Pathway TR-10 Operator’s Guide
Operation
• Turn Tr10 on.
• 1ST SCREEN: Battery light will illuminate and a light will indicate battery level.
LOW ON SCALE=LOW BATTERY; HIGH ON SCALE =GOOD BATTERY.
• 2ND SCREEN: Two lights will appear.
TOP LIGHT INDICATES SCALE; SCALE = 1-800
BOTTOM LIGHT INDICATES MODE; DEFAULTED TO CONTINUOUS MODE.
• 3RD SCREEN: TR10 then defaults to EMG Measurement Mode.
• To change scale press Akey.
TWO LIGHTS FLASH PROMPTING YOU TO MAKE CHANGES.
TOP LIGHT INDICATES SCALE.
TWO SCALES ARE AVAILABLE: 1-800 AND 1-30.
A LIGHT BY 800=1-800 SCALE; A LIGHT BY 30 =1-30 SCALE.
While lights are blinking, press down arrow to select 1-30 scale.
Press up arrow to select 1-800 scale.
NOTE THAT TR10 ONLY GIVES YOU ABOUT 4 SECONDS TO MAKE A SELECTION BEFORE
AUTOMATICALLY SELECTING THE SCALE INDICATED BY THE BLINKING LIGHT.
• To select Mode press A key
TWO LIGHTS FLASH PROMPTING YOU TO MAKE CHANGES.
BOTTOM LIGHT INDICATES MODE; READ THE WORDS TO THE LEFT:
Continuous (No work/Rest goals set; No Goals set)
Above (Goal) (When EMG level is ABOVE the Goal light, success tone sounds)
Below (Goal) (When EMG level is BELOW the Goal light, success tone sounds)
Work/Rest 5/10 (TR10 prompts user to work for 5 seconds, Rest for 10 seconds)
10/10 (TR10 prompts user to work for 10 seconds, Rest for 10 seconds)
• Press A key repeatedly to select desired mode.
NOTE THAT TR10 ONLY GIVES YOU ABOUT 4 SECONDS TO MAKE A SELECTION BEFORE
AUTOMATICALLY SELECTING THE MODE INDICATED BY THE BLINKING LIGHT.
• THE TR10 IS NOW IN EMG MEASUREMENT MODE AND THE SESSION HAS BEGUN.
• Use up and down arrows to adjust the goal that appears when using
Above, Below, Work/Rest 5/10, or Work/Rest 10/10.
4
