Page 2 of 9
6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury,
etc.
7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication. A
moment of inattention while operating this equipment may result in serious personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
WARNING: To prevent personal injury, perform the Pressure Relief Procedure before and after
operating the control valve and before performing any disassembly or assembly.
WARNING: Failure to comply with the following information could result in injury that could cause
severe injury or death.
1. EQUIPMENT MISUSE HAZARD: Equipment misuse can cause the equipment to rupture or malfunction
and result in serious injury.
◼Only trained or authorized people should operate this equipment.
◼Read all instruction manuals, tags, and labels before you operate this equipment.
◼Use the equipment only for its intended purpose. If you are not sure, call the distributor.
◼Do not modify this equipment. If you need to replace the parts, use the standard parts or components.
◼Check equipment daily. Repair or replace worn or damaged parts immediately.
◼Do not exceed the maximum working pressure of the lowest rated system component. This
equipment has a 1500 PSI maximum working pressure.
◼Make sure all applications comply with local, state, and national fire, electrical, and safety regulations.
◼Use fluids and solvents that are compatible with the equipment. Refer to the Technical Data section of
all equipment manuals. Read the fluid and solvent manufacturer's warnings.
◼Do not move or lift the equipment when the control valve is in use.
◼The operating environment must be fireproof, safe for electrical use and other with security assured.
2. SKIN INJECTION HAZARD: Fluid from the control valve, leaks, or ruptured components can splash into
your body, eyes or skin, which may cause extremely serious injury. If this happens, ask for medical help
immediately.
◼Do not point the dispensing valve at anyone or at any part of the body.
◼Do not stop or deflect leaks with your hand, body, glove or rag.
◼Do not use oil that has been polluted.
◼Do not put your hand or fingers over the fitting coupler.
◼Follow the Pressure Relief Procedure in the OPERATION INSTRUCTIONS section if the grease
fitting coupler clogs and before you clean or service this equipment.
◼Before each use, make sure that all connections are properly installed. Tighten all fluid connections
before operating the equipment.
◼Check the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not
repair high-pressure couplings. You must replace the entire hose.
