Savant CLI-10K4IN-00 Manuel utilisateur

CLI-10K4IN-00 | 009-1798-00 | 190613

45 Perseverance Way, Hyannis, MA 02601

Savant.com | 508.683.2500

1 of 2

Top Panel

Blinking Green RS-485 communications is not established.

Once powered is applied, it can take up to

20 seconds to establish communications.

HELPFUL! If communications was

established and subsequently lost,

the LED will stay solid for about 1

minute before it starts blinking.

.5s1s 1s

Repeat

.5s

Solid Green RS-485 communication is established and

module is communicating with thermostat.

BThermistor inputs 1-4 - Connect one thermistor per port (1-

4). When wiring the thermistors, polarity is not observed.

C24V AC input - Connect 24V AC from HVAC transformer or

similar to power the module. Input power is an AC signal so

polarity is not observed.

RS-485 port - As shown in the image above, the right three

pins connect to the RS-485 connections in the thermostat.

No connections are made to the leftmost 3 pins. Refer to the

RS-485 Connections section for more information on wiring.

(1) HVAC 10K Sensor Module - (CLI-10K4IN)

(2) 3 Position Screw Down Plug-In Terminal Block (028-0736)

(1) 6 Position Screw Down Plug-In Terminal Block (028-0737)

(1) 6 Position Screw Down Plug-In Terminal Block (028-9352)

(1) Product and Regulatory Insert (009-1703)

Remote Temperature Sensor - Flush Mount (SST-TEMP1)

Outdoor Remote Temperature Sensor (SST-0TEMP1)

PLENOM Remote Sensor - Commercial (CLI-PLEN1C)

PLENOM Remote Sensor - Residential (CLI-PLEN1R)

SLAB Remote Sensor (CLI-SLAB1)

Box Contents

Supported Sensors (available on the Savant Store)

Speciﬁcations

Environmental

Temperature 32° to 104° F (0° to 40° C)

Humidity 10% to 90% Rel Humidity (non-condensing)

Power

Input Power 24V AC (19.2 - 28.8V AC)

Max Current Draw .1 amps (rms)

Minimum Supported Release

Climate Conﬁg App Version 1.1.2

Regulatory

Safety and

Emissions

FCC Part 15

Contains FCC ID: 2AEHU-MESHTEK-H52

Contains IC: 20059-MESHTEK52

RoHS Compliant

Dimensions and Weights

Height Width Depth Weight

CLI-10K4IN 3.77 inch

(9.58 cm)

3.16 inch

(8.03 cm)

.91 inch

(2.3114 cm)

< 1 lbs

(< .5 kg)

Shipping 6.25 inch

(15.88 cm)

4.8 inch

(12.19 cm)

1.25 inch

(3.175 cm)

< 1 lbs

(< .5 kg)

10K

Status

24VAC

CLI-10K4IN-00

S/N:

UID:

SHK180200331

001AAE09C62D2453

Left Side Panel

GndN/C

N/C

N/C B

Maximum Wiring Distances

RS-485 Up to 1000 feet (304.8 meters) cumulative.

Power

#24 AWG - 20 feet (6.10 meters)

#20 AWG - 57 feet (17.37 meters)

#18 AWG - 90 feet (27.43 meters)

#16 AWG - 143 feet (43.59 meters)

#14 AWG - 228 feet (69.49 meters)

Sensor Module with Four 10K Thermistor Inputs

Quick Reference Guide

CLI-10K4IN-00 | 009-1798-00 | 190613

45 Perseverance Way, Hyannis, MA 02601

Savant.com | 508.683.2500

2 of 2

Use the diagram below when wiring the 10K temperature sensors.

Thermistor ConnectionsMaking Connections

Power Connections

RS-485 Connections

Refer to the following documents located on the Savant Customer

Community for additional information.

– Multistat Smart Thermostat Deployment Guide (009-1636)

– Multistat Thermostat with Touchscreen (009-1593)

Additional Information

< 1/8 inch of

bare wire

exposed

When making connections, follow the guidelines set below to ensure a

safe and secure connection.

Use the diagrams below when making the power connections be-

tween the thermostat and the CLI-10K4IN climate module.

Use the diagrams below when making the RS-485 connections be-

tween the thermostat and CLI-10K4IN climate module.

– Power can be daisy-chained between modules.

– The cable lengths vary depending on the size of the wire. See the

speciﬁcations table on page 1 for more information.

– Supports a maximum of four sensors per CLI-10K4IN module.

– There is no polarity to the 10K temperature sensors.

– Max cable length = 500 feet (152.4 meters).

– Minimum size wire = 24 AWG.

– A twisted pair is recommended (e.g. Cat 5e/6/7).

– Any 10K type temperature sensor is supported. See the Supported

Sensors section on page 1.

– Climate modules can be daisy-chained to increase the number of

sensors.

– Two or more ports can be combined and the average of these

sensors taken.

1. With a small slotted screwdriver,

turn the screws on the connector

counterclockwise (CCW) until the

silver crimps open enough to slide

a wire into the square slots.

2. Strip back insulation on each wire

to / inch and insert the stripped

wire into the proper connection.

3. Turn the screw clockwise (CW)

until the crimps tighten around

each wire. Tug on each wire a bit

to verify they are secure.

AUX OUT

AUX IN

RS2

RS1

GND

RX-

RX+

GND

1-WIRE

5V DC

TX+

TX-

24C

10K

Status

CLI-10K4IN-00

S/N:

UID:

SHR180600332

001AAE09C6240000

24VAC

Power can be

daisy-chained

to other modules

24V AC

from HVAC

AUX OUT

AUX IN

RS2

RS1

GND

RX-

RX+

GND

1-WIRE

5V DC

TX+

(TX+)

TX-

(TX-)

24C

Left Side View

RS-485 Cable

CLI-10K4IN

10K Remote

Sensors

10K

Status

CLI-10K4IN-00

S/N:

UID:

SHR180600332

001AAE09C6240000

24VAC ~

– Max cable length is 1000 feet (304.8 meters).

– Savant recommends using standard RS-485 cable for wire runs.

Autres manuels Savant Unité de contrôle

Savant

Savant CLI-PTAC1K1 Manuel utilisateur

Savant

Savant VOM-VP01F Manuel utilisateur

Savant

Savant CLI-1WIRE2 Manuel utilisateur

Savant

Savant SAV-LMP-0300 Manuel utilisateur

Savant

Savant SKL-3040-00 Manuel utilisateur

Savant

Savant VOM-VP02H Manuel utilisateur

Savant

Savant CLI-8000 Series Manuel utilisateur

Savant

Savant SSC-P008 Manuel utilisateur

Savant

Savant GPM-CP2R20120-21 Manuel utilisateur

Savant

Savant Pro Host Manuel utilisateur

Savant

Savant Pro Host Manuel utilisateur

Savant

Savant IP Audio 125 with Savant Music 2.0 Manuel utilisateur

Savant

Savant Smart Host Rack Mountable Manuel utilisateur

Savant

Savant SmartView VOM-SV02 Manuel utilisateur

Savant

Savant SKL-3040-00 Manuel utilisateur

Savant

Savant SKL-3040-00 Manuel utilisateur

Savant

Savant ITP-E8000 Series Manuel utilisateur

Savant

Savant Pro Host SVR-5200S-00 Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur