RadiSys ES4001G ONT Manuel utilisateur

Quick

Installation Guide

ES4001G ONT

Document Revision 0.1 (draft)

Interfaces Specication

Operating Temperature 0 to 55°C (32 to 131°F)

Dimensions 210mm(L)×150mm(W)×32mm(H)

2.3 Interfaces

Item Description

1 LEDs Status LEDs

2 DC POWER Power port for external Power Adaptor

3 ON/OFF Button Turn power ON or OFF

4 RESET Reboot ONT (quick push)

Reset to factory (press and

hold for 10 seconds)

5 1GE (GE1) 1GE Ethernet ports for PC or LAN (RJ45)

6 PON Optical cable Termination port

1 Introduction

The Radisys ES4001G is a high value, small form factor GPON ONT ber

terminal complying with the ITU-T G.984 standard. The ONT enables

broadband connectivity to the subscriber for residential and business

services.

2.1 Contents

- ES4001G ONT

- RJ45 cable

- Power Adaptor

2.2 ProductSpecications

Interfaces Specication

WAN Uplink GPON port (SC/APC)

Ethernet 1 10/100/1000 Base-T port (RJ45)

Power Adaptor Input 90-240VAC, 50/60Hz

Power Adaptor Output +12VDC nominal, 0.5A

2 3 54 6

Power DC12V Reset GE PON

3.1 Installation

1. Remove ONT from packaging.

2. Lay ONT at on surface or attach ONT to wall.

3. Remove protection plug (black) from PON port.

4. Connect ber optic cable with SC/APC termination to WAN port.

5. Connect Ethernet cable with RJ45 termination to LAN port.

6. Connect Power Adaptor cable with 2-pin barrel to POWER port.

7. Plug in Power Adaptor into electrical outlet.

8. Push ON/OFF button. Check LED power up sequence.

User note: ONT may be upgraded to newer software image prior to pro-

visioning of services. ONT may reset after the initial boot up sequence is

complete, or software image is upgraded.

2.4 LED Status Indicators

Label Color Status Denition

POWER Green ON Normal operation

Rapid blink Reset to factory defaults, not cong-

ured for service

Slow blink (1/s) Initializing, start of boot process

PON/LOS Green/RED ON WAN interface ranged and linked

Slow Blink (1/s) WAN ranging in process

RED blink Not ready for ranging or provisioning

INTERNET Green ON Internet service available, IP address

OFF Internet service not available, IP or

DNS failure

LAN1 (GE1) Green ON Ethernet port interface is linked

Activity (ash) Data transmitting

OFF Ethernet port is disabled or no service

456

Power DC12V Reset GE PON

3.2 Mounting ONT on a wall

ONT has two mounting holes that can be used for wall mount placement.

Please see diagram for screw separation and location.

ONT should be mounted with LEDs facing up and service interfaces facing

down to avoid dust and contamination.

4 Web Graphical User Interface

You can access the ONT through a web browser using the following steps:

- Connect an Ethernet cable from your computer the LAN port.

- Launch a web browser or telnet session and connect to address

192.168.1.1.

- After response, enter the following:

1. Username: admin

2. Password: Serial Number of the respective device in

UPPER CASE (printed on back side of the device)

5 Troubleshooting

The Power LED on the front panel is off after pressing the Power switch.

- Verify that the power adapter is connected correctly to the device.

- Be sure to use the supplied power adapter with the device. The PON

LED on the front panel is off or green ashing after the device is

powered on.

- The PON link is not established.

- The ONT is not registered.

- Contact the service provider for help.

- The LAN LED on the front panel is off after the device is powered on.

- The corresponding LAN is not established.

- The Ethernet cable is not connected correctly.

- The network device connected to the LAN is not powered on.

- The LOS LED on the front panel is ashing red after the device is

powered on.

- The optical ber cable is broken or damaged.

- The optical ber cable is not connected to ONT PON device correctly.

- Please contact the service provider if the LED is ashing red.

6 Caution

Please follow the instructions below to avoid physical injury:

- This unit is for indoor use only.

- All Ethernet, telephone and power wiring are limited to the inside of

the building.

- You should not install ONT during lighting storms to avoid

electrical shock.

- Never look directly at the ber port and ber cable ends when they

are powered on.

- DO NOT plug in, turn on or attempt to operate an obviously

damaged unit.

- DO NOT use near water.

- DO NOT operate ONT in a location where maximum ambient temp.

exceeds 55°C.

- DO NOT place near high temperature source.

- Set up the unit away from direct sunlight or other electrical

equipment.

- Open optical connections must use a protective cap under all

circumstances to protect against physical damage and dirt.

- Avoid impact stresses when handling connectors.

- Physical damage to optical connections impairs transmission quality.

- Please don’t open the cover of the device, especially when the device

is powered ON. It can be dangerous to do so.

- Avoid a bend radius in excess of 30 mm for ber optic links.

- Check the available voltage supply.

- Only connect approved accessories.

- This equipment is not suitable for use in locations where children are

to be present.

- DO NOT disassemble the unit.

7 Limited Warranty

The product warranty does not cover damage resulting from hardware

being installed in areas subject to rain, high humidity, water ingress and

dust or debris. Disassembling product or removing enclosure cover from

the assembly is a safety hazard and will void warranty. ES4001G may only

be repaired by authorized service personnel.

Radisys ES4001G ONT Quick Installation Guide10

RSYSQGES4001ONT12062023A

Table des matières

Autres manuels RadiSys Matériel informatique

RadiSys

RadiSys EPC-2102 P5000HX2 Series Guide de référence

RadiSys

RadiSys EPC-3307 Guide d'application

RadiSys

RadiSys EPC-9 Guide d'application

RadiSys

RadiSys EPC-31 Guide d'application

RadiSys

RadiSys ATCA-4616 Manuel de service

RadiSys

RadiSys EPS-6315 Guide d'application

RadiSys

RadiSys PROCELERANT CE915GMA Manuel utilisateur

RadiSys

RadiSys EPC-3311 Guide d'application

RadiSys

RadiSys EPC-6320 Guide d'application

RadiSys

RadiSys PM6165B ONT Manuel utilisateur

RadiSys

RadiSys EPC-5A Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur