Pelonis PHTA8AWB Manuel utilisateur

145x210mm

PHTA8AWB

IMPORTANT INSTRUCTIONS

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances,basic precautions should always be followed to

reduce the risk of fire,electric shock,and injury to persons,including the following:

1. Read all instructions before using heater.

2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot

surface. If provided, always use handles when moving this heater. Keep

combustible materials such as furniture, pillows, bedding, papers, clothes and

curtains at least 3 feet (0.9m) from the front of the heater and keep them away

from the sides and rear.

3. Extreme caution is necessary when any heater is used by or near children or

invalids and whenever the heater is left operating and unattended.

4. Always unplug the heater when not in use.

5. Do not operate any heater with a damaged cord or plug or after the heater

malfunctions, has been dropped or damaged in any manner. Discard heater or

return heater to authorized service facility for examination, electrical or

mechanical adjustment, or repair.

6. Do not use the heater outdoors.

7. This heater is not intended for use in bathroom, laundry areas and similar moist

indoor locations. Never locate heater where it may fall into a bathtub or other

water container.

8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,

or similar coverings. Do not route cord under furniture or appliances. Arrange

cord away from traffic area and where it will not be tripped over.

CAUTION:

This appliance has a polarized plug (one blade is wider than the

other). To reduce the risk of shock, this plug is intended to fit only one way in a

polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it

still does not fit, contact a qualified electrician. DO NOT attempt to defeat this

safety feature. To do so could result in an electric shock hazard.

10. This heater draws 12.5 amps during operation. To prevent overloading a

circuit, do not plug the heater into a circuit that already has other appliances

working.

11.

CAUTION:

It is normal for the plug to feel warm to the touch; however, a loose

fit between the AC outlet (receptacle) and plug may cause overheating and

distortion of the plug. Contact a qualified electrician to replace loose or worn

outlet.

12. To disconnect the heater, first turn controls to off, then remove plug from

outlet. Never pull by the cord.

13. Do not insert or allow foreign objects to enter any ventilation or exhaust

opening as this may cause an electric shock or fire, or damage the heater.

14. To prevent a possible fire, do not block air intakes or exhaust in any manner.

Do not use on soft surface, like a bed, where openings may become blocked.

15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas

where gasoline, paint, or flammable liquids are used or stored.

16. Use this heater only as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock, or injury to

persons.

17.

CAUTION:

Always plug heaters directly into a wall outlet/receptacle. Never

use with an extension cord or reloadable power tap (outlet/power strip).

18. The output of this heater may vary and its temperature may become intense

enough to burn exposed skin. Use of this heater is not recommended for

persons with reduced sensitivity to heat or an inability to react to avoid burns.

19. Disposal of oil contained within should be in accordance with applicable

regional, national, and local laws and regulations.

20.

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF

PLUG TO WIDE SLOT AND FULLY INSERT.

21. “SAVE THESE INSTRUCTIONS”

Control panel

Rear shell

Air outlet

Display screen

How to use

Pre-startup check

1. If power line is in good condition.

2. Product power is 120V AC, bearing capacity of product socket is no lower than 12.5A;

otherwise, accidents would occur.

【Starting up】

Turn power switch to “I” marked position, then press on-off key on the control panel to

start up the machine. After starting up, the machine runs on the mode of last power off.

Remote-control

unit take-in

PART FIGURE

“+”key

On-off key

“-”key

Timing key Mode key

Sway key

In the power-on mode, press this key to select the timed shutdown setting. The timing indicator lights

up, the temperature display icon lights off, and display screen blinks and shows the rest time of last

setting. Press “+” or “-” keys to set shutdown time, the setting range is 0~24 hours. The machine

confirms the time and quits the timing setting state if without pressing within 5 seconds. If the set time

is 0, it means cancelling the timing setting; if the set time is not 0, the machine shuts down

automatically, enter the idle mode and turns off the timing icon when reaching the set time. Set again

the time after time setting, and the machine is retimed.

In the idle mode, press this key to set timing power-on, of the same operation as timing shutdown.

The time unit of the timer is hour.

On the idle mode, press on-off key to enter the power-on mode, the warmer starts working and the whole machine

runs under the previous remembered mode and temperature. On the power-on mode, press on-off key to enter the

idle mode, the warmer stops working. (Note: On the heating mode, draught fan will operate for 15 seconds at low

wind speed after power off.)

After power repeatedly press the “mode key”, the warmer shifts in circular order among

“energy saving mod, breeze, low warm wind,and high warm wind”.

Key Function Description

In the power-on mode, press this key to start swaying, and press again to stop swaying.

On-off key

Mode key

On the working state, press “+” or “-” keys to set the working temperature. The temperature

setting range is 40℃~95℃ and every temperature value is of 1℃ difference. The machine confirms and

displays the set temperature value if without operation within 3 seconds after the setting. After room

temperature reaches the set temperature, display screen blinks for 10 seconds and heating unit stops

working; when temperature is below the set temperature, machine restarts to heat.

+ and - key

Timing key

Sway key

F F F

Display screen

1. Press down on the battery compartment cover

and slide it out.

2. Use 2 "AAA" batteries (Not Included)

3. Insert the batteries, making sure that the positive

terminals are facing the proper way.

4. Replace the cover.

BATTERIES INSTRUCTIONS

(not included)

1. Do not dispose of batteries in fire, batteries may

explode or leak.

2. Do not mix old and new batteries.

3. Do not mix alkaline, standard (carbon-zinc) or

rechargeable (nickel-cadmium) batteries.

4. Non-rechargeable batteries are not to be recharged.

5. Batteries are to be inserted with the correct polarity.

6. Exhausted batteries are to be removed from the product.

7. The batteries must be removed from the remote controller before it is scrapped

and that they are disposed of safely.

BATTERY WARNING

< >

Troubleshooting

If the product does not operate or does not operate properly, first check according to the following

list. If the reason the product does not operate or does not operate properly is not included in the

following list, the product mayhave failed. At this time, it is recommended to send the product to

the dealer for treatment

Problem Possible Cause Soluon

Aer the power is

engaged,the machine does

not work.

The plug may not be

plugged well.

Check whether the plug is

properly inserted into the

receptacle.

READ AND SAVE THESE INSTRUCTIONS

The machine suddenly

stops during heang.

The temperature exceeds

the threshold of the

thermal cut- o.

Cool the machine before

use.

MAIN TECHNOLOGY SPECIFICATIONS

MODEL LOW HIGH

POWER REGULATION RANGE (W)

NTH15-18AR 800 1500

Power supply: AC 120V~ 60Hz

Email: [email protected]

5 Sylvan Way Parsippany, NJ 07054

Table des matières

Autres manuels Pelonis Chauffage

Pelonis

Pelonis NF15-9BMB Manuel utilisateur

Pelonis

Pelonis NY1506-18SRA Manuel utilisateur

Pelonis

Pelonis HF-0023 Manuel utilisateur

Pelonis

Pelonis PHTPU1501WC Manuel utilisateur

Pelonis

Pelonis PSH20Q3ABB Manuel utilisateur

Pelonis

Pelonis HF-0063 Manuel utilisateur

Pelonis

Pelonis NTH15-17MR Manuel utilisateur

Pelonis

Pelonis HC-0155M Manuel utilisateur

Pelonis

Pelonis PTH15A2BGB Manuel utilisateur

Pelonis

Pelonis PSH700 Manuel utilisateur

Pelonis

Pelonis PSH23FT3DSBC Manuel utilisateur

Pelonis

Pelonis Safe-T FURNACE HC-445 Manuel utilisateur

Pelonis

Pelonis HO-201 Manuel utilisateur

Pelonis

Pelonis HC-0119A Manuel utilisateur

Pelonis

Pelonis PSHF2022EOC Manuel utilisateur

Pelonis

Pelonis NTH15-18MR Manuel utilisateur

Pelonis

Pelonis HF-0019 Manuel utilisateur

Pelonis

Pelonis PSH700G Manuel utilisateur

Pelonis

Pelonis PSH700R Manuel utilisateur

Pelonis

Pelonis HT-0605 Manuel utilisateur

Pelonis

Pelonis HC-0113 Manuel utilisateur

Pelonis

Pelonis HC-0119A Manuel utilisateur

Pelonis

Pelonis NTK15A Manuel utilisateur

Pelonis

Pelonis HC-451 Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur