SC&T HE20E Manuel utilisateur

ITEM NO.: HE20E 4K2K 60Hz HDMI (HDBaseT) CAT5e Extender with IR/RS232

HE20E HDMI CAT5 Extender is using only one cost effective CAT5E/6 cable to extend your UHD

display up to 100 meters at 4K2K 60Hz. It support the special long reach mode up to 150M at

1080p 60hz 8bits. With Bi-directional RS232 and IR function to delivers significant value to

the entire home and commercial entertainment system.

HE20E 4K2K 60Hz HDMI (HDBaseT) CAT5e Extender with IR/RS232

Features:

Extends HDMI, RS232 and IR signal over one CAT5e/6 cable.

HDBaseT 2.0, HDCP 2.2 & DVI Compliant.

Uncompressed high definition video up to 4K2K@60hz (YCbCr 4:2:0).

Audio supports up to LPCM 7.1 @ 192KHz, Dolby TrueHD, DTS-HD MA

Transmission range up to 100 meters at 4K2K resolution.

Support long reach mode distance up to 150M at 1080p@60Hz@8bits.

Bi-directional IR, support 30-60khz.

Bi-Directional RS232.

Installation view:

Cable:

Link cable recommend use high quality Cat.5e、Cat.6、Cat.6a、Cat.7 UTP / STP or FTP cable.

Poor quality cable or network connection or improper construction will cause unstable

connection, video or sound disruptions, picture noise appears.

HDBaseT Distance chart by different cable:

HDMI (HDBaseT) CAT5 Extender Series

Cable Type

Range

Supported Video

CAT5e/CAT6/

CAT6a/CAT7

150M

Long reach mode

Up to 1080p 60Hz 8bit

CAT5e

100M

Up to 1080p, 60 Hz, 36 bpp

(data rates lower than 5.3 Gbps or below 225 MHz TMDS

clock).

90M

1080p 60 Hz 48 bpp, 1080p 60 Hz 3D, 4K2K/30Hz/4:4:4

and 4K2K/60Hz/4:2:0 video formats

CAT5e/CAT6a/

CAT7

100M

If connection through the wall socket, the cable length must less 5 meters between HDMI

extender and wall jack, as below drawing:

10/100Mbps network connection using general CAT5e cable and working distance up to 100M.

Panel view:

HE20ET

HE20ER

LED Instruction:

Switch Function:

1. RS232 ON : Firmware Update , OFF : Normal

2. LINK MODE ON : Long Reach mode , OFF : 4K

3. IR MODE ON : Polarity Reverse , OFF : Normal

4. IR RX TYPE ON : OEM , OFF : Reserve

RS232 Define:

Color

Status

HE20ET

HE20ER

GREEN

ON: Power on

BLUE

LINK

ON: HDBaseT Linking

RED

HDCP

OFF: HDMI unlink, ON: HDCP enable , Flash: HDCP

disable

Color

Status

HE20ET

HE20ER

GREEN

STATUS

ON: IR Polarity Reverse (third party IR system)

BLUE

IR RX

ON: Receiving IR signal

RED

IR TX

ON: Sending IR signal

Transmitter

Wall Jack

Receiver

MAX 100M

< 5M

1 2 3 4

DB9(F)/3.5mm STEREO PHONE JACK

DB9(M)/3.5mm STEREO PHONE JACK

DB9(F)/3.5mm STEREO PHONE JACK DB9(M)/3.5mm STEREO PHONE JACK

RJ45 Define:

Video Link (TIA/EIA-568-B)

1. Orange-white DATA0 +

2. Orange DATA0 -

3. Green-white DATA1 +

4. Blue DATA2 +

5. Blue-white DATA2 -

6. Green DATA1 -

7. Brown-white DATA3 +

8. Brown DATA3 -

Caution:

1. The wiring must away from any equipment with electromagnetic wave, i.e.: mobile phone,

microwave, radio equipment, fluorescent lamp, high voltage power lines.

2. The cable must pull in straight to avoid any crosstalk interference and the transmission

stability.

3. This device HDBaseT port is not general Ethernet signal; do not connect with Network

devices to avoid damage.

4. IR transmitter do not put near from receiver to avoid mutual interference.

Package Include:

HE20ET HDM Transmitter x 1 pcs

HE20ER HDMI Receiver x 1 pcs

IR Blaster Cable x 1 pcs

IR Receiver Cable x 1 pcs

DB9(M)/3.5mm STEREO PHONE JACK x 1

DB9(F)/3.5mm STEREO PHONE JACK x 1

Mounting Screw pack x 2 bags

DC5V 2Amp Power Adapter x 2 pcs

Specification:

Rev. A1

RS232

3.5 mm Phone Jack

RS232

3.5 mm Phone Jack

Footprint

Define

Footprint

Define

Footprint

Define

Footprint

Define

Pin 2

Pin 1

Pin 2

Pin 1

Pin 3

Pin 2

Pin 3

Pin 2

Pin 5

GND

Pin 3

GND

Pin 5

GND

Pin 3

GND

ITEM NO.

HE20ET

HE20ER

HDMI Connector

HDMI Type A x 1

HDMI Video Support

1080p @ 60Hz @ 48bits、3D、4K x 2K(YCbCr 4:2:0)

HDMI Audio Support

Up to 7.1 LPCM 192KHz / Dolby TrueHD / DTS-HD MA

HDBaseT Connector

RJ45 x 1

HDBaseT Distace

100M/150M (Long Reach mode)

RS-232 Connector

DB9(F)/3.5mm STEREO PHONE JACK

DB9(M)/3.5mm STEREO PHONE JACK

RS-232 Baud Rate

115200 bps / full duplex

IR Input/Output

3.5mm Phone Jack x 2

IR Carrier

Frequecny/Angle/Distance

30~60KHz / T：± 10° / R：± 55° / 5M /Bi-directional

Audio Connector

Optical (TOSLINK) TX

Optical (TOSLINK) RX

Power Consumption

800mA

1200mA

Power Adapter

DC 5V 2A

Temperature

Operation: 0 to 55℃, Storage: -20 TO 85℃, Humidity: up to 95%

Dimensions mm

109.6 x 109.5 x 30

Weight g

270

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels SC&T Extenseur

Manuels Extenseur populaires d'autres marques

SY HDBT-60T Manuel utilisateur

Appsys ProAudio

Appsys ProAudio ADX-16 Manuel utilisateur

Atlona

Atlona RS232 Manuel utilisateur

IDK

IDK OPF-TH1000-A Manuel utilisateur

Enable-IT

Enable-IT 824WP Manuel utilisateur

Worx

Worx Landroid RadioLink WA0864 Fiche technique

TP-Link

TP-Link TL-WA730RE Manuel utilisateur

Camplex

Camplex CMX-HDMI-SFPL Manuel utilisateur

Marmitek

Marmitek MegaView70 Manuel utilisateur

Samsung

Samsung SCS-26UC4 Manuel utilisateur

Foxun

Foxun SX-GES24 Manuel utilisateur

MuxLab

MuxLab 500771 Manuel utilisateur

foxunhd

foxunhd SX-AEX01 Manuel utilisateur

TERK Technologies

TERK Technologies LFIRX2 Manuel utilisateur

Devolo

Devolo Audio Extender Manuel

Edimax

Edimax EW-7438RPn V2 Manuel utilisateur

Shinybow USA

Shinybow USA SB-6335T5 Manuel utilisateur

SECO-LARM

SECO-LARM ENFORCER EVT-PB1-V1TGQ Manuel utilisateur