Permit other device to join
ZL01F is featured to be a router in the network. It permits other devices, such as another
ZL01F, to join the network. In normal operation, by default the router device ZL01F does
not permit any device to join to the network to protect the network from unexpected or
unauthorized join attempt. You will need to open up the permit-join manually on ZL01F or
on other router device to allow new devices (a router or an end device) to join.
Operation:
Step 1. Short press the permit-join key once or perform permit-join from ZiG-BUTLER
software.
Step 2. You should see the indicator light blinks for 60 times. The permit join is now
enabled only for 60 seconds.
Step 3. ZL01F waits the new device to join automatically. Please note that the maximum
waiting time to join is 60 seconds. Repeat the process if you missed the 60 seconds
period.
Restore to factory setting
ZL01F is capable of storing and saving includes network routing information. If you wish to
remove ZL01F from the network and join to a new network, you would need to clear the
setting by simply reset the device to restore to the factory setting.
Operation:
Step 1. First remove the power then hold on to the permit-join key.
Step 2. While doing so, power up the device again to give power then release the key.
Step 3. If restore to factory setting is successful, you should see the indicator light
flashes quickly. Now the device has restored to the factory setting.
Now if you wish to join to a new network please power cycle the device again to put the
device into search network mode.
