Sangean PR-D19 Manuel utilisateur

Version 1

中文

PR-D19

Important safety instructions

10.

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only with dry cloth.

Do not block any ventilation openings. Install in accordance with

the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including amplifiers) that

produce heat.

Do not defeat the safety purpose of the polarized or grounding-type

plug. A polarized plug has two blades with one wider than the other.

A grounding type plug has two blades and a third grounding prong.

The wide blade or the third prong are provided for your safety. If the

provided plug does not t into your outlet. Consult an electrician for

replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched particularly

at plugs, convenience receptacles, and the point where they exit

from the apparatus.

11.

12.

13.

14.

15.

16.

17.

Only use attachments/accessories specied by the manufacturer.

Use only with the cart, stand, tripod, bracket, or table specied by

the manufacturer, or sold with the apparatus. When a cart is used,

use caution when moving the cart/apparatus combination to avoid

injury from tip-over.

Unplug this apparatus during lightning storms or when unused for

long periods of time.

Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way, such

as power-supply cord or plug is damaged. liquid has been spilled

or objects have fallen into the apparatus, the apparatus has been

exposed to rain or moisture, does not operate normally, or has

been dropped.

To Reduce the Risk of Fire or Electric Shock, Do not Expose This

Appliance To Rain or Moisture.

The Shock Hazard Marking and Associated Graphical Symbol is

provided on the rear of unit.

Apparatus shall not be exposed to dripping or splashing and no

objects lled with liquids, shall be placed on the apparatus.

18.

19.

20.

Excessive sound pressure on ear- and headphones could impair

the hearing ability. Higher setting that idle on the equalizer leads to

higher signal voltages on the output for ear and headphones.

The power plug should be close to the radio, and easy to be

approached that during the emergency, to disconnect the power

from the radio, just unplug the power plug from the AC power slot.

Where the MAINS plug or an appliance coupler is used as the

disconnect device, the disconnected device shall remain readily

operable.

FCC INFORMATION

The Federal Communication Commission Radio Frequency

Interference Statement includes the following paragraph:

The equipment has been tested and found to comply with the

limits for a Class B Digital Device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instruction,

may cause harmful interference to radio communication. However,

there is no grantee that interference will not occur in a particular

installation. If this equipment dose cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Cautions to the user

Notice:

The changes or modifications not expressly approved by the party

responsible for compliance could voidthe user’s authority to operate the

equipment.

CAUTION:

To reduce the risk of the electric shock, do notm perform any servicing

other than that contained in the operating instructions unless you are

qualied to do so.

Control

Speaker

Buzzer alarm radio

Radio alarm radio

Band/Bandwidth/Step button

Power on indicator

LCD display

Power/Sleep button

Volume down button

Volume up button

Display/Mono/Clock set button

Tuning up/down button

Key lock switch

Preset button

Battery compartment

Telescopic aerial

Aux in socket

Headphone socket

DC IN socket

Icon display

Battery indicator

Stereo indicator

Bandwidth indicator

Buzzer alarm indicator

Radio alarm indicator

Key lock symbol

Sleep timer indicator/Snooze indicator

Preset indicator

Volume indicator

Frequency/Clock display

PM indicator

FM/AM indicator

Using the radio for the rst time

Battery operation

1. Remove the battery cover on the rear of the unit by pressing the

catch.

2. Insert four UM-3 (AA size) batteries into the spaces in the compartment.

3. Take care to ensure all batteries are inserted with correct polarity

as shown on the rear cabinet. Replace the battery cover.

4. Reduced power, distortion, “stuttering sound” and the battery

icon ashing on the display are all signs that the batteries need

replacing.

5. If the radio is not to be used for any extended period of time, it is

recommended that the batteries are removed from the radio.

Using the AC power adaptor

The AC power adaptor required for this unit should be 6 volts DC at

1 A center pin positive.

Insert the adaptor plug into the DC socket on the left side of the

radio.

Plug the adaptor into a standard mains socket outlet.

Whenever the adaptor is used, the batteries are automatically

disconnected.

The AC adaptor should be disconnected from the main supply when

not in use.

Operating your radio - Search tuning AM / FM

1. Fully extend the antenna above the radio. Press the Power button

to switch on your radio.

2. Press the Band button to select the required band.

3. Press and hold the Tuning up/down button to start the search

tuning. Your radio will scan in an upwards direction (low frequency

to high frequency) or downwards direction (high frequency to low

frequency) and stop automatically when it finds a station of

sufcient strength.

4. To find other stations, press and release the Tuning Up/Down

buttons.

5. Adjust the volume by pressing the Volume up/down button to the

required setting.

Note:

To see time or frequency on the screen, press the Display button.

Manual tuning - AM / FM

1. Press the Power button to switch on your radio.

2. Press the Band button to select the required band. Fully extend

the antenna for best reception.

3. Press and release the Tuning up/down button to tune to a station.

The FM frequency will change in steps of 50/100kHz and AM

frequency will change in steps of 9/10kHz.

4. When the waveband end is reached the radio will recommence

tuning from the opposite waveband end.

5. Set the Volume using the Volume Up/Down buttons to the desired

settings.

Presetting stations

You may store your preferred AM/FM radio stations to the preset

stations (1 to 5). The procedure for setting preset Stations is

described below.

Note that the radios for AM (AM1/AM2) and FM (FM1/FM2) are

saved together in the preset stations so there are 20 of them. Your

preset stations will be preserved for 30 minutes when there is no

power supply from either the battery or the AC adapter.

1. Press the Power button to switch on your radio.

2. Tune to the required station as previously described.

3. Press and hold the required Preset button (1-5) until you hear a

beep sound and the display shows‘M1’ for example on the top right

corner. The station will be stored using the preset number. Repeat

this procedure for the remaining presets as you wish.

4. Preset stations which have already been stored may be overwritten

by following the above procedure if required.

Table des matières

Autres manuels Sangean Récepteur

Sangean

Sangean CP-100D Manuel utilisateur

Sangean

Sangean ATS-909 Manuel utilisateur

Sangean

Sangean WFR-70 Manuel utilisateur

Sangean

Sangean REVERY R4 Manuel utilisateur

Sangean

Sangean PT-633 Manuel utilisateur

Sangean

Sangean ATS-818ACS Manuel utilisateur

Sangean

Sangean SG-118 Feuille d'instructions

Sangean

Sangean WR-2 Manuel utilisateur

Sangean

Sangean DT-120 Manuel utilisateur

Sangean

Sangean WFR-32 Manuel utilisateur

Sangean

Sangean HEDONIC 70 PR-D7 Manuel utilisateur

Sangean

Sangean MMR-77 Manuel utilisateur

Sangean

Sangean WR-12 Manuel utilisateur

Sangean

Sangean DCR-89+ Manuel utilisateur

Sangean

Sangean U-3 Manuel du propriétaire

Sangean

Sangean Sangean DT400W Manuel utilisateur

Sangean

Sangean WFR-39 Manuel utilisateur

Sangean

Sangean DT-110 Manuel utilisateur

Sangean

Sangean ATS-405 Manuel utilisateur

Sangean

Sangean WFT-4 Manuel utilisateur

Sangean

Sangean PR-D7 Manuel utilisateur

Sangean

Sangean ATS-505 Manuel du propriétaire

Sangean

Sangean DT-210 Manuel utilisateur

Sangean

Sangean WR-1CL Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur