Prorack K727 Manuel utilisateur

K727

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 1 x 1 x 1 x 1

Revision No: 1A 1

Fitting Kit K727

x 2 x 2 x 2 x 1

x 1 x 2 x 2

Fitting Kit K727

MAX kgs (lbs)

W/P WHD

Audi

A3 , 4dr Sedan Aug 13-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)

A3 , 4dr Sedan Aug 13-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)

A3 Limousine, 4dr Sedan Aug 13-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)

A3 , 4dr Sedan Aug 13-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)

A3 , 4dr Sedan Aug 13-+ US 75 kgs (165 lbs) 75 kgs (165 lbs)

Fitting Kit EN

K727

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

Fitting Kit EN

K727

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment method.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K727

●Remove locking screw.

●Apply protective strip as shown.

Trim if required.

●A = Clear

B = Grey

●It is important to put the clamps in the

correct position on the vehicle.

●Letters refer to the part numbers stamped

on clamps.

●Clamp Part Number:

A = 087A

B = 088A

C = 089A

D = 090A

Fitting Kit EN

K727

●Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

●Refit locking screw so that it goes through

the hole in the clamp. Do not begin to

tighten the locking screw.

●Refer to the underside of the pad for the

part number.

Fitting Kit EN

K727

●It is important to put the pads in the correct

position on the vehicle.

●Letters refer to the pad part numbers and

position.

●Pad Part Number:

A = 293A

B = 294A

C = 295A

D = 296A

●Place rubber pads (supplied with fitting kit)

on the vehicle roof. Pad may vary in shape

to that shown.

●Make sure the pad fits into the holes

underneath the foot.

Fitting Kit EN

K727

Fitment

●Clamps directly to edge of roof under the

doors, pin locates in hole on vehicle

●Please check the rear of this manual for

information relating specifically to your

vehicle.

●Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

●Adjust the legs on the crossbar so that they

are positioned equally from the ends of the

crossbar, and the clamps engage firmly on

the body work of the vehicle.

●Tighten adjusting screw to 5 Nm (3.7 ft lb)

hand tight.

Fitting Kit EN

K727

●Tighten locking screw on both legs evenly.

●Check crossbar is securely attached to the

vehicle.

●Use keys to fit and lock covers

Table des matières

Autres manuels Prorack Accessoires automobiles

Prorack

Prorack K554 Manuel d'utilisation et d'installation

Prorack

Prorack K335 Manuel utilisateur

Prorack

Prorack K820 Manuel utilisateur

Prorack

Prorack K178 Manuel utilisateur

Prorack

Prorack K1255 Manuel utilisateur

Prorack

Prorack K903 Manuel utilisateur

Prorack

Prorack K426 Manuel utilisateur

Prorack

Prorack K1018 Manuel utilisateur

Prorack

Prorack K373 Manuel utilisateur

Prorack

Prorack K087 Manuel utilisateur

Prorack

Prorack K136 Manuel utilisateur

Prorack

Prorack K067 Manuel utilisateur

Prorack

Prorack K1104 Manuel utilisateur

Prorack

Prorack K328 Manuel utilisateur

Prorack

Prorack K1213 Manuel utilisateur

Prorack

Prorack K1173 Manuel utilisateur

Prorack

Prorack K1047 Manuel utilisateur

Prorack

Prorack K379 Manuel utilisateur

Prorack

Prorack K545 Manuel utilisateur

Prorack

Prorack PR3097 Manuel utilisateur

Prorack

Prorack K367 Manuel d'utilisation et d'installation

Prorack

Prorack K746 Manuel utilisateur

Prorack

Prorack K175 Manuel utilisateur

Prorack

Prorack K340 Manuel utilisateur

Manuels Accessoires automobiles populaires d'autres marques

James Baroud

James Baroud Odyssey Manuel utilisateur

Motorola

Motorola i50sx Manuel utilisateur

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuel utilisateur

Feniex

Feniex T3 Manuel utilisateur

Renault

Renault 77 11 423 180 Manuel utilisateur

Kia

Kia E8300-4D000 Manuel utilisateur

Brink

Brink 756843 Manuel utilisateur

Whispbar

Whispbar K085W Manuel utilisateur

v.link

v.link CI-VL2-PC-HSD Manuel utilisateur

Viking

Viking Stack-Rack Guide de configuration rapide

Aries

Aries 203015 Manuel utilisateur

Choetech

Choetech AT0005 Manuel utilisateur

ZZ2

ZZ2 ZZAIR-PRO Manuel utilisateur

Holman

Holman 4A80L Manuel utilisateur

Thule

Thule 2075 Manuel utilisateur

Motorola

Motorola T325 Manuel utilisateur

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guide d'installation

DV8

DV8 FBJL-02 Manuel utilisateur