Schweitzer Engineering Laboratories SEL-2245-4 Manuel utilisateur

Schweitzer Engineering Laboratories, Inc. SEL-2245-4 Data Sheet

The SEL-2245-4 provides ac metering inputs for the SEL Axion®. Within an Axion node, install as many as sixteen

SEL-2245-4 modules per system in any combination you want.

Front Panel

Figure 1 SEL-2245-4 AC Metering Module

Mechanical Installation

Each SEL-2242 chassis/backplane has four or ten slots,

labeled A–J. Slots B–Jsupport the SEL-2245-4 modules.

Figure 2 Notch for Module Alignment

To install an SEL-2245-4 module, tip the top of the

module away from the chassis, align the notch on the

bottom of the module (shown in Figure 2) with the slot

you want on the chassis, and place the module on the

bottom lip of the chassis as Figure 3 illustrates. The

module is aligned properly when it rests entirely on the

lip of the chassis.

i6316a

SEL-2245-4 AC Metering Module

SEL-2245-4 Data Sheet Schweitzer Engineering Laboratories, Inc.

Figure 3 Proper Module Placement

Next, carefully rotate the module into the chassis,

making sure that the alignment tab fits into the

corresponding slot at the top of the chassis (refer to

Figure 4). Finally, press the module firmly into the

chassis and tighten the chassis retaining screw.

Figure 4 Final Module Alignment

Input Connections

The SEL-2245-4 CT/PT analog inputs include a dot next

to the terminal number to indicate the positive

convention. Refer to Specifications for ac analog input

ratings and to Figure 5 for terminal assignments. You can

configure potential transformer (PT) inputs for 5–400 V

and current transformer (CT) inputs for 0–22 A.

Configure inputs by adding a Fieldbus I/O connection for

each module in ACSELERATOR RTAC®SEL-5033

Software. See the EtherCAT®portion in Section 2:

Communications in the SEL-5033 Software Instruction

Manual for details.

Figure 5 CT/PT Analog Inputs

LED Indicators

The LEDs labeled ENABLED and ALARM are related to

EtherCAT network operation. The green ENABLED LED

illuminates when the module is operating normally on

the network. The ALARM LED illuminates during network

initialization or when there is a problem with the

network.

CAUTION

Use supply wires suitable for 60°C (140°F) above ambient. See product

or manual for ratings.

ATTENTION

Utilisez des fils d'alimentation appropriés pour 60°C (140°F) au-dessus

ambiante. Voir le produit ou le manuel pour les valeurs nominales.

i6316a

Schweitzer Engineering Laboratories, Inc. SEL-2245-4 Data Sheet

Specifications

Compliance

Designed and manufactured under an ISO 9001 certified quality

management system

UL Listed to U.S. and Canadian safety standards (File E220228;

NRAQ, NRAQ7)

CE Mark

General

Operating Temperature Range:

–40° to +85°C (–40° to +185°F)

Operating Environment

Pollution Degree: 2

Overvoltage Category: II

Insulation Class: 1

Relative Humidity: 5%–95%, noncondensing

Maximum Altitude: 2000 m

AC Metering Inputs (SEL-2245-4)

Frequency: 50/60 Hz

Range: 45–65 Hz

Typical Accuracy: ±0.005 Hz above 20 V

Worst-Case Accuracy: ±0.01 Hz above 20 V

Phase Rotation: ABC, ACB

Input Configuration: 3-Wire Delta, 4-Wire Wye

Update Interval

Fundamental Metering: 200 Hz

RMS Metering: 5 Hz

Current Inputs Phase and Neutral

INOM: 1 A or 5 A (no settings required)

Measurement Range: 0.050–22 A Continuous

22–100 A Symmetrical for 25 s

Thermal Withstand Limit: 500 A for 1 s

Typical Accuracy: ±0.1% Fundamental@ fNOM and > 0.6 A

±0.1% RMS@ fNOM and > 0.6 A

Worst-Case Accuracy: ±2% ± 0.005 A Fundamental

±1% ± 0.005 A RMS

Angle

Range: ±180°

Typical Accuracy: ±0.1° Fundamental @ fNOM and > 0.6 A

Worst-Case Accuracy: ± 2° @ fNOM

Burden: < 0.1 VA @ INOM

Voltage Inputs

VNOM: 300 V

Measurement Range: 5–400 L-N, 9–693 L-L Vac

Fundamental/RMS

5–300 L-N, 9–520 L-L Vac

Fundamental/RMS (UL)

Maximum: 600 L-N, 1039 L-L Vac Fundamental/RMS

for 10 s

Typical Accuracy: ±0.1% Fundamental@ fNOM and > 20 V

±0.1% RMS@ fNOM

Worst-Case Accuracy: ±2% Fundamental@ fNOM

±1% RMS ±0.05 V

Angle

Range: ±180°

Typical Accuracy: ±0.1° @ fNOM and > 20 V

Worst-Case Accuracy: ±2° @ fNOM

Burden: < 0.1 VA

Sequence Components

Values: I0, I1, I2, V0, V1, V2

Typical Accuracy

Magnitude: ±0.2% @ fNOM

Angle: ±0.2° @ fNOM and V > 6.7 V, I > 0.6 A

Worst-Case Accuracy

Magnitude: ±3% @ fNOM and V > 6.7 V, I > 0.6 A

Angle: ±0.2° @ fNOM and V > 6.7 V, I > 0.6A

Power and Power Factor (Per Phase and Three-Phase)

PA, PB, PC, 3P

Typical Accuracy: 0.1% @ PF > 0.1

Worst-Case Accuracy: 2%

QA, QB, QC, 3Q

Typical Accuracy: 0.1% @ PF < 0.9

Worst-Case Accuracy: 2%

SA, SB, SC, 3S

Typical Accuracy: 0.1%

Worst-Case Accuracy: 2%

PFA, PFB, PFC, 3PF

Typical Accuracy: 0.1% @ PF > 0.1

Worst-Case Accuracy: 2%

Synchrophasor

Conformance: IEEE C37.118.1-2011 as amended by

IEEE C37.118.1a-2014

IEEE C37.118.2-2011

Accuracy: Level 1 as specified by IEEE C37.118

Measurements: Software selectable (P or M class)

Voltage: VA, VB, VC, VS

Current: IA, IB, IC, IN

Positive-Sequence: V1, I1

Periodic: Frequency and df/dt

Processing Rate: 120 Hz

Triggered Waveform Recording

Sampling Rates: 1, 2, 4, 8, 24 kHz software selectable

Record Duration: 0.1 second increments from 0.5 s to

specified maximum for each sample rate.

Maximum Record

Duration:

6 s at 24 kHz

18 s at 8 kHz

36 s at 4 kHz

72 s at 2 kHz

144 s at 1 kHz

All brand or product names appearing in this document are the trademark or registered

trademark of their respective holders. No SEL trademarks may be used without written

permission. SEL products appearing in this document may be covered by U.S. and Foreign

patents.

Schweitzer Engineering Laboratories, Inc. reserves all rights and benefits afforded under

federal and international copyright and patent laws in its products, including without lim-

itation software, firmware, and documentation.

The information in this document is provided for informational use only and is subject to

change without notice. Schweitzer Engineering Laboratories, Inc. has approved only the

English language document.

This product is covered by the standard SEL 10-year warranty. For warranty details, visit

selinc.com or contact your customer service representative. *PDS2245-04*

2350 NE Hopkins Court • Pullman, WA 99163-5603 U.S.A.

Tel: +1.509.332.1890 • Fax: +1.509.332.7990

selinc.com • inf[email protected]

SEL-2245-4 Data Sheet Date Code 20180629

Record Pretrigger: 0.05 s minimum to a maximum of

(record length –0.05) s

Waveform File Format: COMTRADE (IEEE C37.111-1999

compliant)

Type Tests

Environmental Tests

Enclosure Protection: IEC 60529:2001 + CRGD:2003

IP3X excluding the terminal blocks

Vibration Resistance: IEC 60255-21-1:1988

Vibration Endurance, Severity: Class 2

Vibration Response, Severity: Class 2

Shock Resistance: IEC 60255-21-2:1988

Bump Test, Severity: Class 1

Shock Withstand, Severity: Class 1

Shock Response, Severity: Class 2

Seismic: IEC 60255-21-3:1993

Quake Response, Severity: Class 2

Cold: IEC 60068-2-1:2007

–40°C, 16 hours

Dry Heat: IEC 60068-2-2:2007

+85°C, 16 hours

Damp Heat, Cyclic: IEC 60068-2-30:2005

25°C to 55°C, 6 cycles,

95% relative humidity

Dielectric Strength and Impulse Tests

Impulse: IIEC 60255-5:2000

IEEE C37.90-2005

Severity Level:

0.5 Joule, 5 kV CT/PT inputs

Dielectric (HiPot): IEC 60255-5:2000

IEEE C37.90-2005

Severity Level:

2500 Vac CT/PT inputs for 1 minute

RFI and Interference Tests

EMC Immunity

Electrostatic Discharge

Immunity:

IEEE C37.90.3-2001

IEC 60255-22-2:2008

IEC 61000-4-2:2008

Severity Level: 8 kV contact discharge

15 kV air discharge

Radiated RF Immunity: IEEE C37.90.2-2004

Severity Level: 35 V/m

IEC 61000-4-3:2008

IEC 60255-22-3:2007

Severity Level: 10 V/m

Digital Radio Telephone

RF Immunity:

ENV 50204:1995

Severity Level:

10 V/m at 900 MHz and 1.89 GHz

Conducted RF Immunity: IEC 60255-22-6:2001

IEC 61000-4-6:2008

Severity Level: 10 Vrms

Surge Immunity: IEC 60255-22-5:2008

IEC 61000-4-5:2005

Severity Level: 1 kV Line to Line,

2 kV Line to Earth

(202 ms filter on RMS voltages and

frequencies, 33 ms filter on fundamental

frequencies)

Fast Transient, Burst

Immunity:

IEC 60255-22-4:2008

IEC 61000-4-4:2011

Severity Level: Class A: 4 kV, 5 kHz;

2 kV, 5 kHz on communications ports

Magnetic Field

Immunity:

IEC 61000-4-8:2009

Severity Level: 1000 A/m for 3 seconds,

100 A/m for 1 minute

IEC 61000-4-9:2001

Severity Level: 1000 A/m

IEC 61000-4-10:2001

Severity Level: 100 A/m

Surge Withstand

Capability Immunity:

IEC 60255-22-1:2007

Severity Level: 2.5 kV common-mode

1.0 kV differential-mode

IEEE C37.90.1-2002

Severity Level: 2.5 kV Oscillatory

4.0 kV Fast Transient

Oscillatory Waves

Immunity:

IEC 61000-4-12:2006

Severity Level: Ring Wave: 2 kV

common, 1.0 kV differential

Oscillatory: 2.5 kV common,

1.0 kV differential

Common Mode

Disturbance Immunity:

IEC 61000-4-16:2002

Frequency: 0 Hz to 150 Hz

Severity Level: Level 4, Segment 4:

30 Vrms open-circuit, 15 kHz–150 kHz

Emissions

Radiated and Conducted

Emissions:

IEC 60255-25:2000

Severity Level: Class A

Table des matières

Autres manuels Schweitzer Engineering Laboratories Unité de contrôle

Schweitzer Engineering Laboratories

Schweitzer Engineering Laboratories SEL-2594 Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur