Orbit Starlite SL3 Manuel utilisateur
1
Contents
I. IMPORTANT PRECAUTIONS................................................................(1)
II. PRODUCT SPECIFICATION ……….............................................…….…(3)
III. ASSEMBLY…………...……………………......................................………....(4)
IV.WORKOUT GUIDELINES …………................................…………...........(7)
V.TREADMILL OPERATION………….…................................................….(8)
VI. MAINTENANCE…………...................................…………………….(9)-(10)
VII. RECYCLING INFORMATION.........…………...............................…..…….(11)
VIIl.ERRORS AND TROUBLESHOOTING ...............………………………(11)
IX. EXPLODED VIEW and PARTS LIST........................................(12)-(14)
2
WARNING:
PLACE SAFETY KEY WITH MAGNET ONTO TREADMILL CONSOLE. ATTACH CLAMP TO
CLOTHING FIRMLY. THIS TREADMILL WILL NOT START WORKING UNTIL THE SAFETY KEY
IS IN PLACE.
LUBRICATE TREADMILL RUNNING DECK WITH SILICON OIL AS SET OUT IN MAINTENANCE
GUIDE. ALWAYS SWEEP DUST OFF DECK SURFACE AND UNDERNEATH RUNNING BELT
BEFORE LUBRICATION.
KEEP THE ORIGINAL PACKING, INCLUDING CARDBOARD BOX AND POLYTHENE FOAMS,
ALONG WITH YOUR PURCHASE RECEIPT AND USER MANUAL DURING THE PRODUCT
WARRANTY PERIOD. YOU MAY NEED THE PACKING TO FREIGHT THE TREADMILL BACK TO
OUR SERVICE DEPARTMENT.
To avoid risk of severe injuries, read carefully all the important instructions and warnings regarding the use of this
treadmill before using it.
MINIMUN
USER
HEIGHT
140 cm
MAX
USER
WEIGHT
100 kg.
I.IMPORTANT PRECAUTIONS
3
IMPORTANT SAFETY PRECAUTIONS
WARNING: Before starting any exercise program, consult your physician or health
professional，especially for person who is above 35 years old or had some health problems
before. Neither manufacturer nor distributor should be held responsible for any injuries or
discomfort by the user due to above reasons.
Don't plug in power until you finish assembling the treadmill.
ATTENTIONS:
1. When using this treadmill, attach the safety key pull pin to your clothes or belt.
2. Do not plug anything into any parts of this treadmill, or it may cause damage.
3. Position treadmill on a clean, level surface. Do not place the treadmill on thick carpet as it
may interfere with proper ventilation. Whereby necessary, use a rubber or PVC treadmill mat.
Do not place treadmill near water or outdoors, moisture will cause damage to electronics.
4. Do not start the treadmill while standing on the walking belt. After turning the power on and
adjusting the speed control, there may be a few seconds before the walking belt begins to
move, always stand on the foot rails on the sides of the frame until the belt is moving. Hold
onto handrails when initially start walking or running on the treadmill, let go until you are
comfortable with its speed.
5. Wear appropriate clothing when exercising on the treadmill. Do not wear long, loose fitting
clothing that could be caught in the treadmill. Always wear running or aerobic shoes with
rubber soles.
6. Keep small children and pets away from the treadmill while switched on.
7. This treadmill is designed for adult use, children intent to use the treadmill must have adult
supervision.
8. The power cord of motorized treadmill is specialized for its purpose. Do not attempt to
modify or repair it yourself. Do not place heavy object on power cord or leave it near high
temperature, only plug it into well earthed power point. If it is damaged, please purchase new
from distributor or contact our company directly for advice.
9. If case of an electrical failure or safety key being pulled from its pot during exercise, this
treadmill may come to a stop in 3-4 seconds. Hold onto hand rail until it completely stops and
step down through the side foot rails. Do not attempt to jump off the treadmill while it’s still in
motion.
10. When the treadmill is not being used, unplug power cord and remove safety key. Keep it in
a safe indoor place and do not use it for other purpose.
11. This treadmill is designed for home use only with maximum user weight 100kg. It is
improper to put it into a corporate or commercial environment and it won’t be covered by its
domestic warranty.
4
II. PRODUCT SPECIFICATION
Input Voltage
240V±10%
Frequency
50/60 Hz
Running area
1210X460mm
Function
Time, Speed, distance, Calorie, heart rate, Bluetooth & bluetooth
speaker
Speed Range
1.0-13.5km/h
Incline
No incline
Max user weight
100kgs
Power
1.0 CHP
5
III.ASSEMBLY
STEP 1
1. Lift treadmill out of box by two people and place it lightly on a flat surface, take protective polythene
foams off and put back inside box. Keep fittings nearby.
2. Lift up upright posts as shown in diagram and lock them with 2pcs of M10 knob screws on both sides.
Main
Part
Q'ty
1.Main frame
1set
No.
Fittings
Q’ty
No.
Fittings
Q’ty
M8 Knob
2
⑥
5mm Wrench
1
M10 Knob
2
⑦
6mm Wrench
1
Silicone oil
1
⑧
Multi Wrench
1
④
Safety Key
1
○
9
User Manual
1
⑤
M6*10
2
NOTICE:ASSEMBLY REQUIRES TWO PERSONS
6
STEP 2
1. Fold down console as shown in diagram and lock it with 2pcs M8 knob screws on both sides. Be careful not to
pinch wires inside posts.
2. Take out 5mm wrench and 2pcs M6*10 screw, to lock the Ipad holder. Put the safety key on the proper
position.
3. Connect power cord to the correct power supply and switch on power. Treadmill console should light up and
it’s ready for use.
Warning: This treadmill must be grounded properly. It is equipped with a cord
connecting to an equipment-grounding conductor and a grounding plug. The 3
pin plug must be plugged into an appropriate power outlet that complies with
industrial codes and local requirements in relate to grounding.
DANGER – Improper connection of the equipment-grounding conductor can
result in risk of electric shock. Check with a qualified electrician or serviceman
if you are in doubt as to whether the product is properly grounded. Do not
modify the plug provided with the product.
If it does not fit the power outlet, please have a proper outlet installed by a
qualified electrician. No adapter should be used with this product
STEP 3
To fold down treadmill, just unlock the 4pcs knob screws, and restore it into flat position as shown in below
diagram. Use 2pcs M10 knob screws to secure upright posts to main frame.
7
STEP 4
1. Lift up the treadmill: ① to lock the upright post with 2pcs of M10 knob screws on both sides. ②Switch the
supporting frame lock to horizontal position, the supporting frame should extend out automatically. This will
leave the treadmill in a steady stand-up position.
2. To lay it down, push back the supporting frame with foot, ①switch the lock to vertical position, then slowly lay
it down to floor. Repeat step 1& 2 to set it up again.
IV.WORKOUT GUIDELINES
It is better to do some stretch exercise before running; this would help reduce
chance of injury as well. Use 5-10 mins to warm-up. Follow above method and
diagram to do stretch exercise for five repeats, and each foot for 10 seconds or
more every repeat. After running, do those stretch exercises again.
When the treadmill is running, hold on hand pulse pads for about 5 seconds tightly, it
will then display your pulse reading. Continue to hold on for over 10 seconds for a
more stable pulse reading. However, heart rate reading is only good as exercise
reference and cannot be used as medical data.
For your health concern, do not over exercise at any time. Only increase exercise
intensity in a controlled manner.
8
V.TREADMILL OPERATION
COMPUTER
MANUAL
BLUETOOTH SPEAKER
APP G
APP GFIT
9
VI.MAINTENANCE
If power cord is damaged, it must be replaced by a qualified
electrician or a service technician from the distributor.
DO NOT TANGLE THE POWER CORD
REGULAR MAINTENANCE OF THE TREADMILL
STORAGE: Keep your treadmill indoor in stand-up position, away from dust
and moisture. Don’t store it in an open space where it might be exposed to
weather. Moisture, dust and water could cause rust to metal parts and damage
to electronics. This would void its product warranty.
POWER CORD: Exam power cord regularly. Make sure it’s intact. Pets bite
may damage cable and cause dangerous leakage. Have it replaced when
damaged.
SCREWS AND CONNECTING CABLES: Exam and tighten screws on a regular
basis, because screws and nuts may come loose due to vibration. Take care not
to damage cables in folding up and down the treadmill.
LUBRICATION: Always clean running deck and running belt before
lubrication.
a) Switch off power and detach power cord from power supply.
b) Lift running belt and insert the lubricant pot as deep as possible under the
belt. Apply lubricant oil onto middle of running deck. Do it from both sides
of treadmill, covering areas about 15cm from motor cover to about 30cm
from rear roller.
c) After lubrication, leave the treadmill running at 1km/h for at least 5
minutes to spread silicon oil evenly on running deck.
d) Please refer to below table as guide line on lubrication frequency.
Table des matières
Autres manuels Orbit tapis roulant
Manuels tapis roulant populaires d'autres marques
Smooth Fitness
Smooth Fitness EVO 3i Manuel utilisateur
NordicTrack
NordicTrack NETL81810.0 Manuel utilisateur
Schwinn
Schwinn 830/Journey 8.0 Manuel utilisateur
Keys Fitness
Keys Fitness HealthTrainer HT-740T Manuel utilisateur
Spirit
Spirit XT8 Manuel utilisateur
NordicTrack
NordicTrack T 14.0 Treadmill Manuel utilisateur