Sangean WR-2 Manuel utilisateur

Revision 1

WR-2A

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only with dry cloth.

Do not block any ventilation openings. Install in accordance

with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including ampliers) that

produce heat.

Do not defeat the safety purpose of the polarized or grounding-

type plug. A polarized plug has two blades with one wider

than the other. A grounding type plug has two blades and

a third grounding prong. The wide blade or the third prong

are provided for your safety. If the provided plug does not fit

into your outlet. consult an electrician for replacement of the

obsolete outlet.

Protect the power cord from being walked on or pinched

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

Only use attachments/accessories specied by the manufacturer.

Important Safety Instructions

10.

11.

Use only with the cart, stand, tripod, bracket, or table specied

by the manufacturer, or sold with the apparatus. When a cart is

used, use caution when moving the cart/apparatus combination

to avoid injury from tip-over.

Unplug this apparatus during lightning storms or when unused

for long periods of time.

Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged. liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not operate

normally, or has been dropped.

To Reduce the Risk of Fire or Electric Shock, Do not Expose

This Appliance To Rain or Moisture.

The Shock Hazard Marking and Associated Graphical Symbol

is provided on the bottom panel of unit.

Apparatus shall not be exposed to dripping or splashing and no

objects lled with liquids, shall be placed on the apparatus.

Excessive sound pressure on ear- and headphones could impair

the hearing ability. Higher setting that idle on the equalizer leads

to higher signal voltages on the output for ear and headphones.

The power plug should be close to the radio, and easy to be

approached that during the emergency, to disconnect the power

from the radio, just unplug the power plug from the AC power slot.

Where the MAINS plug or an appliance coupler is used as the

disconnect device, the disconnected.

12.

13.

14.

15.

16.

17.

18.

19.

20.

Speaker

Light button

Band button

LCD display

Preset buttons

Power On / Off / Sleep button

Tuning control knob

Volume / tone control

IR sensor

Menu button

Mono button

Radio alarm button

Buzzer alarm button

Nap button

Info button

Headphone socket

AC power cord socket

12V DC input socket (ideal for vehicles / boats)

REC out socket

AUX IN socket

External / Internal antenna switch

External F-type FM antenna terminal

External AM antenna terminal (USA version only)

Controls

Power On / Off / Sleep button

Nap button

Select button

Info button

Preset button

Mute button

Light button

Tuning up / down button

Tone control button

Volume button

Menu button

Radio alarm button

Buzzer alarm button

Band button

Remote control

Frequency / Time / Station display

Radio / Buzzer alarm indicator

Daylight Saving Time (DST)

Sleep / Snooze status

RDS indicator

Stereo indicator

Memory preset

Aux In level attenuation

Display icons

Remote control functions

Many functions of the WR-2 radio can be operated using the

remote control. Some operations require a longer press of the

button.

In this case simply keep your finger held on the remote control

button for 2-3 seconds until the display on the radio shows that the

command has been accepted.

Before the rst operation: please remove the small transparent

foil from the battery holder to activate the battery.

Remote control battery replacement

4. Replace the battery holder.

IMPORTANT:

The batteries should not be exposed to excessive heat such as

sunshine, re or the like. After use, disposable batteries should if

possible be taken to a suitable recycling center. On no account

should batteries be disposed of by incineration.

Warning

KEEP OUT OF REACH OF CHILDREN

[The remote control supplied with] This product contains a coin/

button cell battery. Swallowing may lead to serious injury or death.

Severe burns can occur within 2 hours of ingestion.

Keep batteries out of reach of small children. Coin cell batteries can

be accidentally ingested. If ingested, these batteries may leak harmful

contents causing chemical burns, perforation of soft tissue, and in

severe cases may cause death. Coin batteries must be removed

immediately if swallowed. Seek medical attention immediately, if you

or your doctor suspects that a battery has been ingested.

1. Open the battery holder by pulling

the holder out in direction shown.

2. Remove battery from holder.

3. Replace battery (CR2025 or equivalent)

ensuring that the positive side of the

battery faces you with holder positioned

as shown.

Power your radio

AC operation

Before you plug the AC cord into the radio, be sure the AC voltage

is correct. Insert the plug on the end of the supplied power cord

into the AC power socket on the back of the radio.

DC operation

For outdoors use, you can power the radio by using 12V DC input

socket from a DC power supply (example, from the power supply of

vehicles or boats). An AC power adaptor with 1 Ampere and center

positive in polarity can also power the radio in house.

Using the radio for the rst time

1. Place your clock radio on a at surface.

2. Insert the adaptor plug into the AC socket located on the rear of

your radio.

Manual clock setting

1. Press Menu button and the display will show ‘CLOCK SET’.

2. Press the Tuning control knob to enter the clock setting.

3. Rotate the Tuning control knob to select the desired hour and

press the Tuning control knob to conrm the hour setting. Now the

minute digit will ash.

4. Rotate the Tuning control knob to adjust the minutes and press

the knob to conrm the setting. Now the clock setting is completed.

Autres manuels pour WR-2

Table des matières

Autres manuels Sangean Récepteur

Sangean

Sangean ATS-803A Manuel utilisateur

Sangean

Sangean Sangean SR25V SR25V Manuel utilisateur

Sangean

Sangean PT-633 Manuel utilisateur

Sangean

Sangean WR-1CL Manuel utilisateur

Sangean

Sangean DCR-200 Manuel utilisateur

Sangean

Sangean WR-1CL Manuel utilisateur

Sangean

Sangean MMR-77 Manuel utilisateur

Sangean

Sangean H203D Manuel utilisateur

Sangean

Sangean DT-110 Manuel utilisateur

Sangean

Sangean ATS-505P Manuel utilisateur

Sangean

Sangean Sangean SR-3 SR-3 Manuel utilisateur

Sangean

Sangean DDR-36 Manuel utilisateur

Sangean

Sangean U-1 Manuel du propriétaire

Sangean

Sangean Sangean DT400W Manuel utilisateur

Sangean

Sangean WFT-4 Manuel utilisateur

Sangean

Sangean Toughbox TB-100 Manuel utilisateur

Sangean

Sangean PR-D4 Manuel utilisateur

Sangean

Sangean REVERY R4 Manuel utilisateur

Sangean

Sangean DCR-89+ Manuel utilisateur

Sangean

Sangean Sangean DT400W Manuel utilisateur

Sangean

Sangean WR-11 Manuel utilisateur

Sangean

Sangean DT-110CL Manuel utilisateur

Sangean

Sangean PR-D7 Manuel utilisateur

Sangean

Sangean DT-210V Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur