Planet VC-200S Manuel utilisateur

VDSL2 Router

VC-200M / VC-200S

User’s Manual

this publication may be reproduced, transmitted, transcribed, stored in a retrieval

system, or translated into any language or computer language, in any form or by any

means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise,

without the prior written permission of PLANET.

PLANET makes no representations or warranties, either expressed or implied, with

respect to the contents hereof and specifically disclaims any warranties,

merchantability or fitness for any particular purpose. Any software described in this

manual is sold or licensed "as is". Should the programs prove defective following

their purchase, the buyer (and not this company, its distributor, or its dealer) assumes

the entire cost of all necessary servicing, repair, and any incidental or consequential

damages resulting from any defect in the software. Further, this company reserves

the right to revise this publication and to make changes from time to time in the

contents hereof without obligation to notify any person of such revision or changes.

All brand and product names mentioned in this manual are trademarks and/or

registered trademarks of their respective holders.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

4. Consult the dealer or an experienced radio technician for help.

FCC Caution:

To assure continued compliance (example-use only shielded interface cables when

connecting to computer or peripheral devices). Any changes or modifications not

expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

Following two conditions: (1) This device may not cause harmful interference, and (2)

this Device must accept any interference received, including interference that may

cause undesired operation.

R&TTE Compliance Statement

This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF

THE EUROPEAN PARLIAMENT AND THE COUNCIL OF 9 March 1999 on

radio equipment and telecommunication terminal Equipment and the mutual

recognition of their conformity (R&TTE)

The R&TTE Directive repeals and replaces in the directive 98/13/EEC

(Telecommunications Terminal Equipment and Satellite Earth Station Equipment)

As of April 8, 2000.

WEEE

To avoid the potential effects on the environment and human health as a

result of the presence of hazardous substances in electrical and electronic

equipment, end users of electrical and electronic equipment should

nderstand the meaning of the crossed-out wheeled bin symbol. Do not

dispose of WEEE as unsorted municipal waste and have to collect such

WEEE separately.

Safety

This equipment is designed with the utmost care for the safety of those who install

and use it. However, special attention must be paid to the dangers of electric shock

and static electricity when working with electrical equipment. All guidelines of this

and of the computer manufacture must therefore be allowed at all times to ensure the

safe use of the equipment.

Revision

User’s Manual for VDSL2 Router

Model: VC-200M / VC-200S

Rev: 2.0 (March 2008)

Part No. EM-VC200

Table of Contents

CHAPTER 1 INTRODUCTION................................................................................7

1.1 Feature...............................................................................................................7

