Precautions .
Safety Tips .
•Please read this manual carefully before using the joystick controller.
•Avoid damage from stress, violent vibration or liquid intrusion during
transportation, storage, or installation.
•Do not apply excessive voltage, use only the specified voltage. Otherwise, you
may experience an electrical shock.
•Keep the joystick controller away from strong electromagnetic sources.
•Do not clean the joystick controller with any active chemicals or corrosive detergents.
•Do not disassemble joystick controller or any of the joysticks's components. If problems
arise, please contact your authorized dealer.
•After long term operation, moving components can wear down. Contact your
authorized dealer for repair.
Requirements .
•The joystick controller will require the presence of a DHCP server on your network for initial
configuration (IP address is set to DHCP by default)
•The joystick controller is unable to span subnets; the IP camera and joystick controller must be
in the same subnet of the LAN (example –192.168.1.123 & 192.168.1.111 belong to the same
subnet; 192.168.1.123 & 192.168.0.125 do not)
•The joystick controller requires that the IP camera being controlled is fully ONVIF-S compliant,
with ONVIF capabilities enabled, or the joystick will not properly control the camera.
oWhen being used with a PTZOptics camera please make sure that in the web interface of
the camera you have enabled “ONVIF:” to “On” under the “Network” section.
oWhen being used with a PTZOptics camera please make sure that in the web interface of
the camera you have enabled “ONVIF AUTH:” to “Off” under the “Network” section.
oPlease reboot the camera if these settings were originally in the incorrect state.
What’s in the Box .
Supplied Hardware .
•PT-JOY-G2
oPT-JOY-G2 Joystick Controller
oPower Supply
oUser Manual (This Document)
