Overland Storage NEO 200S Manuel utilisateur

*10400372001*

NEO®200s/400s

Spare Power Supply Instructions

This document describes how to remove and replace a power

supply module in a NEO 200s/400s library from Overland

Storage.

WARNING: To reduce the risk of electric shock or damage to

equipment, always remove any power cords while working

with the unit.

AVERTISSEMENT: Pour réduire le risque de choc électrique ou

endommagement de l'équipement, retirez toujours les cordons

électriques en travaillant avec l'appareil.

CAUTION: While working with the unit, observe standard

Electrostatic Discharge (ESD) precautions to prevent damage

to micro-circuitry or static-sensitive devices.

Remove Old Power Supply

1. Power OFF the library by pressing and holding down the

power button on the front for four seconds.

2. Disconnect any power cords from the electrical source,

then from the library.

3. Loosen the three blue captive thumbscrews on the

defective power supply.

4. Pull on two of the thumbscrews to pull the unit away from

the rear panel of the library, then grasp the top and

bottom edge of the power supply and pull it out of the

library.

Install New Power Supply

1. Grasp the top and bottom edge of the power supply and

push it into the empty bay in the library.

2. Tighten the three blue captive thumbscrews () on

the power supply to secure it.

3. Connect all the power cords to the library (), then to

the electrical source.

http://support.overlandstorage.com

You can get additional technical support on the Internet at the Overland Storage Support web page, or by contacting Overland Storage using

the information found on the Contact Us page on our web site.

Spare Power Supply Instructions

Complete the Exchange

Validate the System

1. Power ON the library using the power button () on the

front panel.

2. From the Operator Control Panel (), run the Library

Verify test. (Service > Library Verify).

The verify test requires the use of a scratch (blank)

cartridge. Insert it using the Mail Slot.

3. Do one of the following:

•If the test passes, remove the cartridge, Cancel to exit

Library Verify, and resume normal operations.

•If the test fails, an error code will be displayed. Make

note of the error, then refer to the Troubleshooting

chapter in the NEO 200s/400s User Guide for

additional instructions.

Return Old Part to Overland

For return shipping details and RMA number, go to:

http://docs.overlandstorage.com/return-instructions

1. Place the old part in the anti-static bag and put it in the

replacement part’s box.

2. Use a return merchandise authorization (RMA) number to

return the part to Overland Storage.

Autres manuels pour NEO 200S

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Overland Storage Stockage

Overland Storage

Overland Storage NEO 8000 Manuel utilisateur

Overland Storage

Overland Storage SnapServer Manuel de service

Overland Storage

Overland Storage NEO 8000 Manuel utilisateur

Overland Storage

Overland Storage Neo Series 2000 Manuel utilisateur

Overland Storage

Overland Storage NEO 8000 Manuel utilisateur

Overland Storage

Overland Storage NEO 8000E Manuel utilisateur

Overland Storage

Overland Storage NEO 4000e Manuel utilisateur

Overland Storage

Overland Storage NEO 8000E Manuel utilisateur

Overland Storage

Overland Storage SnapServer Manuel utilisateur

Overland Storage

Overland Storage REO Series Manuel utilisateur

Overland Storage

Overland Storage PowerLoader Manuel utilisateur

Overland Storage

Overland Storage LoaderXpress Mode d’emploi

Overland Storage

Overland Storage Tandberg Data RDX QuikStor Manuel utilisateur

Overland Storage

Overland Storage NEO Series Manuel utilisateur

Overland Storage

Overland Storage SnapSAN S3000 Manuel de service

Overland Storage

Overland Storage ARCvault Series Mode d’emploi

Overland Storage

Overland Storage SnapServer DX1 Manuel utilisateur

Overland Storage

Overland Storage ULTAMUS Manuel

Overland Storage

Overland Storage Ultamus Raid 1200 Manuel utilisateur

Overland Storage

Overland Storage SnapServer DX2 Manuel utilisateur

Overland Storage

Overland Storage SnapServer XSD 40 Manuel utilisateur

Overland Storage

Overland Storage NEO 2000e Manuel utilisateur

Overland Storage

Overland Storage NEO 400S Manuel utilisateur

Overland Storage

Overland Storage NEO S-Series Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur