Premier Mounts PRF-100 Manuel utilisateur

INSTALLATION INSTRUCTIONS

PRF-100

VESA Mount for 15” to 32” Flat-panels

NORTH AMERICA

3130 East Miraloma Avenue

Anaheim, CA 92806 USA

USA and Canada –

Phone: 800-368-9700

Fax: 800-832-4888

EUROPE

Unit 3, The Moorings Business Park,

Channel Way, Off Blackhorse Road, Exhall

Coventry, England CV6 6RH

Phone: +44 (0) 2476 614700

Fax: +44 (0) 2476 614710

Other Locations – Phone: (001)-714-632-7100; Fax: (001)-714-632-1044

©Premier Mounts 2011

9531-003-011-00

Page 2 Installation Instructions

Table of Contents

Warning Statements

PRF-100

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ AND

COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT PERSONAL INJURY AND

PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE

REFERENCE.

PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER MOUNTS

PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED

ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS,

ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER

RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

THE SURFACE MUST BE CAPABLE OF SUPPORTING AT LEAST FIVE TIMES THE WEIGHT OF THE Flat-panel. IF NOT, THE

MOUNTING STRUCTURE MUST BE REINFORCED. THE MAXIMUM WEIGHT THAT CAN BE USED WITH THIS PRODUCT

IS 50LBS. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE

INSTALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL

INJURY, OR EVEN DEATH.

SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE PROPER SAFETY

GEAR AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

Contact Premier Mounts with any questions

(800) 368-9700

[email protected]

At least two qualified people should perform the assembly procedure. Injury and/or damage can result from dropping or mishandling the

flat-panel.

If mounting to studs, make sure that the mounting screws are anchored into the center of the studs. Use of an edge-to-edge stud finder is

recommended.

Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there are no electrical wires

in wall. Cutting/drilling into an electrical line may cause serious injury.

Make sure there are no water lines inside the wall where the mount is to be located. Cutting/drilling into a water line may cause severe water

damage to the mounting surface.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.

Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of impact.

Warning Statements 2

Parts List 3

Installation Tools 3

Wood Stud Installation 4

Concrete Surface Installation 5

Cover Plate Installation 6

Flat-panel Installation 6

Technical Specifications 7

Warranty 8

Installation Instructions Page 3

Parts List

Congratulations on the purchase of your new Premier Mounts PRF-100 flat-panel mount. This

mount is shipped with all proper installation hardware and components. Make sure that none of these parts are

missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the

installation and contact Premier Mounts at (800) 368-9700.

Installation Tools (not supplied)

Phillips Screwdriver

PRF-100

1/8” Drill Bit Electronic Stud finder Drill Level

If your unit requires alternative mounting hardware, use commercially available hardware or contact Premier Mounts at

(800) 368-9700.

PRF-100 (Qty 1)

M4 x 10mm Combo

Head Screw (Qty 4)

M4 x 12mm Combo

Head Screw (Qty 4)

#10 Wall

Anchors (Qty 4)

#10 x 1-1/4” Screws

(Qty 4)

#10 x 2” Screws

(Qty 2)

M6 x 12mm Combo

Head Screw (Qty 2)

1/4” Drill Bit

Page 4 Installation Instructions

Step 3. Use an electronic stud finder to locate the

stud.

Step 4. Align the plate to the stud and visually

verify the flat-panel placement now that

the stud has been located.

Step 5. Once the center of the stud has been

located, mark the wall at the two (2)

screw hole locations.

Wood Stud Installation

Stud

Electronic

Stud finder

Mark

Center Line

Step 6. Use a 1/8” bit and create pilot holes where

the 2 markings were made.

1/8” Bit

Pilot Hole

Step 7. Insert two (2) #10 X 2” screws into

the pre-drilled pilot holes.

Step 8. Tighten the wall plate screws at this

time.

Drill

#10 x 2” Screws

Step 1. Place the wall plate against the wall with

the directional arrow pointing up.

Step 2. Use a pencil to make a mark in the center

of the visual centering diamond. This will

be the center position of the flat-panel.

Visual Centering Diamond

Directional Arrow

PRF-100

Visual Stud Guide - The visual stud guide will allow you to determine exactly where both edges of the wood stud is within the wall.

Once both edges of the wood stud have been located, the visual centering diamond will be directly over the exact

center of the wood stud. Once the plate is in this position, the two mounting holes may be marked.

Visual Centering Diamond - The visual centering diamond will allow you to determine the center of the wood stud. It will also allow

you to determine the exact center for the flat-panel placement on the wall. The visual centering diamond

will work in conjunction with the visual stud guide.

Visual Stud Guide

Prior to installation, remove the cover plate and two (2) M6 x 75mm Phillips head locking screws from the PRF-100.

Installation Instructions Page 5

Concrete Surface Installation

Screwdriver

#10 x 1-1/4” Screw

#10 Anchor

Pilot Hole

1/4” Bit

Step 1. Use the visual centering diamond

to help determine the placement of the

back plate.

Step 2. Once the mounting placement has

been determined, use a pencil to mark

the mounting points.

Step 3. Drill the mounting holes using a 1/4”

drill bit where the pencil marks have

been made.

Step 4. Place the #10 anchor into the hole

and tap into place.

Step 5. Place the backplate over the inserted

#10 anchors.

Step 6. Insert four (4) #10 x 1-1/4” screws

into the #10 anchors and tighten using

a Phillips tip screwdriver.

Solid SurfaceCinder Block

Pilot Hole

PRF-100

You will have four (4) mounting

holes when installing into concrete.

Page 6 Installation Instructions

PRF-100

Step 1. Re-attach the M6 x 75mm Phillips head

locking screws to the cover plate.

If the flat-panel is not long

enough to cover the length of the

M6 x 75mm screws, replace them with

two (2) M6 x 12mm combo head

screws.

M4 x 10mm combo

head screw

Cover Plate

Securing Screw

Mounting Point

Flat-panel

Slotted Opening

DO NOT OVERTIGHTEN THE

MOUNTING SCREWS

Cover Plate Installation

Flat-panel Installation

Solid Surface Cinder Block

Step 1. Lower the flat-panel onto the wall plate so

that the mounting tab is inserted into the

mounting slot.

Mounting

Slot

Mounting

Tab

Do not release the display until you are

sure the flat-panel is resting securely on

the wall plate.

Step 2. Secure the two plates by inserting and

tightening the two head locking screws

located at the bottom of the cover plate.

Use a Phillips head screwdriver to

tighten these screws.

Head Locking

Screws

Solid SurfaceCinder Block

Screwdriver

The cover plate mounting slot must

be facing up.

Step 2. Secure the cover plate to the flat-panel

using four (4) M4 x 10mm combo head

screws.

The slotted opening of the cover plate must

be facing up and the flat surface touching

the flat-panel surface.

If the threading on the flat-panel is too

deep, use four (4) M4 x 12mm combo

head screws instead.

Installation Instructions Page 7

PRF-100

Technical Specifications

All measurements are in inches [mm].

Please refer to the hardware pack

that is included with the PRF-100 to

determine the correct mounting

hardware for your application.

NOTE: A. 100 X 100 VESA Pattern

B. 75 X 75 VESA Pattern

100mm

75mm

B B

3.95

100

2.95

3.95

100

2.95

1.75

3.00

5.50

140

8.01

203

.49

2.75

3.50

Ø.20

53.31

Page 8 Installation Instructions

PRF-100

Warranty

PREMIER MOUNTS

LIMITED LIFETIME WARRANTY

What and Who is Covered by this Limited Warranty and for How Long

Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of

the original owner of this product. The limited warranty is valid only for the original purchaser of the product.

What Premier Mounts Will Do

At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product part that is

defective. If Premier Mounts chooses to replace a defective product or part, a replacement product or part will

be shipped to you at no charge, but you must pay any labor costs.

What is Not Covered; Limitations

PREMIER MOUNTS DISCLAIMS ANY LIABILITY FOR DAMAGE TO MOUNTS, ADAPTERS, DIS-

PLAYS, PROJECTORS, OTHER PROPERTY, OR PERSONAL INJURY RESULTING, IN WHOLE OR IN

PART, FROM IMPROPER INSTALLATION, MODIFICATION, USE OR MISUSE OF ITS PRODUCTS.

