank, all 4 level segments are shown
when the tank is full.
Only the bottom level segment ashes and the other segments are not shown when the tank is
nearing empty or empty.
If a tank is not installed, that particular tank indicator will have no level segments shown.
Waste Water Tank
Water tanks can be set as waste water tanks, refer to the Water Tank Menu.
When a tank is set-up as waste water tank, all 4 level segments are shown and will be ashing
if the tank is full. When empty, only the bottom level segment is shown.
Pump Status Indicator
These indicators show if the pumps installed are on or off. This is controlled by the pump
button .
Solar Charge Current
This is the current that is drawn when the solar charger in BatteryPlus35 is active.
Aux Charge Current
Refers to the current that is drawn when the Aux in BatteryPlus35 is active.
Battery Charge State
A multi-segmented bar graph showing the state of charge of the battery. Below the bar graph
is displayed the word “CHARGING” or “DISCHARGING” according to the charging state of the
battery.
Time Remaining
Indicates the estimated time remaining for the battery to be charged to full or, discharged to
empty, assuming it continues to charge/discharge at the current rate. If the remaining time is
greater than 199 hours, the display shows “>199 HRS” and the battery is neither charging nor
discharging, the display is blank.
Set-up Mode Indicators
These indicators only appear when Trek is in set-up mode. The icons indicate the functions of
the buttons adjacent to it. The icons include edit, back, and symbol.
1
2
6
5
7
12
4
8
3
16
