Sangoma IMG 1010 Mode d’emploi

IMG 1010 - Rack Mounting

The IMG 1010 is shipped with the tray and docking station mated together for easy mounting. When mounting the chassis, follow these

guidelines:

Do not obstruct air flow to the front or the side vent holes towards the rear of the unit.

Allow approximately 76 cm (2.5 ft.) to slide the field-replaceable tray out.

19" Front and Mid mount Bracket Positioning

The IMG 1010 ships with brackets for a 19" inch rack. They are installed in the front mount position as shown below.

Front Mount (factory default)

The brackets can be rotated as shown below. By rotating and repositioning the brackets, the IMG can be used in a mid-mount installation. The

two mid-mounting options are displayed in diagrams below.

Mounting Ears on bracket facing rear:

Mounting Ears on bracket facing forward:

19" Rear Mount Bracket Kit (SLM-BRK-1000)

For extra support, a rear mount bracket assembly is also available. This bracket assembly is needed to make the system NEBS Level 3

Compliant. If only the front or mid mount brackets are used when installing an IMG in a rack system, the IMG 1010 will not be NEBS Level 3

Compliant. The rear mount brackets are attached to the IMG 1010 by inserting a 6-32" screw located towards the rear of the IMG into the

mounting hole of each bracket (one on either side of IMG 1010). Contact your sales representative to order the bracket.

23" Front and Rear Mount Bracket Kit (SLM-BRK-1001)

The bracket assembly for use with a 23" rack includes front and rear mounting options for added stability. When installing IMG into a 23" rack, the

front and rear brackets are required. As explained above, for the IMG 1010 to be NEBS Level 3 compliant in a 23" rack, both the front and rear

bracket assemblies must be used. See diagram Below

Installation

Remove existing 19" brackets from front mounting position.

Replace with 23" brackets, re-using existing screws.

Attach Rear Bracket Mounts to chassis as shown in figure.

Attach 23" brackets to the Bracket Mounts using screws provided.

Table des matières

Autres manuels Sangoma Porte

Sangoma

Sangoma Vega 3050G Manuel utilisateur

Sangoma

Sangoma VEGA400G Instructions d'utilisation et d'entretien

Sangoma

Sangoma Vega 100G Manuel utilisateur

Sangoma

Sangoma Netborder SS7 Manuel utilisateur

Sangoma

Sangoma Vega 4x4 Manuel utilisateur

Sangoma

Sangoma IMG 2020 Manuel utilisateur

Sangoma

Sangoma Vega 60G Manuel utilisateur

Sangoma

Sangoma Netborder SS7 Manuel utilisateur

Sangoma

Sangoma Vega 5000 Manuel utilisateur

Sangoma

Sangoma Vega 100G Manuel

Sangoma

Sangoma Vega 60G Manuel utilisateur

Sangoma

Sangoma Vega 100G Manuel utilisateur

Manuels Porte populaires d'autres marques

LST

LST M500RFE-AS Manuel utilisateur

Kinnex

Kinnex Media Gateway Manuel utilisateur

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur

Telsey

Telsey CPVA 500 - SIP Manuel utilisateur

RTA

RTA 460A-NNA4 Fiche technique

Shaw

Shaw Gateway HDPVR Manuel utilisateur

ABB

ABB VSN900 Guide de démarrage rapide

Commander

Commander Pulse Manuel utilisateur

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuel utilisateur

NETGEAR

NETGEAR C6300BD Manuel utilisateur

Amit

Amit CDW531AM Manuel utilisateur

HMS

HMS Netbiter EasyConnect EC150 Manuel utilisateur

Huawei

Huawei EchoLife HG620 Manuel utilisateur

AT&T

AT&T U-verse 3801 Manuel d'utilisation et d'entretien

Logic IO

Logic IO RTCU MX2 turbo Manuel utilisateur

Suttle

Suttle MediaMAX MXM-521 Manuel utilisateur