6. Disabletime and Detectiontime
IRDisableTime is the sampling period while IRDetectionTime is detecting period.
Both IRDisableTime and IRDetectionTime are 30 seconds in default.
To save power, IR detection will be turned off for first 70% of IRDisableTime and turned on for rest 30% of IRDisableTime.
If living creature is detected during the rest 30% of IRDisableTime, the IR delay time will be extended for another IRDetectionTime till no infrared signal is detected.
If no living creature is detected during IRDetectionTime, RB11E will report un-occupy along with other sensor status, such as temperature,illumination, etc.
Example1:
While IRDetectionTime is 60 secs and IRDisableTime is 30 secs, no living creature is detected after triggered.
RB11E will report un-occupy after 60 secs(IRDetectTime).
Example2:
While IRDetectionTime is 60 secs and IRDisableTime is 30 secs, living creature is detected during 25th sec.
RB11E will restart IR detect procedure(IRDetectionTime).
No living creature is detected during next IRDetectionTime and RB11E therefore report un-occupy.
Remarks:
Occupancy status (status =1) requires both door magnet and infrared to detect someone
7. Installation
This product comes with waterproof function. When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall
with screws.
Note: To install the battery, use a screwdriver or similar tool to assist in opening the battery cover.
8.Important Maintenance Instruction
Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty
service effectively.
• Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits. In case the device
is wet, please dry it completely.
• Do not use or store in dusty or dirty areas. This can damage its detachable parts and electronic components.
• Do not store in excessive heat. High temperatures can shorten the life of electronic devices, destroy batteries, and deform or melt some plastic parts.
• Do not store in a cold place. Otherwise, when the temperature rises to normal temperature, moisture will form inside, which will destroy the board.
• Do not throw, knock or shake the device. Rough handling of equipment can destroy internal circuit boards and delicate structures.
• Do not wash with strong chemicals, detergents or strong detergents.
• Do not apply with paint. Smudges can block debris in detachable parts and affect normal operation.
• Do not throw the battery into a fire to prevent the battery from exploding. Damaged batteries may also explode.
All of the above suggestions apply equally to your device, battery and accessories. If any device is not working properly.
Please take it to the nearest authorized service facility for repair.
IRDetectionTime = 60 secs
IRDetectionTime = 60 secs
