SenTech GigE Fiche technique
1/6
Sentech GigE Vision Camera
Technical Notes GigE01: Load the Factory Default Rev.1.00
Sentech GigE Vision Camera
Technical Note:
The procedure to load the factory setting
Sensor Technology Co., Ltd
2/6
Sentech GigE Vision Camera
Technical Notes GigE01: Load the Factory Default Rev.1.00
Introduction:
This technical note mentions how to load the factory setting on Sentech GigE camera. This procedure
support on GigE Standard model (STC-GE/GEC),GigE PoE model (STC-SC/SB**POE),GigE PoE
High Speed Model (STC-SC/SB**POEHS) and PowerPlus Model.
3/6
Sentech GigE Vision Camera
Technical Notes GigE01: Load the Factory Default Rev.1.00
1 The Procedure for Loading Factory Default
1) Connect the FPGA uploading GigE Vision camera, and then power-on the camera.
2) Setup the camera with StGigE Player after rebooting the camera.
3) Connect the camera by selecting the “Select/Connect” button.
4) Select “GigE Device control” after connecting the camera.
4/6
Sentech GigE Vision Camera
Technical Notes GigE01: Load the Factory Default Rev.1.00
5) Change the setting with “GigE Device control” window.
A) Make sure “UserSetSelector” is on “Default”.Select. Then select the “UserSetLoad” and click the
“UserSetLoad” button on the right side of this box.
B) Select “UserSet1” on UserSetSelector.
C) Click ` UserSetSave ` button on “UserSetSave”.
D) if “UserSetDefaultSelector” is not “UserSet1”. Please change to “UserSet1”.
5/6
Sentech GigE Vision Camera
Technical Notes GigE01: Load the Factory Default Rev.1.00
A) Click below area at “GigE Device Control” window before close “GigE Device Control” window. The camera
may not work correctly if close “GigE Device Control” without click.
6) Changed statuses are shown in the window below. . And close this window. Factory setting have already been
loaded.
6/6
Sentech GigE Vision Camera
Technical Notes GigE01: Load the Factory Default Rev.1.00
Revision History
Rev
Date
Changes
Note
1.00
2013/01/25
New document
Sensor Technology Co., Ltd
7F, Harada center building
9-17, Naka cho 4 chome
Atsugi-city, Kanagawa
243-0018 Japan
TEL 81-46-295-7061 FAX 81-46-295-7066
URL http://www.sentech.co.jp/
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels SenTech Appareil photo numérique
SenTech
SenTech STC-MCA5MUSB3 Manuel utilisateur
SenTech
SenTech STC-CMC120ACXP Manuel utilisateur
SenTech
SenTech STC-CMB2MCL Instructions d'installation
SenTech
SenTech Line Scan Series Instructions d'installation
SenTech
SenTech STC-CMB401ACXP Instructions d'installation
SenTech
SenTech STC-MBS510U3V Instructions d'installation
SenTech
SenTech GigE Vision Manuel utilisateur
SenTech
SenTech CL Series Instructions d'installation
