3
Programming
0 - Resetting to Factory Defaults
To reset to factory defau ts, power off then press and ho d the * key whi e powering up. S2 wi beep twice and the
LED wi g ow orange. Re ease the * key and the S2 wi be ready for one of the fo owing options:
1) Presenting the “Add User Master Card” to S2’s Reader to add a new user
2) Presenting the “De ete User Master Card” to de ete a current user
3) Presenting a b ank EM card to rep ace an “Add User Master Card” or “De ete User Master Card”. In this
case the first b ank card presented wi become the new “Add User Master Card” and the second b ank
card presented wi become the new “De ete User Master Card”. The LED wi f ash Red confirming that S2
has been reset to factory defau ts and new Master Cards added. If the new Master Cards are not presented
within 10 seconds S2 wi resume User Operating Mode and the LED wi g ow steady Red
When resetting to factory defau ts the user's information is sti retained
Entering Programming Mo e
(Defau t Master Code = 888888
Press * then enter the Master Co e fo owed by # (e.g. * 888888 #)
S2 wi enter Program Mode, the LED wi f ash Green for one second and then g ow steady Red whi e S2 awaits
Program Option Commands. To Exit Program Mode press *. If no keys are pressed for 60 seconds S2 wi
automatica y exit Program Mode and resume Operation Mode
The following options can be accesse an programme in Program Mo e
(Master Code must be 6 digits ong)
(Can on y be done in Master Programming Mode)
Press 0 - The LED wi g ow Orange. Enter a New Co e fo owed by # then re-enter the same New Co e fo owed
by # . The LED wi f ash Green if successfu
Up to 2500 user cards can be added. The first two options are avai ab e in Program Mode on y and the third is a so
avai ab e in Operation Mode
3.1 A ing Car Users Automatically in Program Mo e (Not recommen e )
Press 1 - The LED wi g ow Orange. Present a blank car to the Reader. S2 wi automatica y assign the first card
as User Card 1. When successfu the LED wi f ash Green. Repeat this process for a new cards and then press #
This method is not recommended because S2 wi automatica y a ocate added cards to the next avai ab e
empty card s ot. This makes it difficu t to de ete a card as its a ocated card s ot (ID number) wi not be known
(Can on y be done in Master Programming Mode)