1.2 Package Contents ..............................................................................................8

1.3 Physical Details.................................................................................................8

CHAPTER 2 HARDWARE INSTALLATION......................................................10

2.1 System Requirement .......................................................................................10

2.2 Hardware Installation......................................................................................10

2.3 Configuring the Network Properties...............................................................11

CHAPTER 3 CONFIGURATION...........................................................................17

3.1 Determine your connection settings................................................................17

3.2 Connecting the VDSL2 Router to your network.............................................17

3.3 Configuring with Web Browser......................................................................18

3.4 Quick Installation............................................................................................18

3.5 Configuration Menu for Administrator...........................................................24

3.5.1 Setup Wizard .........................................................................................25

3.5.2 Advanced Setup.....................................................................................25

3.5.3 System ...................................................................................................26

3.5.3.1 Host Name Config .......................................................................26

3.5.3.2 System Time ................................................................................27

3.5.3.3 Administrator Settings.................................................................28

3.5.3.4 Device Mode................................................................................28

3.5.3.5 Firmware Upgrade.......................................................................29

3.5.3.6 System Status...............................................................................29

3.5.3.7 System Logs.................................................................................30

3.5.3.8 Reset.............................................................................................31

3.5.4 WAN......................................................................................................32

3.5.4.1 Dynamic IP ..................................................................................32

3.5.4.2 Static IP........................................................................................33

3.5.4.3 PPPoE ..........................................................................................34

3.5.4.4 DNS..............................................................................................35

3.5.5 LAN.......................................................................................................36

3.5.5.1 LAN Setting.................................................................................37

3.5.5.2 DHCP Client List.........................................................................38

3.5.6 NAT.......................................................................................................38

3.5.6.1 Virtual Server...............................................................................39

3.5.6.2 Port Mapping ...............................................................................40

3.5.6.3 DMZ.............................................................................................41

3.5.7 Route......................................................................................................42

3.5.7.1 Static Route..................................................................................43

3.5.7.2 Routing Table List .......................................................................44

3.5.8 UPnP......................................................................................................45

3.5.8.1 Settings.........................................................................................45

CHAPTER 4 OPERATING THE VDSL2 SYSTEM.............................................46

4.1 Configuration Settings.....................................................................................46

4.1.1 Channel Configuration ..........................................................................47

4.1.2 Line Configuration ................................................................................48

4.1.3 Profile Configuration.............................................................................49

4.1.4Active.....................................................................................................51

4.1.5 Channel Status.......................................................................................51

4.1.6 Version Information ..............................................................................52

APPENDIX A THROUGHPUT TEST FOR VDSL2 PROFILES........................53

APPENDIX B GLOSSARY......................................................................................54

Chapter 1 Introduction

The PLANET VDSL2 Router, VC-200M / VC-200S is based on two core networking

technologies: Ethernet and VDSL2 (Very High Speed Digital Subscriber Line 2). This

technology offers the absolute fastest possible data transmission speeds over existing

copper telephone lines without the need for rewiring.

The ideal situation, the date rate of VDSL2 can up to 40Mbps upstream and 100Mbps

downstream.

The VC-200M / VC-200S supports ITU-T G993.2, and provide selectable operating

mode of bridging and routing.

Via the user-friendly management interface, VC-200M / VC-200S can be managed by

computer running standard web browsers. Furthermore, VC-200M / VC-200S provides

DHCP server, NAT, virtual server, DMZ, DNS proxy, and UPnP capability. It provides

the natural firewall function (Network Address Translation, NAT). All incoming and

outgoing IPs are monitored and filtered

VC-200M / VC-200S provide 4-port 10/100 Ethernet switch, it provide data deliver and

receive in local network, so that it is the best selection for small enterprise and

residence.

1.1 Feature

Internet Access Features

Shared Internet Access. All users on the LAN can access the

Internet through the VC-200M / VC-200S using only a single external

IP Address. The local (invalid) IP Addresses are hidden from external

sources. This process is called NAT (Network Address Translation).

Built-in VDSL2 modem. The VC-200M/VC-200S provides VDSL2

modem, and supports all common VDSL2 connections.

Fixed or Dynamic IP Address or PPPoE. On the Internet (WAN

port) connection, the VC-200M / VC-200S supports both Dynamic IP

Address (IP Address is allocated on connection) and Fixed IP Address.

Advanced Internet Functions

Virtual Servers. This feature allows Internet users to access Internet

servers on your LAN. The required setup is quick and easy.

Firewall. Supports simple firewall with NAT technology.

Universal Plug and Play (UPnP) UPnP allows automatic discovery

and configuration of the Broadband Router. UPnP is supported by

Windows ME, XP, or later.

Selectable VDSL2 transmission modes. User can choose

transmission modes (8a,8b,12a,12b,and 17a) through management

interface on VC-200M / VC-200S

User Friendly Interface. VC-200M / VC-200S can be managed and

controlled through Web UI.

LAN Features

4-Port Switch. The VC-200M / VC-200S incorporates a 4-port

10/100BaseT switching hub, making it easy to create or extend your LAN.

DHCP Server Support. Dynamic Host Configuration Protocol provides a

dynamic IP address to PCs and other devices upon request. The VC-200M /

VC-200S can act as a DHCP Server for devices on your local LAN.

1.2 Package Contents

‧ VC-200M / VC-200S Unit

‧ Power Adapter

‧ Quick Installation Guide

‧ User’s Manual CD

‧ RJ-11cable

‧ RJ-45 cable

1.3 Physical Details

Front Panel

VC-200M front panel

VC-200S front panel

Front Panel LED definition

LED State Description

ON When the router is powered on, and in ready

state.

PWR

OFF When the router is powered off.

Flashing

Router is trying to establish a connection

between VC-200M and VC-200S, or telecom’s

network.

LNK

Successfully connected between VC-200M

and VC-200S, or router and telecom's network,

and in ready state.

DSL

ACT Flashing Data is being transmitted or received.

LNK/ACT Flashing/ON Data is being transmitted or received via the

corresponding LAN port, and in ready state.

LAN

1-4 100 ON Orange color, it corresponding LAN port is

using 100BaseT.

Rear Panel

Rear panel Port and Button Definition

Connector Description

POWER Power connector with 12V DC 1 A

RESET

Button

Press 1-3 seconds for reboot system.

Press more than 5 seconds for reset to factory default setting.

LAN (1-4)

Router is successfully connected to a device through the corresponding

port (1, 2, 3, or 4). If the LED light of LNK/ACT is flashing, the Router

is actively sending or receiving data over that port.

PHONE The RJ-11 connector allows voice communication between the router

and phone through a twisted-pair phone wire.

VDSL2 The RJ-11 connector allows data communication between the router and

the VDSL2 network through a twisted-pair phone wire

Chapter 2 Hardware Installation

This chapter offers information about installing your router. If you are not familiar with

the hardware or software parameters presented here, please consult your service

provider for the values needed.

2.1 System Requirement

1. Personal computer (PC)

2. Pentium II 233 MHz processor minimum

3. 32 MB RAM minimum

4. 20 MB of free disk space minimum

2.2 Hardware Installation

This section describes how to connect and configure VC-200M/VC-200S.

To PC/Hub To VDSL2/Phone Line

Power Adapter

Step 1. Connect the VDSL2 Line

There are two ways to connect VC-200M or VC-2000S.

I. Connect the supplied RJ11 cable to VDSL2 ports between VC-200M and

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Planet Routeur réseau

Planet

Planet FSD-1603 Manuel utilisateur

Planet

Planet WGSW-2620PV Manuel utilisateur

Planet

Planet VDR-300NU Manuel utilisateur

Planet

Planet VRT-402N Manuel utilisateur

Planet

Planet FSD-805 Manuel utilisateur

Planet

Planet IGS-20040MT Manuel utilisateur

Planet

Planet EH-2400 Manuel utilisateur

Planet

Planet SW-504 Manuel utilisateur

Planet

Planet ADE-3400 Manuel utilisateur

Planet

Planet EPN-104 Manuel utilisateur

Planet

Planet ADE-3100 Manuel utilisateur

Planet

Planet ADSL 2/2+ Router with USB Port ADE-3410v2 Manuel utilisateur

Planet

Planet VR-100 Series Manuel utilisateur

Planet

Planet ADSL 2/2+ Router ADE-3400v2 Manuel utilisateur

Planet

Planet WAP-200N Manuel utilisateur

Planet

Planet WGS-804HPT Manuel utilisateur

Planet

Planet FGSW-1822VHP Manuel utilisateur

Planet

Planet ADSL 2/2+ VPN Firewall Router ADW-4302A v2 Manuel utilisateur

Planet

Planet PL-802 Manuel utilisateur

Planet

Planet MGSW SERIES Manuel utilisateur

Planet

Planet PL-501-EU Manuel utilisateur

Planet

Planet FNSW-4800 Manuel utilisateur

Planet

Planet 85M Powerline to Ethernet Bridge with 4-Port Switch... Manuel utilisateur

Planet

Planet ADSL Firewall Router ADE-4120 Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité