Nortel Passport 4430 Manuel utilisateur

210140-A Rev 00 May 2000

Passport 4430, 4450 and 4455

Installation Instructions for the Release 4.0, 16 MB Flash Memory

This instruction sheet will guide you through installing the Release 4.0, 16 MB

FlashMemorySIMMintheEthernetBaseModule(EBM),ofthePassport4430,

4450 and 4455. This SIMM includes the Release 4.0 boot code.

There are two SIMMs that can be used to upgrade the Passport:

• 16 MB Flash SIMM (NTJ778AA) - used in the Passport 4430/4450

• 16 MB Flash SIMM (NTJ779AA) - used in the Passport 4455

Note: Both SIMMs are identical inappearance; be sure to check the

PEC number (NTJxxxAA) that is printed on the label to

ensure you have the correct SIMM forthe EBM youare using.

If the incorrect SIMM is used, the system will not work.

1. Remove the power from the unit.

2. Remove the four (4) cover screws

(two (2) on each side of the unit).

3. Slide the cover toward the rearof

the unit and lift off.

4. Disconnect any external cables

that may be connected to the

unit, and remove any expansion

module rear panels and blank

panels (if no expansion modules

are present, proceed with step 6).

Caution:

!The Passport contains electrosensitive components which may

suffer damage due to static discharge. Either wear a grounded wrist

strap or ground yourself by touching the chassis.

Cover

Screw (4)

Release 4.0, 16 Mbyte Flash Memory Installation Instructions

2'5F

5. Remove the expansion modules by

following this procedure:

a. Take out the top plastic

retainer from the chassis by

lifting up and then pulling out.

(Units with the redundant

power supply will require

looseningof the front panel"L"

bracketsinordertoremovethe

top retainer.)

b. Carefully lift the expansion

module up and out (avoid

excessive bending). Repeat a.

and b. for each expansion

module.

6. Remove a SIMM by following this

procedure (from the front of the

unit):

a. Gently push out the connector

locking flanges located at each

side.(Refertothefigureinstep

5 for location of J9 on the

EBM.)

b. Move the SIMM to a vertical

position.

c. Lift up the SIMM.

7. Install the 16 MB Flash SIMM in

the J9 connector (refer to the

figure in step 5 for location on the

EBM) by following this procedure:

a. Insert the SIMM into the

connector.

b. Gently push down and then

back on the SIMM.

c. The SIMM will "click" into the

connector locking flanges.

8. Reassemble the unit by reversing

steps 1 through 5.

a. b.

"CLICK"

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Nortel Matériel réseau

Nortel

Nortel 9115 Manuel utilisateur

Nortel

Nortel BayStack 100-S Manuel utilisateur

Nortel

Nortel 6000 Series Manuel utilisateur

Nortel

Nortel BayStack 650 Manuel utilisateur

Nortel

Nortel 2340 Manuel utilisateur

Nortel

Nortel Meridian 1 Option 11C Manuel technique

Nortel

Nortel AccessNode 2016 Manuel utilisateur

Nortel

Nortel 2600 Manuel utilisateur

Nortel

Nortel R2MFC Manuel de l'opérateur

Nortel

Nortel BayStack 100-S Manuel de service

Nortel

Nortel Meridian Manuel du produit

Nortel

Nortel BayStack 450 Switch Manuel utilisateur

Nortel

Nortel 1800 Mode d’emploi

Nortel

Nortel BayStack 100-S Manuel utilisateur

Nortel

Nortel Optical Multiservice Edge 6130 Manuel technique

Nortel

Nortel BCN Dimensions

Nortel

Nortel Meridian SL-100 Manuel utilisateur

Nortel

Nortel BayStack 100-S Manuel utilisateur

Nortel

Nortel Meridian 1 Option 11C Compact Manuel d'utilisation et d'entretien

Nortel

Nortel BayStack 100-S Mode d’emploi

Nortel

Nortel 1010 Series Mode d’emploi

Nortel

Nortel NAC Manuel utilisateur

Nortel

Nortel 9110 Mode d’emploi

Nortel

Nortel Norstar Compact Plus Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur