This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC part 15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
FCC part 15.407
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems.
FCC Part 407
The device shall automatically discontinue transmission in cases of absence of information to transmit, or operational failure.
Then it will scan the available radio signals. If this signal is connected before, it will be automatically connected, otherwise
manual connections will be necessary.
The end product must carry a label stating “Contains FCC ID: QAM-AP9-WIFIBT-AB”.
Limited Modular Approval
The devices must be installed and used in strict accordance with the manufacturer’s instructions as described in the user
documentation that comes with the product.
The module must be installed in an ActivPanel.
In the event that these conditions cannot be met (for example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used on the final product. In
these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
FCC ID: QAM-AP9-WIFIBT-AB.
This device complies with FCC part 15C: 15.247 and 15.407.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. The
module should be installed at a minimum distance of 20 cm away from a person nearby. The host product manufacturer should
state this information to the host instruction manual.
Trace antenna designs - not applicable.
ActivPanel 9 Wi-Fi and Bluetooth Module Quick Install Guide EN English 7
