2
GATE WARNINGS AND PRECAUTIONS
The first thing to check is that the gate is in good running order:
A - The gate is rigid and straight and runs smoothly throughout its travel
B - The length of each leaf must comply with max. length indicated on technical specifications of the model
C - The weight of each leaf must comply with max. weight indicated on technical specifications of the model
D - The hinges are hardly anchored and are able to support the torque of the operator; they do not have irregular
movements and/or any friction during the whole movement of the leaf.
- SEA operators have been designed for the automation of gates for vehicles use only
Be aware to avoid the crossing of the gate path because it is very dangerous for pedestrians
- Install the warning signs on each side of the gate and in avisible zone to inform the pedestrians
about the danger they run when passing or resting in the environment of the gate
- For more safety SEA advises to install infrared photocells
GENERAL NOTICE FOR THE INSTALLER AND THE USER
INSTALL THE OPERATOR IN THE CORRECT POSITION DO NOT INSTALL THE FRONT BRACKET IN A WEAK PART
NOT FOR PEDESTRIAN OPENING! INSTALL THE WARNING SIGNS!
KEEP CONTROLS AWAY!
MAX. WIDTH: 100 mm
Italiano
ENGLISH
International registered trademark n. 804888
1. Read carefully these Instructions before installing the product. Store these instructions for future reference
2. Don’t waste product packaging materials and /or circuits.
3. This product was designed and built strictly for the use indicated. Any other use could compromise the condition and
the operation of the product or be a source of danger. SEA S.p.A. declines all liability caused by improper or different use
in respect to the intended one.
4. The mechanical parts must be comply with: Machine Regulation 2006/42/CE and following adjustments, Low Tension
(2006/95/CE), Electromgnetic Consistency (2004/108/CE). Installation must respect Directives: EN12453 and
EN12445.
5. Do not install the equipment in an explosive atmosphere.
6. SEA S.p.A. is not responsible for failure to observe Good Techniques in the construction of the locking elements to
motorize, or for any deformation that may occur during use.
7. Before attempting any job on the system, cut out electrical power and disconnect the batteries. Be sure that the
earthing system is perfectly constructed, and connect it metal parts of the lock.
8. Use of the indicator-light is recommended for every system, as well as a warning sign well-fixed to the frame structure.
9. SEA S.p.A. declines all liability concerning system security and efficiency, if components used are not produced by SEA
10. For maintenance, strictly use original parts by SEA.
11. Do not modify in any way the components of the automated system.
12. The installer shall supply all information concerning system’s manual functioning in case of emergency, and shall
hand over to the user the warnings handbook supplied with the product.
13. Do not allow children or adults to stay near the product while it is operating. The application cannot be used by children,
by people with reduced physical, mental or sensorial capacity, or by people without experience or necessary training.
Keep remote controls or other pulse generators away from children to prevent involuntary activation of the system
14. Transit through the leaves is allowed only when the gate is fully open.
15. The User must not attempt to repair or to take direct action on the system and must solely contact qualified SEA
personnel or SEA service centers. User can apply only the manual function of emergency.
16. The power cables maximum length between the control unit and motors should not be greater than 10 m. Use cables
2
with 2,5 mm section. Use double insulation cable (cable sheath) close to the terminals, in particular for the 230V cable.
Keep an adequate distance (at least 2.5 mm in air), between low voltage (230V) cables and safety low voltage cables
(SELV) or use an appropriate sheath that provides extra insulation having a thickness of 1 mm