PREMIER MOUNTS DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. PREMIER

MOUNTS IS NOT RESPONSIBLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUD-

ING BUT NOT LIMITED TO, INABILITY TO USE ITS PRODUCTS OR LABOR COSTS FOR REMOV-

ING AND REPLACING DEFECTIVE PRODUCTS OR PARTS. SOME STATES DO NOT ALLOW THE

EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE

LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.

What Customers Must Do for Limited Warranty Service

If you discover a problem that you think may be covered by the warranty you MUST REPORT it in writing to

the address below within thirty (30) days. Proof of purchase (an original sales receipt) from the original con-

sumer purchaser must accompany all warranty claims. Warranty claims must also include a description of the

problem, the purchaser’s name, address, and telephone number. General inquiries can be addressed to Premier

Mounts Customer Service at 1-800-368-9700. Warranty claims will not be accepted over the phone or by fax.

Premier Mounts

Attn: Warranty Claim

3130 East Miraloma Ave.

Anaheim, CA 92806

How State Law Applies

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER

RIGHTS WHICH VARY FROM STATE TO STATE.

Table des matières

Autres manuels Premier Mounts Support TV

Premier Mounts

Premier Mounts Rotary series Manuel utilisateur

Premier Mounts

Premier Mounts PSD-BW Manuel utilisateur

Premier Mounts

Premier Mounts CTM-200 Manuel utilisateur

Premier Mounts

Premier Mounts PTFM3765 Manuel utilisateur

Premier Mounts

Premier Mounts AM300-B Manuel utilisateur

Premier Mounts

Premier Mounts CTM-MS4 Manuel utilisateur

Premier Mounts

Premier Mounts PaneLock Manuel utilisateur

Premier Mounts

Premier Mounts PFDM1 Manuel utilisateur

Premier Mounts

Premier Mounts GB-INWAVP Manuel utilisateur

Premier Mounts

Premier Mounts PCM-MS2 Manuel utilisateur

Premier Mounts

Premier Mounts PMC-MM-500 Manuel utilisateur

Premier Mounts

Premier Mounts PSD-TTS/B Manuel utilisateur

Premier Mounts

Premier Mounts FTP-096 Manuel utilisateur

Premier Mounts

Premier Mounts GB-ENCL42 Manuel utilisateur

Premier Mounts

Premier Mounts CTM-33 Manuel utilisateur

Premier Mounts

Premier Mounts 7170-0978 Series Manuel utilisateur

Premier Mounts

Premier Mounts TWM-103 Manuel utilisateur

Premier Mounts

Premier Mounts AM500-U Manuel utilisateur

Premier Mounts

Premier Mounts AM250 Manuel utilisateur

Premier Mounts

Premier Mounts POH46-EX Manuel utilisateur

Premier Mounts

Premier Mounts LIFT1 Manuel utilisateur

Premier Mounts

Premier Mounts AM100 Manuel utilisateur

Premier Mounts

Premier Mounts ECM-D70T Manuel utilisateur

Premier Mounts

Premier Mounts PWM-503 Manuel utilisateur

Manuels Support TV populaires d'autres marques

Ergotron

Ergotron Neo Flex Cantilever UHD Manuel utilisateur

StarTech.com

StarTech.com FPCEILBTB Manuel utilisateur

VonHaus

VonHaus 05/038 Manuel utilisateur

Techlink

Techlink ECHO TV Manuel utilisateur

Sandstrom

Sandstrom SSTVMC12X Manuel utilisateur

Sony

Sony SU-WL700 Mode d’emploi

ICW

ICW SCACC18 Manuel utilisateur

LG WM-L640V Manuel utilisateur

Gembird

Gembird WM-65ST-01 Manuel utilisateur

ERARD

ERARD FiTUP XXL 035320 Manuel utilisateur

PEERLESS

PEERLESS PLCK-1 Mode d’emploi

Kanto

Kanto RCF180 Manuel utilisateur

GEM

GEM GEM GP001 Manuel utilisateur

Gladiator Joe

Gladiator Joe GJ0A0053 Manuel utilisateur

Vivotek

Vivotek AM-105 Manuel utilisateur

Vivo

Vivo VESA STAND-VAD1B Manuel utilisateur

AmazonBasics

AmazonBasics B07QG3LMG4 Manuel utilisateur

Secura

Secura QLF210 Manuel utilisateur